Kinetics of imidazolium-based ionic liquids degradation in aqueous solution by Fenton oxidation

Fenton and photo-assisted advanced oxidative degradation of ionic liquids: a review

Ionic liquids (ILs) are the class of materials which are purely ionic in nature and liquid at room temperature. Their remarkable properties like very low vapour pressure, non-inflammable and high heat resistance are responsible for their use as a very appealing solvent in a variety of industrial applications in place of regular organic solvents. Because ILs are water soluble to a certain extent, the industrial wastewater effluents are found to contaminate with their traces. The non-biodegradability of ILs attracts the attention of the researchers for their removal or degradation from wastewater. Numbers of methods are available for the treatment of wastewater. However, it is very crucial to use the most efficient method for the degradation of ILs. Advanced oxidation process (AOP) is one of the most important techniques for the treatment of ILs in wastewater which have been investigated during last decades. This review paper covers the cost-effective Fenton, photochemical and photocatalytic AOPs and their combination that could be applied for the degradation of ILs from the wastewater. Theoretical explanations of these AOPs along with experimental conditions and kinetics of degradation or removal of ILs from water and wastewater have been reported and compared. Finally, future perspectives of IL degradation are presented.

Direct growth of nano-worm-like Cu2S on copper mesh as a hierarchical 3D catalyst for Fenton-like degradation of an imidazolium room-temperature ionic liquid in water

The increasing consumption of room-temperature ionic liquids (RTILs) inevitably releases RTILs into the water environment, posing serious threats to aquatic ecology due to the toxicities of RTILs. Thus, urgent needs are necessitated for developing useful processes for removing RTILs from water, and 1-butyl-3-methylimidazolium chloride (C4mimCl), the most common RTIL, would be the most representative RTIL for studying the removal of RTILs from water. As advanced oxidation processes with hydrogen peroxide (HP) are validated as useful approaches for eliminating emerging contaminants, developing advantageous heterogeneous catalysts for activating HP is the key to the successful degradation of C4mim. Herein, a hierarchical structure is fabricated by growing Cu₂S on copper mesh (CSCM) utilizing CM as a Cu source. Compared to its precursor, CuO@CM, this CSCM exhibited tremendously higher catalytic activity for catalyzing HP to degrade C4mim efficiently because CSCM exhibits much more superior electrochemical properties and reactive sites, allowing CSCM to degrade C4mim rapidly. CSCM also exhibits a smaller E_a of C4mim elimination than all values in the literature. CSCM also shows a high capacity and stability for activating HP to degrade C4mim in the presence of NaCl and seawater. Besides, the mechanistic investigation of C4mim elimination by CSCM-activated HP has also been clarified and ascribed to OH and ¹O₂. The elimination route could also be examined and disclosed in detail through the quantum computational chemistry, confirming that CSCM is a useful catalyst for catalyzing HP to degrade RTILs.

Experimental investigation of density, viscosity, and surface tension of aqueous tetrabutylammonium-based ionic liquids

The physical properties such as density, dynamic viscosity, and surface tension of aqueous tetrabutylammonium-based ionic liquids were measured experimentally by varying temperature (283.4 to 333.4 K) and concentration of ILs (10-50 wt%) at an interval of 10 K and 10 wt% respectively. In this study, the aqueous tetrabutylammonium-based ionic liquids namely tetrabutylammonium acetate [TBA][OAC], tetrabutylammonium bromide [TBA][Br], and tetrabutylammonium hydroxide [TBA][OH] was used to investigate the influence of temperature and concentration of ILs on the physical properties data was examined. It is observed that both density and surface tension increase with increasing concentration of [TBA][Br], whereas the opposite trend is observed for [TBA][OAC] and [TBA][OH] respectively. This is due to stronger molecular interaction between [TBA][Br] and water compared to other ILs. The dynamic viscosity of all aqueous ILs increases with increasing IL concentration. The measured physical properties of ILs decrease as temperature increases. Furthermore, the experimental data is correlated and compared with that of the calculated model; the agreement was satisfactory. Graphical abstract.