Removal of thorium(IV) ions from aqueous solution by polyacrylamide-based monoliths: equilibrium, kinetic and thermodynamic studies

Ultra-effective modified clinoptilolite adsorbent for selective thorium removal from radioactive residue

This study investigated the efficacy of using phosphate-modified zeolite (PZ) as an adsorbent for removing thorium from aqueous solutions. The effects of various factors such as contact time, adsorbent mass, initial thorium concentration, and pH value of the solution on the removal efficiency were analyzed using the batch technique to obtain optimum adsorption condition. The results revealed that the optimal conditions for thorium adsorption were a contact time of 24 h, 0.03 g of PZ adsorbent, pH 3, and a temperature of 25 °C. Isotherm and kinetics parameters of the thorium adsorption on PZ were also determined, with equilibrium studies showing that the experimental data followed the Langmuir isotherm model. The maximum adsorption capacity (Q_o) for thorium was found to be 17.3 mg/g with the Langmuir isotherm coefficient of 0.09 L/mg. Using phosphate anions to modify natural zeolite increased its adsorption capacity. Furthermore, adsorption kinetics studies demonstrated that the adsorption of thorium onto PZ adsorbent fitted well with the pseudo-second-order model. The applicability of the PZ adsorbent in removing thorium from real radioactive waste was also investigated, and nearly complete thorium removal was achieved (> 99%) from the leached solution obtained from cracking and leaching processes of rare earth industrial residue under optimized conditions. This study elucidates the potential of PZ adsorbent for efficient removal of thorium from rare earth residue via adsorption, leading to a reduction in waste volume for ultimate disposition.

Humic acid attachment on chitosan-modified silica gel as an economical, efficient, and selective adsorbent for thorium and uranium removal

A novel, low-cost adsorbent material was prepared by the immobilization of humic acid on a silica gel surface coated with cross-linked chitosan (SiChiHA). The adsorbent was developed to remove selectively of Th(IV) and U(VI) from aqueous solution, including their pre-concentration and separation from lanthanides and high salinity conditions. A simple waste-less humic acid immobilization method was shown to be successful based on FT-IR, SEM-EDS, and zeta potential characterization results. The adsorbent was found to be stable over a wide pH range, with the highest capacities obtained at pH 3.5 (Th(IV)) and pH 5 (U(VI)). Langmuir model calculations yielded a maximum capacity of 30.6 mg g^-1 and 75.4 mg g^-1 for Th(IV) and U(VI). The adsorption process was found to be rapid (half concentration was removed within 10 min) and best described by a pseudo-second order rate equation. Increasing NaCl concentration up to 2 mol L^-1 or lanthanide concentration up to 100 times did not significantly affect the removal efficiency for either Th(IV) of U(VI). Both elements could be sequentially separated by elution with ammonium citrate and nitric acid, respectively. The adsorption-desorption experiment showed that the adsorbent could be used for at least five cycles without significant capacity loss. This study provides insight into the development of low-cost adsorbent with practical functionality, including separation and regeneration ability, the advantageous properties scarcely reported in low-cost adsorbent literature.