SARS-CoV-2: low virus load on surfaces in public areas

Self-Assembly of Single-Virus SERS Hotspots for Highly Sensitive In Situ Detection of SARS-CoV-2 on Solid Surfaces

Microbial surface transmission has aroused great attention since the pandemic caused by severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Developing a simple in situ detection method for viruses on solid surfaces is of great significance for timely public health surveillance. Taking advantage of the natural structure of SARS-CoV-2, we reported the assembly of Au@AgNPs on the surface of a single virus by the specific aptamer-spike protein interaction. Multiple hotspots can be created between the neighboring Au@AgNPs for the highly sensitive surface-enhanced Raman scattering (SERS) detection of SARS-CoV-2. Using two different aptamers labeled with Cy3 and Au@AgNPs, in situ SERS detection of pseudotyped SARS-CoV-2 (PSV) on packaging surfaces was achieved within 20 min, with a detection limit of 5.26 TCID50/mL. For the blind testing of 20 PSV-contaminated packaging samples, this SERS aptasensor had a sensitivity of 100% and an accuracy of 100%. This assay has been successfully applied to in situ detection of PSV on the surfaces of different packaging materials, suggesting its potential applicability.

Assessment of Surface Disinfection Effectiveness of Decontamination System COUNTERFOG® SDR-F05A+ Against Bacteriophage ɸ29

The experience of COVID19 pandemic has demonstrated the real concern of biological agents dispersed in the air and surfaces environments. Therefore, the need of a fast and large-scale disinfection method has arisen for prevention of contagion. COUNTERFOG® is an innovative technology developed for large-scale decontamination of air and surfaces. The objective of this study is to assess experimentally the effectiveness of COUNTERFOG® in disinfecting viral-contaminated surfaces. We also aim to measure the necessary time to disinfect said surfaces. Stainless steel surfaces were contaminated with bacteriophage φ29 and disinfected using COUNTERFOG® SDR-F05A+, which uses a sodium hypochlorite solution at different concentrations and for different exposure times. A log reduction over 6 logs of virus titer is obtained in 1 min with 1.2% sodium hypochlorite when the application is direct; while at a radial distance of 5 cm from the point of application the disinfection reaches a reduction of 5.5 logs in 8 min. In the same way, a higher dilution of the sodium hypochlorite concentration (0.7% NaOCl) requires more exposure time (16 min) to obtain the same log reduction (> 6 logs). COUNTERFOG® creates, in a short time and at a distance of 2 m from the point of application, a thin layer of disinfectant that covers the surfaces. The selection of the concentration and exposure time is critical for the efficacy of disinfection. These tests demonstrate that a concentration between 0.7- 1.2% sodium hypochlorite is enough for a fast and efficient ɸ29 phage inactivation. The fact that ɸ29 phage is more resistant to disinfection than SARS-CoV-2 sustains this disinfection procedure.