Photocatalytic dye degradation using nickel ferrite spinel and its nanocomposite

Innovative Nanomaterial Properties and Applications in Chemistry, Physics, Medicine, or Environment

Developing innovative nanomaterials unlocks new opportunities in physics, chemistry, medicine, and environmental protection [...].

Effects of Lanthanum Substitution and Annealing on Structural, Morphologic, and Photocatalytic Properties of Nickel Ferrite

Nanoparticles of NiLaxFe2-xO4 ferrite spinel incorporated in a SiO2 matrix were synthesized via a sol-gel method, followed by annealing at 200, 500, and 800 °C. The resulting materials were characterized via XRD, AFM, and BET techniques and evaluated for photocatalytic activity. The XRD diffractograms validate the formation of a single-phase cubic spinel structure at all temperatures, without any evidence of secondary peaks. The size of crystallites exhibited a decrease from 37 to 26 nm with the substitution of Fe3+ with La3+ ions. The lattice parameters and crystallite sizes were found to increase with the rise in La3+ content and annealing temperature. Isotherms were employed to calculate the rate constants for the decomposition of malonate precursors to ferrites and the activation energy for each ferrite. All nanocomposites have pores within the mesoporous range, with a narrow dispersion of pore sizes. The impact of La content on sonophotocatalytic activity was evaluated by studying Rhodamine B degradation under visible light irradiation. The results indicate that the introduction of La enhances nanocomposite performance. The prepared Ni-La ferrites may have potential application for water decontamination.

Titanium doped cobalt ferrite fabricated graphene oxide nanocomposite for efficient photocatalytic and antibacterial activities

Dyes and microbes are the main sources of water pollution and their treatment with titanium doped cobalt ferrite nanoparticles (CoTixFe2-xO4 NPs) is highly challenging due to the recombination ability of their electron-hole pairs which could be mitigated by making their composite with graphene oxide (GO). In the present study, titanium doped cobalt ferrite was fabricated on GO (CoTi0.2Fe1.8O4/GO NC) via the facile ultrasonication method and its confirmation was done by various analytical studies. Homogeneous dispersion of spherical CoTi0.2Fe1.8O4 NPs on the GO surface was realized by SEM analysis. Excellent crystallinity was corroborated by XRD while a Zeta Potential value -21.52 mV depicted exceptional stability. The photocatalytic power of CoTi0.2Fe1.8O/GO NC against Congo Red (CR) dye showed 91% degradation efficiency after 120 min visible light irradiation under optimum conditions of pH 9 and dye concentration 1 mg L-1 which was reasonably higher as compared to bare CoTi0.2Fe1.8O NPs (78% degradation efficiency). The improved photocatalytic performance is accredited to its narrow bandgap value (1.07 eV) and enhanced charge separation as indicated by the Tauc plot and Photoluminescence analysis, respectively. Additionally, CoTi0.2Fe1.8O/GO NC could be readily regenerated and reused five times with only ∼2% performance loss. Meanwhile, MICs of CoTi0.2Fe1.8O4/GO NC against P. aeruginosa and S. aureus were 0.046 and 0.093 mg mL-1 while MBCs were 0.093 and 0.187 mg mL-1, respectively. Thereby, optimized NC can open new avenues for the degradation of dyes from polluted water besides acting as a promising antimicrobial agent by rupturing the cell walls of pathogens.

Facile synthesis and physicochemical characterization of κ-Carrageenan-silver-bentonite based nanocatalytic platform for efficient degradation of anionic azo dyes

Water pollution due to textile industry effluents is a global concern that warrants versatile research solutions for degrading them, and for a sustainable environment. In the present work, by using the imperative role of nanotechnology, a facile one-pot synthesis has been devised to generate κ-carrageenan capped silver nanocatalyst (CSNC), and was immobilized on 2D bentonite (BT) sheets to generate nanocatalytic platform (BTCSNC) for the degradation of anionic azo dyes. The nanocomposite(s) were physicochemically characterized using UV-Vis, DLS, TEM, FESEM, PXRD, ATR-FTIR, TGA, BET and XPS etc., to obtain insights into the nanocomposite composition, structure, stability, morphology and mechanism of interaction. The obtained CNSC are monodispersed, spherical with a size of 4 ± 2 nm, and were stabilized by the functional groups (-OH, COO‾, and SO3‾) of κ-Crg. The broadening of peak corresponding to basal plane (001) of BT montmorillonite in PXRD spectra established its exfoliation upon addition of CSNC. XPS and ATR-FTIR data evidenced the absence of covalent interactions between CSNC and BT. The catalytic efficiency of CSNC and BTCSNC composites were compared for the degradation of methyl orange (MO) and congo red (CR). The reaction followed a pseudo first order kinetics, and immobilization of CSNC on BT resulted in a 3-4 fold enhancement in degradation rates. The rates achieved for the degradation kinetics are: MO degradation within 14 s (Ka 9.86 ± 2.00 min-1), and CR degradation within 120 s (Ka of 1.24 ± 0.13 min-1). Further, a degradation mechanism has been proposed by analyzing the products identified through LC-MS. The reusability studies of the BTCSNC evidenced the complete activity of the nanocatalytic platform for six cycles, and gravitational separation method for catalyst recycling. In a nutshell, the current study provided an environmentally friendly, sizable, and sustainable nano catalytic platform" for the remediation of industrial wastewater contaminated with hazardous azo dyes".

