Intensified wheat husk conversion employing energy-efficient hybrid electromagnetic radiations for production of fermentable sugar: process optimization and life cycle assessment

Environmentally sustainable ethyl levulinate synthesis from delignified sugarcane bagasse using ternary eutectic solvent under MW-xenon irradiation: engine performance and emission assessment

For the first time, a synergistic energy-efficient combination of microwave-xenon (MW-XE) irradiations in presence of photoactive ternary acidic deep eutectic solvents (TADES) has been applied for intensification of ethyl levulinate synthesis from delignified sugarcane bagasse (DSB) under mild (90 min, 90 °C) and environmentally benign process conditions. The Taguchi orthogonal designed optimized conditions (20 W/cm3 of MW specific irradiation power input, 1 mol/mol of FeCl3 to citric acid ratio, 90 min of reaction time, 150 W of XE specific power input) rendered maximum 61.3 mol% of EL yield (selectivity: 87.70 [Formula: see text] 0.5%). Remarkably, synergistic effect of MW and XE irradiation significantly enhanced the EL yield (61.3 mol%) compared to the individual MW (34.52 mol%) and XE (22.67 mol%) irradiation at otherwise optimized reaction conditions. Moreover, the MWXE irradiated reactor (MWXER) exhibited a significant 79.10% increase in EL yield compared to the conventional thermal reactor (CTR), at the expense of 10% less energy consumption. The ethyl levulinate could be recovered efficiently through green protocol from reaction mix resulting in high purity (97 [Formula: see text] 0.5%) and TADES was sustainably reused in the process. The optimally generated product EL when blended (5 and 10 vol.%) with B10 and B20 (10% and 20% biodiesel-diesel blend) could provide 21-31% reduction in HC and 7.3-36% reduction in CO in comparison with petro-diesel. It was also explored that, at similar optimal parametric combinations, the TADES produced 29.5% greater EL yield in comparison with the standard ionic liquid BMIMCl. The life cycle environmental impact analysis (LCEIA) of the overall process revealed that the 5 vol.% EL blending with B10 contributed lowest environmental impacts mitigating marine ecotoxicity, human toxicity, fossil depletion, and climate change by 77.9%, 77.4%, 78.4% and 77.5%, respectively.

Life cycle assessment of waste printed wiring board-derived Ag photocatalyst for sustainable fermentable sugar production

An exploratory work involving waste printed wiring board (WPWB)-derived inexpensive silver oxide (Ag₂O)-grafted silica-alumina composite photocatalyst (SAA) using quartz halogen and UVA irradiations (QHUV) (wavelength: 315 nm-1000 nm) has been revealed. The efficacy of the novel SAA photocatalyst was assessed in the synthesis of fermentable sugar (FS) by photo-hydrolysis of pure crystalline cellulose (PCC) in the QHUV-assisted batch reactor (QHUVBR), and the process parameters (5% AgNO₃ doping, 7.5% catalyst concentration, 20 min PH time, and 80 °C PH temperature) were optimized using Taguchi orthogonal array design. The BET analysis of the optimal SAA catalyst possessed high surface area (27.24 m²/g), high pore volume, and pore diameter (0.042 cc/g and 13.1684 nm), respectively, whereas the XRD indicated the presence of significant crystalline phases of Ag₂O. EDS mapping displayed the uniform distribution of silver active sites on silica-alumina support of the optimal SAA photocatalyst. The optimized parametric conditions in QHUVBR resulted in a maximum FS yield of 77.53% which was significantly higher compared to that achieved (34.52%) in a conventionally heated batch reactor (CHBR). Besides, the energy consumption was 75% more in CHBR (600 W) in comparison with QHUVBR (150 W), making the process energy-efficient and cost-effective. The environmental sustainability could be ascertained from the life cycle assessment (LCA) study in terms of low climate change, ionizing radiation, metal depletion, human toxicity, and other potential indicator values.