Heating of Milk Before or After Homogenization Changes its Coagulation Behaviour During Acidification

Effects of changes in homogenization sequence and temperature for milk on physicochemical properties of stirred yoghurt

In this study, the effects of homogenization sequence (before or after heat treatment) and homogenization temperature (40, 50 and 60 °C) for milk were investigated on physicochemical properties of stirred yoghurt. Stirred yoghurts were produced from homogenized and subsequently heat-treated milks, and heat-treated and subsequently homogenized milks and stored at 4 °C for 30 days. Number of grains, mean perimeter of grains, visual roughness, firmness, apparent viscosity, consistency coefficient in yoghurts produced from homogenized milk after heat treatment were higher, compared to those in yoghurts produced from milk homogenized before heat treatment, and these increased when homogenization temperature increased. To conclude, this study showed that some physicochemical properties of yoghurt were changed, by altering homogenization sequence and homogenization temperature for milk.

Research on milk homogenization in the stream homogenizer with separate cream feeding

Homogenization, which is used in the technological schemes of production of most dairy products, is the most energy-intensive of the processes of mechanical processing of milk. One promising way to increase the energy efficiency of homogenization is to use separate homogenization and to use a little-researched stream homogenizer with separate cream feeding. The principle of its action is to pre-divide milk into cream and skim milk, and feed the fat phase with a thin stream into the stream of skim milk. This creates the conditions for achieving the high value of the Weber criterion - the main factor in the dispersion of milk fat. The purpose of these researches is to conduct experimental studies and determine the energy consumption and quality of homogenization of milk after treatment in a stream homogenizer. To achieve this goal, a designed experimental setup was used. The dispersive indices of the milk emulsion were determined by computer analysis of micrographs of milk samples obtained with an optical microscope and a digital camera using Microsoft Office Excel and Microsoft Visual Studio C # software using the OpenCV Sharp library. As a result of experimental studies, the critical value of the Weber criterion for homogenization of milk was determined, which is 28. The regularities of dispersion of milk fat in a stream homogenizer with separate feeding of the fat phase have been established. It is determined that the milk treatment in the experimental homogenizer allows us to achieve an emulsion with an average size of fat globules of about 0.8 μm (at the level of valve homogenizers). The value of the homogenization coefficient is obtained for the disruption of the fat globule in the conditions: subject to a single effect on the emulsion, without the influence of vibration and cavitation. This homogenization coefficient equals 3300 m3/2.s-1.

Interfacial characteristics, colloidal properties and storage stability of dairy protein-stabilized emulsion as a function of heating and homogenization

This research investigated the influence of processing history on physicochemical properties of dairy protein-stabilized emulsions. Emulsions were heated (UHT) either before or after a single homogenization (UHTSH, SHUHT) or homogenized both before and after heating (double homogenization, DHUHT). The results demonstrated that UHT treatment increased the protein load at the oil/water interface while homogenization prior to UHT (SHUHT) inhibited displacement of protein by surfactant molecules, and this emulsion exhibited higher interfacial protein coverage and wider size distribution compared to the emulsion produced by UHTSH. The use of the double homogenization with UHT resulted in emulsion droplets with the smallest average size and lowest concentration of unabsorbed protein. However, no difference in the protein load in a specific area was noticed between emulsions produced by DHUHT and SHUHT. When changes of surface tension at the air/water interface were measured using a drop tensiometer, SHUHT emulsion showed the fastest decrease of surface tension due to the occurrence of a lower level of surfactant displacement where more surfactant was available for fast adsorption. Emulsions prepared with DHUHT or UHTSH decreased the surface tension in a slower speed than SHUHT. During storage, partial coalescence of emulsion droplets was observed for emulsions produced with single homogenization, regardless of whether this was carried out before or after heating. Double homogenization formed more stable emulsions than single homogenization. This work clearly showed that it is possible to tailor physico-chemical functionalities of dairy protein-based emulsions by controlling the interactions between proteins or with surfactants during processing.

Conventional and Innovative Processing of Milk for Yogurt Manufacture; Development of Texture and Flavor: A Review

Milk and yogurt are important elements of the human diet, due to their high nutritional value and their appealing sensory properties. During milk processing (homogenization, pasteurization) and further yogurt manufacture (fermentation) physicochemical changes occur that affect the flavor and texture of these products while the development of standardized processes contributes to the development of desirable textural and flavor characteristics. The processes that take place during milk processing and yogurt manufacture with conventional industrial methods, as well as with innovative methods currently proposed (ultra-high pressure, ultrasound, microfluidization, pulsed electric fields), and their effect on the texture and flavor of the final conventional or probiotic/prebiotic products will be presented in this review.