The Electrical Conductivity and Dielectric Response of Cupric Acetylacetonate Thin Films

Trace Small Molecular/Nano-Colloidal Multiscale Electrolyte Additives Enable Ultra-Long Lifespan of Zinc Metal Anodes

Electrolyte additives are efficient to improve the performance of aqueous zinc-ion batteries (AZIBs), yet the current electrolyte additives are limited to fully water-soluble additives (FWAs) and water-insoluble additives (WIAs). Herein, trace slightly water-soluble additives (SWAs) of zinc acetylacetonate (ZAA) were introduced to aqueous ZnSO4 electrolytes. The SWA system of ZAA is composed of a FWA part and a WIA part in a dynamic manner of dissolution equilibrium. The FWA part exists as soluble small molecules, which efficiently regulate Zn2+ ion solvation structure, while the WIA part exists as insoluble nano-colloids, which in-situ form a thick and robust solid electrolyte interface film on zinc metal anodes (ZMAs). Such small molecular/nano-colloidal multiscale electrolyte additives of ZAA are capable to not only improve ionic conductivity and transference number but also inhibit corrosion, hydrogen evolution, and Zn dendrite on ZMAs. The SWA-based Zn∥Zn half battery delivers a superb cumulative plating capacity of 15 Ah cm-2 under 1 mAh cm-2 and 20 mA cm-2, and the SWA-based NH4V4O10∥Zn pouch cell obtains a capacity retention of 67.8% within 4000 cycles under 4 A g-1. The study provides innovative insights for rational design of electrolyte additives, which may pave the way for the practicality of AZIBs.

Silica- Iron Oxide Nanocomposite Enhanced with Porogen Agent Used for Arsenic Removal

This study aims to remove arsenic from an aqueous medium by adsorption on a nanocomposite material obtained by the sol–gel method starting from matrices of silica, iron oxide and NaF (SiO₂/Fe(acac)₃/NaF). Initially, the study focused on the synthesis and characterization of the material by physico–chemical methods such as: X-ray diffraction, FT-IR spectroscopy, Raman spectroscopy, atomic force microscopy, and magnetization. Textural properties were obtained using nitrogen adsorption/desorption measurements. The zero load point, pHpZc, was also determined by the method of bringing the studied system into equilibrium. In addition, this study also provides a comprehensive discussion of the mechanism of arsenic adsorption by conducting kinetic, thermodynamic and equilibrium studies. Studies have been performed to determine the effects of adsorbent dose, pH and initial concentration of arsenic solution, material/arsenic contact time and temperature on adsorption capacity and material efficiency. Three theoretical adsorption isotherms were used, namely Langmuir, Freundlich and Sips, to describe the experimental results. The Sips isotherm was found to best describe the experimental data obtained, the maximum adsorption capacity being ~575 µg As(III)/g. The adsorption process was best described by pseudo-second order kinetics. Studies have been performed at different pH values to establish not only the optimal pH at which the adsorption capacity is maximum, but also which is the predominantly adsorbed species. The effect of pH and desorption studies have shown that ion exchange and the physiosorption mechanism are implicated in the adsorption process. From a thermodynamic point of view, parameters such as ΔG°, ΔH° and ΔS° were evaluated to establish the mechanism of the adsorption process. Desorption studies have been performed to determine the efficiency of the material and it has been shown that the material can be used successfully to treat a real-world example of deep water with a high arsenic content.