Synthesis and visible-light photocatalytic property of spinel CuAl2O4 for vehicle emissions

Photodegradation of vehicle emissions is a promising approach for dealing with atmospheric pollution in road tunnels. In this research, copper aluminate nanoparticles (CuAl₂O₄) were prepared by the sol-gel method using copper nitrate, aluminum nitrate, and citric acid as precursor materials. The samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), and UV-Vis spectroscopy to validate their structure, surface morphology, and optical properties, respectively. The XRD and SEM results confirm that the CuAl₂O₄ powder has a particle size of 20-37 nm and exhibits a spinel-type structure. The upper limit of the stimulation wavelength in the UV-Vis diffuse reflectance spectrum is located at 725 nm with a band gap (Eg) of about 1.50 eV, which is suitable for effective visible-light degradation. Photocatalytic performance of the CuAl₂O₄ nanoparticles was analyzed by investigating the effects of light source, calcination temperature, and catalyst loading amount on the degradation of vehicle emissions (CO, HC, and NO). Best results were obtained under fluorescent light irradiation by CuAl₂O₄ nanoparticles calcined at 700 °C. The optimum catalyst amount for decomposing CO, HC, and NO were determined as 0.5 g, 0.5 g, and 2 g, respectively. Overall, the photocatalytic performance study verifies that spinel CuAl₂O₄ photocatalyst is a valuable material for next-generation technologies aimed at reducing harmful emissions from vehicles.

Recent advances in spinel ferrite-based magnetic photocatalysts for efficient degradation of organic pollutants

Although spinel ferrite (MFe₂O₄, M = Zn, Ni, Mn, etc.) has been reported as a promising catalyst, its low photocatalytic activity under visible light greatly restricts its practical application. Spinel ferrite-based photocatalytic composites have exhibited improved efficiency for pollutant degradation, due to interface charge carrier mobility and structural modification. Meanwhile, due to its magnetism and stability, spinel ferrite composite can be easily recycled for long-term utilization, showing its high application potential. In this review, the recent advances in the construction and photocatalytic degradation of spinel ferrite composites are discussed, with an emphasis on the relationship between structural property and photocatalytic activity. In addition, to improve their photocatalytic application, the challenges, gaps and future research prospects are proposed.

Photocatalytic Organic Contaminant Degradation of Green Synthesized ZrO2 NPs and Their Antibacterial Activities

The green synthesis of metal oxide nanoparticles is an efficient, simple, and chemical-free method of producing nanoparticles. The present work reports the synthesis of Murraya koenigii-mediated ZrO2 nanoparticles (ZrO2 NPs) and their applications as a photocatalyst and antibacterial agent. Capping and stabilization of metal oxide nanoparticles were achieved by using Murraya koenigii leaf extract. The optical, structural, and morphological valance of the ZrO2 NPs were characterized using UV-DRS, FTIR, XRD, and FESEM with EDX, TEM, and XPS. An XRD analysis determined that ZrO2 NPs have a monoclinic structure and a crystallite size of 24 nm. TEM and FESEM morphological images confirm the spherical nature of ZrO2 NPs, and their distributions on surfaces show lower agglomerations. ZrO2 NPs showed high optical absorbance in the UV region and a wide bandgap indicating surface oxygen vacancies and charge carriers. The presence of Zr and O elements and their O=Zr=O bonds was categorized using EDX and FTIR spectroscopy. The plant molecules’ interface, bonding, binding energy, and their existence on the surface of ZrO2 NPs were established from XPS analysis. The photocatalytic degradation of methylene blue using ZrO2 NPs was examined under visible light irradiation. The 94% degradation of toxic MB dye was achieved within 20 min. The antibacterial inhibition of ZrO2 NPs was tested against S. aureus and E. coli pathogens. Applications of bio-synthesized ZrO2 NPs including organic substance removal, pathogenic inhibitor development, catalysis, optical, and biomedical development were explored.

RGO nanosheet wrapped β-phase NiCu2S nanorods for advanced supercapacitor applications

A new integration strategy of transition metal sulfide with carbon-based materials is used to boost its catalytic property and electrochemical performances in supercapacitor application. Herein, crystalline reduced graphene oxide (rGO) wrapped ternary metal sulfide nanorod composites with different rGO ratios are synthesized using hydrothermal technique and are compared for their physical, chemical, and electrochemical performances. It is found that their properties are tuned by the weight ratios of rGO. The electrochemical investigations reveal that β-NiCu₂S/rGO nanocomposite electrode with 0.15 wt.% of rGO is found to possess maximum specific capacitance of 1583 F g^-1 at current density of 15 mA g^-1 in aqueous electrolyte medium. The same electrode shows excellent cycling stability with capacitance retention of 89% after 5000 charging/discharging cycles. The reproducibility test performed on NiCu₂S/rGO nanocomposite electrode with 0.15 wt.% of rGO indicates that it has high reproducible capacitive response and rate capability. Thus, the present work demonstrates that the β-NiCu₂S/rGO nanocomposite can serve as a potential electrode material for developing supercapacitor energy storage system.

Nanomaterials photocatalytic activities for waste water treatment: a review

Water is necessary for the survival of life on Earth. A wide range of pollutants has contaminated water resources in the last few decades. The presence of contaminants incredibly different dyes in waste, potable, and surface water is hazardous to environmental and human health. Different types of dyes are the principal contaminants in water that need sudden attention because of their widespread domestic and industrial use. The toxic effects of these dyes and their ability to resist traditional water treatment procedures have inspired the researcher to develop an eco-friendly method that could effectively and efficiently degrade these toxic contaminants. Here, in this review, we explored the effective and economical methods of metal-based nanomaterials photocatalytic degradation for successfully removing dyes from wastewater. This study provides a tool for protecting the environment and human health. In addition, the insights into the transformation of solar energy for photocatalytic reduction of toxic metal ions and photocatalytic degradation of dyes contaminated wastewater will open a gate for water treatment research. The mechanism of photocatalytic degradation and the parameters that affect the photocatalytic activities of various photocatalysts have also been reported.