Ceria-zirconia supported Au as highly active low temperature Water-gas shift catalysts

Low Temperature Water-Gas Shift: Enhancing Stability through Optimizing Rb Loading on Pt/ZrO2

Recent studies have shown that appropriate levels of alkali promotion can significantly improve the rate of low-temperature water gas shift (LT-WGS) on a range of catalysts. At sufficient loadings, the alkali metal can weaken the formate C–H bond and promote formate dehydrogenation, which is the proposed rate determining step in the formate associative mechanism. In a continuation of these studies, the effect of Rb promotion on Pt/ZrO2 is examined herein. Pt/ZrO2 catalysts were prepared with several different Rb loadings and characterized using temperature programmed reduction mass spectrometry (TPR-MS), temperature programmed desorption (TPD), diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS), an X-ray absorption near edge spectroscopy (XANES) difference procedure, extended X-ray absorption fine structure spectroscopy (EXAFS) fitting, TPR-EXAFS/XANES, and reactor testing. At loadings of 2.79% Rb or higher, a significant shift was seen in the formate ν(CH) band. The results showed that a Rb loading of 4.65%, significantly improves the rate of formate decomposition in the presence of steam via weakening the formate C–H bond. However, excessive rubidium loading led to the increase in stability of a second intermediate, carbonate and inhibited hydrogen transfer reactions on Pt through surface blocking and accelerated agglomeration during catalyst activation. Optimal catalytic performance was achieved with loadings in the range of 0.55–0.93% Rb, where the catalyst maintained high activity and exhibited higher stability in comparison with the unpromoted catalyst.

TiO2-supported Au-Ag plasmonic nanocatalysts achieved by plasma restructuring and activation

Plasmonic Au-Ag/TiO₂ bimetallic nanocatalyst is regarded as a promising visible-light (VL) photocatalyst due to its wide light absorption and potentially enhanced activity. For its preparation, Au precursors usually contain Cl and co-impregnation/co-deposition suffers from AgCl precipitation, and consequently Au and Ag have to be sequentially supported. However, Au and Ag species of the sequential preparation are individually isolated and difficult to be homogeneously mixed. Here we report an Au-Ag plasmonic nanocatalyst achieved by plasma restructuring and activation from the sequential preparation. The isolated cationic Au and Ag species on the sequentially-prepared Au-Ag/TiO₂ sample are restructured to be homogeneously mixed and highly activated by O₂ plasma, which can be partially auto-reduced to Au-Ag bimetallic nanoparticles within the induction period of a few minutes in VL photocatalytic oxidation of CO. The Au-Ag plasmonic nanocatalyst exhibits a strongly enhanced activity in the VL photocatalytic reaction. The contribution of O₂ plasma treatment and the enhancement mechanism for the Au-Ag plasmonic nanocatalyst are disclosed.

Application of Potassium Ion Deposition in Determining the Impact of Support Reducibility on Catalytic Activity of Au/Ceria-Zirconia Catalysts in CO Oxidation, NO Oxidation, and C3H8 Combustion

The purpose of the study was to show how a controlled, subtle change of the reducibility of the support by deposition of potassium ions impacts the activity of gold catalysts. Since the activity of supported gold catalysts in carbon monoxide oxidation is known to strongly depend on the reducibility of the support, this reaction was chosen as the model reaction. The results of tests conducted in a simple system in which the only reagents were CO and O2 showed good agreement with the CO activity trend in tests performed in a complex stream of reagents, which also contained CH4, C2H6, C3H8, NO, and water vapor. The results of the X-ray Diffraction (XRD) studies revealed that the support has the composition Ce0.85Zr0.15O2, that its lattice constant is the same for all samples, and that gold is mostly present in the metallic phase. The reducibility of the systems was established based on Temperature Programmed Reduction (TPR) and in situ XRD measurements in H2 atmosphere. The results show that the low temperature reduction peak, which is due to the presence of gold, is shifted to a higher value by the presence of 0.3 at% potassium ions on the surface. Moreover, the increase of the potassium loading leads to a more pronounced shift. The T50 of CO oxidation in the simple model stream was found to exhibit an excellent linear correlation with the maximum temperature of the low temperature reduction peak of Au catalysts. This means that stabilizing oxygen with a known amount of potassium ions can be numerically used to estimate the T50 in CO oxidation. The results in the complex stream also showed a similar dependence of CO conversion on reducibility, though there was no substantial difference in the activity of the catalysts in other reactions regardless of the potassium loading. These studies have shown that the influence of potassium varies depending on the reaction, which highlights differences in the impact of reducibility and importance of other factors in these reactions.

