Bioethanol production from defatted biomass of Nannochloropsis oculata microalgae grown under mixotrophic conditions

Bioenergy feedstock production in Chlamydomonas reinhardtii (microalgae) cultivated under mixotrophic growth with cellulose hydrolysate from agricultural waste

In the present study, cellulose purified from finger millet agricultural waste is subjected to enzymatic hydrolysis, and the hydrolysate (predominantly glucose) is used as a carbon source supplement in the media for the mixotrophic growth of Chlamydomonas reinhardtii. Interestingly, a switch between excess starch production and excess lipid (triacylglycerols, TAG) production occurs by a small change in hydrolysate concentration in the media. Starch production increased 4.5-fold with respect to the photoautotrophic control, with a glucose concentration of 3 mg/mL in the media after hydrolysate addition. This culture had TAG production enhancement by 1.5-fold. However, mixotrophic cultivation with 4 mg/mL glucose concentration in the media with hydrolysate addition resulted in TAG productivity enhancement by 4.2-fold compared to control and starch amount increase of 1.3-fold. The organic carbon source (glucose) and the inorganic carbon source (citrate ions) in the hydrolysate together played a role in this delicate switching between starch and lipid pathways. Proteins, starch, and TAG molecules are analyzed in the microalgal cells grown under different conditions with FTIR spectroscopy, a rapid, high-throughput method of biomolecular estimation. High-resolution single-cell AFM studies of the cell wall structure reveal enhanced corrugations in surface morphology during mixotrophic growth with cellulose hydrolysate, illustrating an adaptive mechanism with improved mechanical stress management. Lipid droplet morphology at the single-cell level points to two distinct mechanisms of lipid accumulation: one in which the lipids are segregated as droplets, and the other in which lipid molecules are uniformly dispersed in the cytosol as unresolved, ultra-small droplets. The present study therefore analyzes both the bulk and the single-cell level changes when cellulose hydrolysate is used as a carbon source for Chlamydomonas reinhardtii mixotrophic cultivation, which serves a four-fold purpose: value from waste, fixation of atmospheric CO2, production of lipids for biodiesel, and starch for bioethanol.

The growth and lipid accumulation of Scenedesmus quadricauda under nitrogen starvation stress during xylose mixotrophic/heterotrophic cultivation

In order to conquer the block of high cost and low yields which limit to realize the commercialization of microalgal biodiesel, the mixotrophic and heterotrophic cultivation of Scenedesmus quadricauda FACHB-1297 fed on xylose was separately studied employing six forms of media: phosphorus sufficient, phosphorus restricted, and phosphorus starvation were combined with nitrogen sufficient and nitrogen starvation conditions. The maximum lipid content (about 41% of dry weight) was obtained on the 5th day (heterotrophic cultivation) and 8th day (mixotrophic cultivation) under the nitrogen starved and phosphorus sufficient (N0&P) conditions, which was about twofold in comparison to the final lipid content on the sufficient nitrogen condition (control). Under mixotrophic and heterotrophic modes, the highest lipid production was achieved in the N0&P trial, with the value of 274.96 mg/L and 193.77 mg/L, respectively. Xylose utilization rate of 30-96% under heterotrophic modes was apparently higher than that of 20-50% in mixotrophic modes. In contrast, phosphorus uptake rate of 100% under mixotrophic cultivation was significantly more than that of 60-90% in heterotrophic cultivation. Furthermore, under the condition of heterotrophic cultivation using xylose as a carbon source, the phosphorus had a positive impact on microalgae cell synthesis and the lipid content enhanced with the augmentation in phosphorus concentrations. We suggested that sufficient phosphorus should be supplied for obtaining higher microalgal lipid production in the lack of nitrogen under xylose heterotrophic/mixotrophic condition. This was a highly effective way to obtain efficient microalgae lipid production.

Removal of fenamiphos, imidacloprid, and oxamyl pesticides from water by microalgal Nannochloropsis oculata biomass and their determination by validated HPLC method

The present study assessed the removal of fenamiphos, imidacloprid, and oxamyl pesticides from water using algal Nannochloropsis oculata biomass. Several factors, such as algal biomass concentration, incubation time, and pesticide concentration, were studied for their impact on pesticide removal. Analysis and quantification of pesticides by rapid HPLC have been developed and validated. The optimum conditions were obtained at 15 min, 50 mg/L of pesticide concentration, and 4,500 mg/L of the algal biomass with 92.24% and 90.43% removal for fenamiphos and imidacloprid, respectively. While optimum parameters of 10 min incubation, 250 mg/L of pesticide concentration, and 2,750 mg/L of the algal biomass exhibited 67.34% removal for oxamyl. N. oculata, marine microalgae, successively removed different concentrations of the tested pesticides from water, and the algal biomass showed a potential reduction of pesticides in polluted water samples.

