Simultaneous acquisition of multi-nuclei enhanced NMR/MRI by solution-state dynamic nuclear polarization

An easy-built Halbach magnet for LF-NMR with high homogeneity using optimized target-field passive shimming method

The aim of this work is to develop a Halbach magnet that possesses characteristics such as easy-built, low cost and high homogeneity for use in a portable low-field NMR (LF-NMR) system. Considering portability, a 4-ring Halbach magnet was designed through simulation and mechanical modelling, which was successfully constructed in a general laboratory setting. The obtained field strength (B0) was 0.169 T, with an initial homogeneity of 8204 ppm within a sphere with a diameter of 20 mm. To enhance robustness, efficiency and effectiveness of shimming, an optimized target-field passive shimming method was proposed. Subsequently, the homemade spectrometer was used to run NMR experiments on the Halbach magnet. The 1H NMR linewidths of water samples became significantly narrower after passive shimming, e.g., the linewidth of a sample with a diameter of 3 mm and a length of 3 mm reduced from 452.3 Hz (62.5 ppm) to 12.9 Hz (1.8 ppm), which was much less than 102 Hz. The NMR results demonstrate that the proposed passive shimming method can achieve high homogeneity, and the developed Halbach magnet is capable of satisfying numerous LF-NMR applications.

Multiplexing experiments in NMR and multi-nuclear MRI

Multiplexing NMR experiments by direct detection of multiple free induction decays (FIDs) in a single experiment offers a dramatic increase in the spectral information content and often yields significant improvement in sensitivity per unit time. Experiments with multi-FID detection have been designed with both homonuclear and multinuclear acquisition, and the advent of multiple receivers on commercial spectrometers opens up new possibilities for recording spectra from different nuclear species in parallel. Here we provide an extensive overview of such techniques, designed for applications in liquid- and solid-state NMR as well as in hyperpolarized samples. A brief overview of multinuclear MRI is also provided, to stimulate cross fertilization of ideas between the two areas of research (NMR and MRI). It is shown how such techniques enable the design of experiments that allow structure elucidation of small molecules from a single measurement. Likewise, in biomolecular NMR experiments multi-FID detection allows complete resonance assignment in proteins. Probes with multiple RF microcoils routed to multiple NMR receivers provide an alternative way of increasing the throughput of modern NMR systems, effectively reducing the cost of NMR analysis and increasing the information content at the same time. Solid-state NMR experiments have also benefited immensely from both parallel and sequential multi-FID detection in a variety of multi-dimensional pulse schemes. We are confident that multi-FID detection will become an essential component of future NMR methodologies, effectively increasing the sensitivity and information content of NMR measurements.

SQUID-based ultralow-field MRI of a hyperpolarized material using signal amplification by reversible exchange

The signal amplification by reversible exchange (SABRE) technique is a very promising method for increasing magnetic resonance (MR) signals. SABRE can play a particularly large role in studies with a low or ultralow magnetic field because they suffer from a low signal-to-noise ratio. In this work, we conducted real-time superconducting quantum interference device (SQUID)-based nuclear magnetic resonance (NMR)/magnetic resonance imaging (MRI) studies in a microtesla-range magnetic field using the SABRE technique after designing a bubble-separated phantom. A maximum enhancement of 2658 for ¹H was obtained for pyridine in the SABRE-NMR experiment. A clear SABRE-enhanced MR image of the bubble-separated phantom, in which the para-hydrogen gas was bubbling at only the margin, was successfully obtained at 34.3 μT. The results show that SABRE can be successfully incorporated into an ultralow-field MRI system, which enables new SQUID-based MRI applications. SABRE can shorten the MRI operation time by more than 6 orders of magnitude and establish a firm basis for future low-field MRI applications.