A sensitive spectrophotometric determination of atrazine in micellar medium and its application in environmental samples

Atrazine adsorption and desorption on functionalized montmorillonite: aluminum-pillared and lithium saturated

Atrazine is an herbicide used worldwide, and it is considered a severe environmental contaminant. The present study aims to evaluate the atrazine adsorption in aqueous media in montmorillonite samples which were either in natural state or functionalized through saturation with lithium and pillarization with aluminum by different methods. Montmorillonite saturated with lithium adsorbed significantly more atrazine than the natural montmorillonite sample. Among the samples obtained through the three aluminum-pillarization methods, the mass percentage of adsorbed atrazine was very similar. However, the best combination was the aluminum-pillarization (due to the maintenance of the open interlayer region) and saturation with lithium (due to the significant reduction of the cation exchange capacity of the mineral), because both processes facilitate the interaction of atrazine with the montmorillonite. Another advantage was that the adsorption of atrazine in the pillared and lithium saturated samples had small desorption, which is desirable in the environmental perspective. It is recommended to build filters with aluminum-hydroxy pillared, lithium saturated montmorillonite as an alternative method to rapidly remove atrazine from aqueous media. In addition to the shorter production time, this process resulted in montmorillonite with high occupancy rate and stability of the aluminum-hydroxy pillars.

Evaluation of flow injection analysis method with spectrophotometric detection for the determination of atrazine in soil extracts

A method for determining atrazine in soil extracts was evaluated by flow injection analysis with spectrophotometric detection. The method is based on the reaction of atrazine with pyridine in an acid medium followed by the reaction with NaOH and sulfanilic acid. Several analytical conditions were previously studied and optimized. Under the best conditions of analysis, the limits of detection and quantification were 0.15 and 0.45 mg L(-1), respectively, for a linear response between 0.50 and 2.50 mg L(-1), and a sampling throughput of 21 determinations per hour. Using the standard addition method, the maximum relative standard deviation of 17% and recovery values between 80 and 100% were observed for three extracts from soil samples with different composition. The proposed method is simple, low-cost and easy to use, and can be employed for studies involving atrazine in soil samples or for screening of atrazine in soils.