Synergy and Anti-Synergy between Palladium and Gold in Nanoparticles Dispersed on a Reducible Support

Highly active and stable bimetallic Au-Pd catalysts have been extensively studied for several liquid-phase oxidation reactions in recent years, but there are far fewer reports on the use of these catalysts for low-temperature gas-phase reactions. Here we initially established the presence of a synergistic effect in a range of bimetallic Au-Pd/CeZrO₄ catalysts, by measuring their activity for selective oxidation of benzyl alcohol. The catalysts were then evaluated for low-temperature WGS, CO oxidation, and formic acid decomposition, all of which are believed to be mechanistically related. A strong anti-synergy between Au and Pd was observed for these reactions, whereby the introduction of Pd to a monometallic Au catalyst resulted in a significant decrease in catalytic activity. Furthermore, monometallic Pd was more active than Pd-rich bimetallic catalysts. The nature of the anti-synergy was probed by several ex situ techniques, which all indicated a growth in metal nanoparticle size with Pd addition. However, the most definitive information was provided by in situ CO-DRIFTS, in which CO adsorption associated with interfacial sites was found to vary with the molar ratio of the metals and could be correlated with the catalytic activity of each reaction. As a similar correlation was observed between activity and the presence of Au⁰* (as detected by XPS), it is proposed that peripheral Au⁰* species form part of the active centers in the most active catalysts for the three gas-phase reactions. In contrast, the active sites for the selective oxidation of benzyl alcohol are generally thought to be electronically modified gold atoms at the surface of the nanoparticles.

Kinetic analysis of low concentration CO detection by Au-loaded cerium oxide sensors

Gold nanoparticle-loaded cerium oxide sensors detect 10–30 ppm of carbon monoxide in air with very fast response. The response and recovery transients of conductance have been modelled using two-site Langmuir adsorption kinetics.

Visualisation of single atom dynamics in water gas shift reaction for hydrogen generation

In situ real time single atom resolution observations of dynamic water gas shift catalysts in CO + water (WGS) environments.

Water-gas shift on gold catalysts: catalyst systems and fundamental studies

Since the pioneering finding by Haruta et al. that small gold nanoparticles on reducible supports can be highly active for low-temperature CO oxidation, the synthesis, characterization, and application of supported gold catalysts have attracted much attention. The water-gas shift reaction (WGSR: CO + H2O = CO2 + H2) is important for removing CO and upgrading the purity of H2 for fuel cell applications, ammonia synthesis, and selective hydrogenation processes. In recent years, much attention has been paid to exploration the possibility of using supported gold nanocatalysts for WGSR and understanding the fundamental aspects related to catalyst deactivation mechanisms, nature of active sites, and reaction mechanisms. Here we summarize recent advances in the development of supported gold catalysts for this reaction and fundamental insights that can be gained, and furnish our assessment on the status of research progress.

Highly dispersed gold on zirconia: characterization and activity in low-temperature water gas shift tests

Gold-loaded zirconia and sulfated zirconia catalysts were tested in the low-temperature water gas shift reaction. The samples were characterized by N2 adsorption analysis, temperature-programmed reduction, X-ray diffraction, pulse-flow CO chemisorption, FTIR spectroscopy, and high-resolution transmission electron microscopy. A reference catalyst, Au/TiO2, provided by the World Gold Council was investigated for comparison. CO chemisorption and FTIR data indicate the presence of only highly dispersed gold clusters on the sulfated sample and both small clusters and small particles on the non-sulfated sample. Both gold-zirconia catalysts are much more active than the Au/TiO2 reference sample over all the temperature range investigated. The sample prepared on sulfated zirconia exhibits higher stability than the catalyst on unmodified zirconia. The prominent role in the water gas shift reaction of gold clusters in close contact with the support was deduced.