Statistical methodology for optimizing the dilute acid hydrolysis of sugarcane bagasse

Principal factors affecting the yield of dilute acid pretreatment of lignocellulosic biomass: A critical review

This review provides a critical analysis of the state of the art of dilute acid pretreatment applied to lignocellulosic biomass. Data from 63 publications were extracted and analysed. The majority of the papers used residence times of<30 min, temperature ranges from 100 °C to 200 °C, and acid levels between 0 % and 2 %. Yields are quantified directly after pretreatment (xylose content) or after enzymatic hydrolysis (glucose content). Statistical analyses allowed the time-temperature equivalence to be quantified for three types of biomass: they were formulated by non-linear expressions. In further works, investigating less explored areas, for example moderate temperature levels with longer residence times, is recommended. Pretreatment material (time-temperature kinetics, reactor type) and analytical methods should be standardized and better described. It becomes mandatory to promote the development of an open, findable, accessible, interoperable, and reusable data approach for pretreatments research.

Effect of Mechanical Treatment of Eucalyptus Pulp on the Production of Nanocrystalline and Microcrystalline Cellulose

This study aimed to assess the effect of mechanical pretreatment on bleached eucalyptus kraft pulp fibers and investigate the influence of reaction time and temperature on the properties and yield of nanocrystalline cellulose (NCC) and microcrystalline cellulose (MCC). Two types of pulps were hydrolyzed, pulp 1 (control, whole fibers) and pulp 2 (mechanically pretreated, disintegrated fibers). NCC and MCC particles were obtained by sulfuric acid hydrolysis (60% w/w) of eucalyptus pulps under different conditions of time (30–120 min) and temperature (45–55 °C). Physical treatment of kraft pulp facilitated acid hydrolysis, resulting in higher NCC yields compared with no pretreatment. The morphologic properties and crystallinity index (CI) of NCC and MCC were little affected by pulp pretreatment. NCC particles obtained from pulps 1 and 2 were needle-shaped, with mean diameters of 6 and 4 nm, mean lengths of 154 and 130 nm, and CI of 74.6 and 76.8%, respectively. MCC particles obtained from pulps 1 and 2 were rod-shaped, with mean diameters of 2.4 and 1.4 µm, mean lengths of 37 and 22 µm, and CI of 73.1 and 74.5%, respectively. Pulps 1 and 2 and their respective NCC and MCC derivatives had a cellulose I crystalline structure.

Optimization of dilute sulfuric acid pretreatment to maximize combined sugar yield from sugarcane bagasse for ethanol production

Increasing fermentable sugar yields per gram of biomass depends strongly on optimal selection of varieties and optimization of pretreatment conditions. In this study, dilute acid pretreatment of bagasse from six varieties of sugarcane was investigated in connection with enzymatic hydrolysis for maximum combined sugar yield (CSY). The CSY from the varieties were also compared with the results from industrial bagasse. The results revealed considerable differences in CSY between the varieties. Up to 22.7 % differences in CSY at the optimal conditions was observed. The combined sugar yield difference between the best performing variety and the industrial bagasse was 34.1 %. High ratio of carbohydrates to lignin and low ash content favored the release of sugar from the substrates. At mild pretreatment conditions, the differences in bioconversion efficiency between varieties were greater than at severe condition. This observation suggests that under less severe conditions the glucose recovery was largely determined by chemical composition of biomass. The results from this study support the possibility of increasing sugar yields or improving the conversion efficiency when pretreatment optimization is performed on varieties with improved properties.