Accurate assessment of the effect of Rhodamine 6G solution as a spectral converter on biomass production of microalgae Chlorella sp., nitrate uptake, and energy consumption by the light source

Spectral conversion of light introduced as a new technique to manage incoming light photons into the culture medium of photosynthetic microorganisms which can increase biomass production. In this work, a much more accurate value of the effect of spectral conversion on the growth of Chlorella sp. was obtained. For this purpose, the light source and Rhodamine 6G solution, as a spectral converter, was placed in the center of the culture flask, which was covered with aluminum foil. The loss of photons was largely avoided due to the additional homogeneous distribution of light. Modification of white light using the solution has increased biomass productivity up to 300%. Also, for biomass productivity of 1 mg L^-1 day^-1, the energy consumption of the white light source was reduced up to 75%. Nitrate uptake has also increased up to 28%, and intracellular lipid content has decreased, as well.

Production and use of Scenedesmus acuminatus biomass in synthetic municipal wastewater for integrated biorefineries

Bioethanol production from algal biomass is a promising alternative for sustainable biofuel production. Algae possess a high photosynthetic capacity and an adaptive ability to thrive under harsh environmental conditions. The potential properties of Scenedesmus acuminatus CCALA 436 were assessed in this research for its bioethanol efficiency, and the effects of growing the algae in wastewater and at different concentrations of mepiquat chloride were studied. Also, pre-treatment efficiencies of different concentrations of calcium oxide were carried out on microalgae biomass. Superoxide dismutase, catalase activity, glutathione, and malondialdehyde contents of microalgae were examined, and the changes in chlorophyll, photoprotective carotenoid contents, and protein concentrations were determined. The results revealed that the maximum sugar and ethanol contents of Scenedesmus acuminatus CCALA 436 were 44.7 ± 1.5% and 20.32 g/L, respectively, for 50% wastewater and mepiquat chloride (2.5 mg/L) after pre-treatment with calcium oxide (0.08%). Additionally, the levels of oxidative enzymes varied depending on the wastewater concentrations. These findings indicate Scenedesmus acuminatus CCALA 436 grown in wastewater and mepiquat chloride can be used for the treatment of wastewater and the production of ethanol and high-value products such as carotenoid.

A semi-continuous algal-bacterial wastewater treatment process coupled with bioethanol production

Harnessing the biomass energy potential through biofuel production offers new outlets for a circular economy. In this study an integrated system which combine brewery wastewater treatment using algal-bacterial aggregates instead of activated sludge was developed. The use of algal-bacterial aggregates can eliminate the aeration requirements and significantly reduce the high biomass harvesting costs associated with algal monocultures. A sequencing batch reactor (SBR) setup operating with and without biomass recirculation was used to investigate pollutant removal rates, aggregation capacity and microbial community characteristics under a range of hydraulic retention times (HRTs) and solid retention times (SRTs). It was observed that biomass recirculation strategy significantly enhanced aggregation and pollutant removal (i.e., 78.7%, 94.2% and 75.2% for d-COD, TKN, and PO₄^3--P, respectively). The microbial community established was highly diverse consisting of 161 Bacterial Operational Taxonomic Units (B-OTUs) and 16 unicellular Eukaryotic OTUs (E-OTUs). Escalation the optimal conditions (i.e., HRT = 4 d, SRT = 10 d) at pilot-scale resulted in nutrient starvation leading to 38-44% w/w carbohydrate accumulation. The harvested biomass was converted to bioethanol after acid hydrolysis followed by fermentation with Saccharomyces cerevisiae achieving a bioethanol production yield of 0.076 g bioethanol/g biomass. These data suggest that bioethanol production coupled with high-performance wastewater treatment using algal-bacterial aggregates is feasible, albeit less productive concerning bioethanol yields than systems exclusively designed for third and fourth-generation biofuel production.

