A Nucleic Acid Biosensor for Detection of Hepatitis C Virus Genotype 1a Using Poly(l-Glutamic Acid)-Modified Electrode

Advanced Theranostic Strategies for Viral Hepatitis Using Carbon Nanostructures

There are several treatment protocols for acute viral hepatitis, and it is critical to recognize acute hepatitis in its earliest stages. Public health measures to control these infections also rely on rapid and accurate diagnosis. The diagnosis of viral hepatitis remains expensive, and there is no adequate public health infrastructure, while the virus is not well-controlled. New methods for screening and detecting viral hepatitis through nanotechnology are being developed. Nanotechnology significantly reduces the cost of screening. In this review, the potential of three-dimensional-nanostructured carbon substances as promising materials due to fewer side effects, and the contribution of these particles to effective tissue transfer in the treatment and diagnosis of hepatitis due to the importance of rapid diagnosis for successful treatment, were extensively investigated. In recent years, three-dimensional carbon nanomaterials such as graphene oxide and nanotubes with special chemical, electrical, and optical properties have been used for the diagnosis and treatment of hepatitis due to their high potential. We expect that the future position of nanoparticles in the rapid diagnosis and treatment of viral hepatitis can be better determined.

Genosensors as an alternative diagnostic sensing approaches for specific detection of various certain viruses: a review of common techniques and outcomes

Viral infections are responsible for the deaths of millions of people throughout the world. Since outbreak of highly contagious and mutant viruses such as contemporary sars-cov-2 pandemic, has challenged the conventional diagnostic methods, the entity of a thoroughly sensitive, specific, rapid and inexpensive detecting technique with minimum level of false-positivity or -negativity, is desperately needed more than any time in the past decades. Biosensors as minimized devices could detect viruses in simple formats. So far, various nucleic acid, immune- and protein-based biosensors were designed and tested for recognizing the genome, antigen, or protein level of viruses, respectively; however, nucleic acid-based sensing techniques, which is the foundation of constructing genosensors, are preferred not only because of their ultra-sensitivity and applicability in the early stages of infections but also for their ability to differentiate various strains of the same virus. To date, the review articles related to genosensors are just confined to particular pathogenic diseases; In this regard, the present review covers comprehensive information of the research progress of the electrochemical, optical, and surface plasmon resonance (SPR) genosensors that applied for human viruses' diseases detection and also provides a well description of viruses' clinical importance, the conventional diagnosis approaches of viruses and their disadvantages. This review would address the limitations in the current developments as well as the future challenges involved in the successful construction of sensing approaches with the functionalized nanomaterials and also allow exploring into core-research works regarding this area.

Fluorescent paper-based DNA sensor using pyrrolidinyl peptide nucleic acids for hepatitis C virus detection

A novel fluorescent paper-based DNA sensor employing a highly specific pyrrolidinyl peptide nucleic acid (acpcPNA) probe was developed for the sensitive and selective detection of hepatitis C virus (HCV). The acpcPNA was covalently immobilized onto partially oxidized cellulose paper via reductive alkylation between the amine and the aldehyde groups. The fluorescence-based detection was performed by monitoring the fluorescence signal response of a fluorescent dye that selectively binds to the single-strand region of the DNA target over the PNA probe employing a custom-made portable fluorescent camera gadget in combination with a smartphone camera. Under the optimal conditions, a linear relationship between the fluorescence change in the green channel and the amount of HCV DNA from 5 to 100 pmol with a correlation coefficient of 0.9956, and the limit of detection of 5 pmol were obtained for short synthetic oligonucleotides. The acpcPNA probe exhibited very high selectivity for the complementary oligonucleotides over the single-base-mismatched, two-base-mismatched, and non-complementary DNA targets. Benefitting from the signal amplification achieved through the numerous binding sites for the dye provided by the overhanging tail of long ssDNA target sequences, this system was successfully applied to detect the HCV complementary DNA (cDNA) obtained from clinical samples with satisfactory results. The proposed fluorescent paper-based sensor demonstrated a great potential to be used as a low-cost, simple, label-free, sensitive, and selective DNA sensor for point-of-care applications.

Highly selective sensing and measurement of microRNA-541 based on its sequence-specific digestion by the restriction enzyme Hinf1

In this study, a genosensor is introduced to detect microRNA-541 through an enzymatic digestion method and using a restriction enzyme (RE). Hinf1 is a type of RE which can cut the double helix DNA at specific sequences. The hybridization event and the corresponding enzymatic reactions are studied through guanine signal tracing on a pencil graphite electrode modified with graphene quantum dots (GQDs/PGE). The stages of fabricating the electrode are monitored by atomic force microscopy, and its electrochemical behavior is studied by cyclic voltammetry. The results indicate that the guanine current response of a 25-mer oligonucleotide of 7-guanine immobilized on the electrode surface decreases after hybridization despite an increase in the number of the guanine bases. Also, after enzyme treatment, the current decreases further due to the separation of a number of guanine bases from ds-DNA. A comparison of the analytical parameters of the proposed method with those of the conventional guanine oxidation method indicates that the linear concentration range in the proposed method, i.e. 1.0 fM to 1.0 nM, is lower than that in the conventional method, i.e. 10.0 pM-1.0 μM. On the basis of these findings, it is concluded that the use of Hinf1 enzyme makes it possible to measure microRNA at a femtomolar level. The selectivity of the designed biosensor has been proved using a non-complementary sequence with a one-base mismatch in the recognition site, rather than a complementary sequence. Finally, the proposed genosensor can be satisfactorily applied to measure microRNA-541 in human plasma samples.

Electrochemical nucleic acid hybridization biosensor based on poly(L-Aspartic acid)-modified electrode for the detection of short oligonucleotide sequences related to hepatitis C virus 1a

This work describes, for the first time, the fabrication of poly(L-aspartic acid) (PAA) film modified pencil graphite electrode (PGE) for the detection of hepatitis C Virus 1a (HCV1a). The presence of PAA on the electrode surface can provide free carboxyl groups for covalent binding of biomolecules. The PGE surface was first coated with PAA via electropolymerization of the L-aspartic acid, and avidin was subsequently attached to the PAA modified electrode by covalent attachment. Biotinylated HCV1a probes were immobilized on avidin/PAA/PGE via avidin-biotin interaction. The morphology of PAA/PGE was examined using a scanning electron microscope. The hybridization events were monitored with square wave voltammetry using Meldola's blue (MDB). Compared to non-complementary oligonucleotide sequences, when hybridization was carried out between the probe and its synthetic targets or the synthetic polymerase chain reaction analog of HCV1a, the highest MDB signal was observed. The linear range of the biosensor was 12.5 to 100 nM and limit of detection was calculated as 8.7 nM. The biosensor exhibited favorable stability over relatively long-term storage. All these results suggest that PAA-modified electrode can be used to nucleic acid biosensor application and electropolymerization of L-aspartic acid can be considered as a good candidate for the immobilization of biomolecules.