Non-Colloidal Nanocatalysts Fabricated Using Arc Plasma Deposition and Their Application in Heterogenous Catalysis and Photocatalysis

Facilely Fabricated Zero-Bias Silicon-Based Plasmonic Photodetector in the Near-Infrared Region with a Schottky Barrier Properly Controlled by Nanoalloys

Plasmonic Schottky devices have attracted considerable attention for use in practical applications based on photoelectric conversion, because they enable light to be harvested below the bandgap of semiconductors. In particular, silicon-based (Si) plasmonic Schottky devices have great potential for useful photodetection in the near-infrared region. However, the internal quantum efficiency (IQE) values of previously reported devices are low because the Schottky barrier is excessively high. Here, we are the first to develop AuAg nanoalloy-n-type Si plasmonic Schottky devices by cathodic arc plasma deposition. Interestingly, it is found that a novel nanostructure, which leads to the improvement of responsivities, is formed. Moreover, these plasmonic nanostructures can be fabricated in only ∼1 min. The fabricated AuAg nanoparticle-film structure enables proper control of the Schottky barrier height and increases the area of the Schottky interface for electron transfer. As a result, the considerably enhanced IQE of our device at a telecommunication wavelength of 1310 nm (1550 nm) without external bias is 4.6 (6.5) times higher than those in previous reports, and these responsivities are a record high. This approach can be applied to realize efficient photodetection in the NIR region and extend the use of light below the bandgap of semiconductors. This paves the way for future application advancements in a variety of fields, including photodetection, imaging, photovoltaics, and photochemistry.

Size-dependent interaction of plasma with anatase TiO2 nanoparticles

We study the particle size distribution and phase changes of the anatase TiO2 nanopowder samples when they are subject to the plasma treatments of three different kinds of gases as nitrogen (N2), oxygen (O2), and argon (Ar). The plasma gas pressures vary as 0.1, 0.3, and 0.6 Torr. We demonstrate that the plasma treatments have an effect neither on the phase structure nor on the mean nanocrystalline size. The phase and size invariances of the samples are attributed to their nanoscale thermodynamic aspects. We find out that elevating the gas pressure in some cases creates fine-size amorphous nanoparticles with a narrow distribution. Our findings authenticate that plasma treatment affects the amorphous phase with etching particles down to a mean value of ∼3 nm. The small-angle X-ray scattering (SAXS) technique was utilized to obtain the size distribution of the nanoparticles, and the wide-angle X-ray scattering (WAXS) technique was used to probe the phase and size changes of the crystalline structure.

A useful preparation of ultrasmall iron oxide particles by using arc plasma deposition

Ultrasmall particles, different from the larger size nanoparticles, have recently attracted significant attention in the scientific community in nanotechnology for catalytic, electronic and optical applications; however, their magnetic properties remain unexplored due to the difficult structural analysis. A challenging issue is to develop a preparation method for iron oxide particles (IOPs) with fine size control, and to determine the dependence of magnetic properties on the morphology and crystallinity of the magnetic particles. However, synthetic approaches to obtain IOPs, regarded as one of the new fields of magnetic nanoparticles, have been significantly limited. This article reported a developed synthetic method to prepare IOPs on carbon supports using pulsed arc plasma deposition (APD) in flowing oxygen gas, which clarified the finely-controlled formation of IOPs on graphene nanosheets. Structural characterization of the IOPs revealed the formation of crystalline γ-Fe₂O₃ ultrasmall particles with oxygen deficiency. The pulsed APD method for IOPs is the first simple and convenient technique to not only prevent significant aggregation and contamination by organic compounds and avoid the need for thermal pretreatment, but also provide uniform crystalline nano-order particles.

Finely size-controlled ultrasmall iron oxide particles (IOPs) on graphene nanosheets were usefully prepared by using pulsed arc plasma deposition. The IOPs are composed of a high crystallinity single γ-Fe₂O₃ component without annealing.

The effect of the oxidation states of supported oxides on catalytic activity: CO oxidation studies on Pt/cobalt oxide

The strong metal–oxide interaction of platinum nanoparticles (PtNPs) deposited on two types of cobalt oxides, CoO and Co₃O₄, was investigated using CO oxidation.