A review on the sustainable procurement of microalgal biomass from wastewaters for the production of biofuels

The feasibility of microalgal biomass as one of the most promising and renewable sources for the production of biofuels is being studied extensively. Microalgal biomass can be cultivated under photoautotrophic, heterotrophic, photoheterotrophic, and mixotrophic cultivation conditions. Photoautotrophic cultivation is the most common way of microalgal biomass production. Under mixotrophic cultivation, microalgae can utilize both organic carbon and CO2 simultaneously. Mixotrophic cultivation depicts higher biomass productivity as compared to photoautotrophic cultivation. It is evident from the literature that mixotrophic cultivation yields higher quantities of polyunsaturated fatty acids as compared to that photoautotrophic cultivation. In this context, for economical biomass production, the organic carbon of industrial wastewaters can be valorized for the mixotrophic cultivation of microalgae. Following the way, contaminants' load of wastewaters can be reduced while concomitantly producing highly productive microalgal biomass. This review focuses on different aspects covering the sustainable cultivation of different microalgal species in different types of wastewaters.

Sustainable Microalgae and Cyanobacteria Biotechnology

Marine organisms are a valuable source of new compounds, many of which have remarkable biotechnological properties, such as microalgae and cyanobacteria, which have attracted special attention to develop new industrial production routes. These organisms are a source of many biologically active molecules in nature, including antioxidants, immunostimulants, antivirals, antibiotics, hemagglutinates, polyunsaturated fatty acids, peptides, proteins, biofuels, and pigments. The use of several technologies to improve biomass production, in the first step, industrial processes schemes have been addressed with different accomplishments. It is critical to consider all steps involved in producing a bioactive valuable compound, such as species and strain selection, nutrient supply required to support productivity, type of photobioreactor, downstream processes, namely extraction, recovery, and purification. In general, two product production schemes can be mentioned; one for large amounts of product, such as biodiesel or any other biofuel and the biomass for feeding purposes; the other for when the product will be used in the human health domain, such as antivirals, antibiotics, antioxidants, etc. Several applications for microalgae have been documented. In general, the usefulness of an application for each species of microalgae is determined by growth and product production. Furthermore, the use of OMICS technologies enabled the development of a new design for human therapeutic recombinant proteins, including strain selection based on previous proteomic profiles, gene cloning, and the development of expression networks. Microalgal expression systems have an advantage over traditional microbial, plant, and mammalian expression systems for new and sustainable microalga applications, for responsible production and consumption.

Implementation of graphitic carbon nitride nanomaterials and laser irradiation for increasing bioethanol production from potato processing wastes

Agricultural and agro-industrial wastes (e.g., potato peel waste) are causing severe environmental problems. The processes of pretreatment, saccharification, and fermentation are the major obstacles in bioethanol production from wastes and must be overcome by efficient novel techniques. The effect of exposing the fungi (yeast) Saccharomyces cerevisiae to laser source with the addition of graphitic carbon nitride nanosheets (g-C₃N₄) with different concentrations on bioethanol production was investigated through the implementation of a batch anaerobic system and using potato peel waste (PPW). Dichromate test was implemented as quantitative analysis for quantification of the bioethanol yield. The benefits of this test were the appearance of green color indicating the identification of ethanol (C₂H₅OH) by bare eye and the ease to calculate the bioethanol yield through UV-visible spectrophotometry. The control sample (0.0 ppm of g-C₃N₄) showed only a 4% yield of bioethanol; however, by adding 150 ppm to PPW medium, 22.61% of ethanol was produced. Besides, laser irradiations (blue and red) as influencing parameters were studied with and without the addition of g-C₃N₄ nanomaterials aiming to increase the bioethanol. It was determined that the laser irradiation can trigger the bioethanol production (in case of red: 13.13% and in case of blue: 16.14% yields, respectively) compared to the control sample (in absence of g-C₃N₄). However, by adding different concentrations of g-C₃N₄ nanomaterials from 5 to 150 ppm, the bioethanol yield was increased as follows: in case of red: 56.11% and, in case of blue: 56.77%, respectively. It was found that using fungi and exposing it to the blue laser diode source having a wavelength of 450 nm and a power of 250 mW for a duration of 30 min with the addition of 150 mg L^-1 of g-C₃N₄ nanomaterials delivered the highest bioethanol yield from PPW.