Structural Analysis of Partial and Total Esters of Glycerol Undecenoate and Diglycerol Undecenoate

Theoretical and Kinetic Analysis of the Esterification of Undecylenic Acid with Glycerol

The synthesis of undecylenic acid partial esters can be performed at mild temperature with a classical esterification reaction catalyzed by dodecylbenzene sulfonic acid (DBSA). A semi-empirical molecular modeling on the different reaction intermediates indicates that DBSA can strongly decrease their heats of formation through hydrogen bonding. Diester formation seems to be thermodynamically favored with a selectivity for alpha, alpha, or alpha, beta forms that depend on the geometry of the catalyst-intermediate configuration. Triesters are not favored but a high selectivity for monoesters requires a kinetic control. Experimental approach, considering different DBSA concentrations and temperature partially confirms the theoretical predictions but surfactant properties of DBSA and monoesters may induce nonpredicted geometries. Global apparent activation energies are calculated, corresponding to the formation and hydrolysis of mono and diesters. If water trapping allows the decrease of hydrolysis reaction constants, the presence of water and subsequent phase separation may explain differences between theoretical and experimental results and could help increasing monoester selectivity.

Effect of aliphatic chain length on the chemical structures of low molecular weight hyperbranched polyesters

Low molecular weight hyperbranched (HB) polyesters were synthesized via melt polymerization from trimethylolpropane and three aliphatic dicarboxylic acids, namely, succinic acid (SA), adipic acid (AA) and dodecanedioic acid (DA). The degrees of branching (DBs) ranged between 30% and 75% depending on the monomer ratio. Their DB, cyclic index and terminal index were all determined, indicating that the shorter chain HB polyesters PE-SA and PE-AA showed a greater degree of intramolecular cyclization, compared to the longer aliphatic chains within PE-DA. The HB polyesters form stable colloidal suspensions in buffered aqueous media and were found to be pH responsive. The stability of the colloidal suspensions is enhanced by two factors: (1) increasing the aliphatic chain length and (2) increasing the pH of the solution for the same HB polyester.

Self-Assembling Behavior of Glycerol Monoundecenoate in Water

The self-assembling properties of glycerol esters in water are well known. Still, few data on glycerol monoesters of undecylenic acid are available. The aim of this study was to highlight the behavior of glycerol monoundecenoate (GM-C11:1) in different diluted and concentrated states. Its self-assembling properties in water and upon solid inorganic surfaces were investigated in the diluted state using surface tension experiments, atomic force microscopy, and cryogenic transmission electron microscopy studies. In the concentrated state, the gelling properties in the presence of water were investigated using polarized light microscopy, differential scanning calorimetry (DSC), and small-angle X-ray scattering (SAXS) experiments. GM-C11:1 at 100 mg/L self-assembles at the liquid/air interfaces as aggregates of approximately 20 nm in diameter, organized into concentric forms. These aggregates are spherical globules composed of several molecules of GM-C11:1. At higher concentrations (1000 and 10⁴ mg/L), GM-C11:1 is able to uniformly coat liquid/air and liquid/solid interfaces. In bulk, GM-C11:1 forms spontaneously aggregates and vesicles. In a more concentrated state, GM-C11:1 assembles into lamellar L_β and L_α forms in water. By cross-referencing SAXS and DSC findings, we were able to distinguish between interlamellar water molecules strongly bound to GM-C11:1 and other molecules remaining unbound and considered to be "mobile" water. The percentage of water strongly bound was proportional to the percentage of GM-C11:1 in the system. In this case, GM-C11:1 appears to be an effective molecule for surface treatments for which water retention is important.