Effect of the humidity on analysis of aromatic compounds with planar differential ion mobility spectrometry

Influence of Sample Gas Humidity on Product Ion Formation in High Kinetic Energy Ion Mobility Spectrometry (HiKE-IMS)

High Kinetic Energy Ion Mobility Spectrometers (HiKE-IMS) chemically ionize gaseous samples via reactant ions and separate the generated ions by their motion in a neutral gas under the influence of an electric field. Operation at reduced pressures of 10-40 mbar allows for reaching high reduced electric field strengths (E/N) of up to 120 Td. At these high E/N, the generated ions gain the namesake high kinetic energies, leading to a decrease in cluster size of the reactant ions by increasing the reaction rate of collision-induced cluster dissociation of hydrates. In positive ion polarity and in purified air, H₃O⁺(H₂O)_n, NO⁺(H₂O)_n, and O₂^+•(H₂O)_p are the most abundant reactant ions. In this work, we investigate the effect of varying sample gas humidity on product ion formation for several model substances. Results show that increasing the sample gas humidity at high E/N of 120 Td shifts product ion formation from a charge transfer dominated reaction system to a proton transfer dominated reaction system. For HiKE-IMS operated at high E/N, the reduction in cluster size of reactant ions allows ionization of analytes with low proton affinity even at high relative humidity in the sample gas of RH = 75% at 303.15 K and 1013.25 hPa. In contrast to conventional IMS, where increasing the sample gas humidity inhibits ionization for various analytes, increasing sample gas humidity in HiKE-IMS operated at 120 Td is actually beneficial for ionization yield of most analytes investigated in this work as it increases the number of H₃O⁺(H₂O)n.

Clustering and Nonclustering Modifier Mixtures in Differential Mobility Spectrometry for Multidimensional Liquid Chromatography Ion Mobility-Mass Spectrometry Analysis

Modifiers provide fast and reliable tuning of separation in differential mobility spectrometry (DMS). DMS selectivity for separating isomeric molecules depends on the clustering modifier concentration, which is typically 1.5-3 mol % ratio of isopropanol or ethanol in nitrogen. Low concentrations (0.1%) of isopropanol were found to improve resolution and sensitivity but at the cost of practicality and robustness. Replacing the single-channel DMS pump with a binary high-performance liquid chromatography (HPLC) pump enabled the generation of modifier mixtures at a constant flow rate using an isocratic or gradient mode, and the analytical benefits of the system were investigated considering cyclohexane, n-hexane, or n-octane as nonclustering modifiers and isopropanol or ethanol as clustering modifiers. It was found that clustering and nonclustering modifier mixtures enable optimization of selectivity, resolution, and sensitivity for different positional isomers and diastereoisomers. Data further suggested different ion separation mechanisms depending on the modifier ratios. For 85 analytes, the absolute difference in compensation voltages (CoVs) between pure nitrogen and cyclohexane at 1.5 mol % ratio was below 4 V, demonstrating its potential as a nonclustering modifier. Cyclohexane's nonclustering behavior was further supported by molecular modeling using density functional theory (DFT) and calculated cluster binding energies, showing positive ΔG values. The ability to control analyte CoVs by adjusting modifier concentrations in isocratic and gradient modes is beneficial for optimizing multidimensional LCxDMS-MS. It is fast and effective for manipulating the DMS scanning window size to realize shorter mass spectrometry (MS) acquisition cycle times while maintaining a sufficient number of CoV steps and without compromising DMS separation performance.

High Kinetic Energy Ion Mobility Spectrometry (HiKE-IMS) at 40 mbar

High Kinetic Energy Ion Mobility Spectrometers (HiKE-IMS) are usually operated at an absolute pressure of 20 mbar reaching high reduced electric field strengths of up to 125 Td for controlled reaction kinetics. This significantly increases the linear range and limits chemical cross sensitivities. Furthermore, HiKE-IMS enables the ionization of compounds normally not detectable in ambient pressure IMS, such as benzene, due to new reaction pathways and the inhibition of clustering reactions. In addition, HiKE-IMS allows the observation of additional orthogonal parameters related to an increased ion temperature such as fragmentation and field-dependent ion mobility, which may help to separate compounds that have similar ion mobility under low field conditions. Aiming for a hand-held HiKE-IMS to carry its benefits into field applications, reducing size and power consumption of the vacuum system is necessary. In this work, we present a novel HiKE-IMS design entirely manufactured from standard printed circuit boards (PCB) and experimentally investigate the analytical performance in dependence of the operating pressure between 20 mbar and 40 mbar. Hereby, the limit of detection (LoD) for benzene in purified, dry air (1.4 ppm_V water) improved from 7 ppb_V at 20 mbar down to 1.8 ppb_V at 40 mbar. Furthermore, adding 0.9 ppm_V toluene, the signal of the benzene B⁺ peak decreased by only 2% at 40 mbar. Even in the presence of high relative humidity in the sample gas above 90% or toluene concentrations of up to 20 ppm_V, the LoD for benzene just increased to 9 ppb_V at 40 mbar.

Differential Mobility Spectrometry of Ketones in Air at Extreme Levels of Moisture

The performance of a differential mobility spectrometer was characterized at ambient pressure and ten values of water vapor concentration, from 1.0 × 102 to 1.7 × 104 ppm using a homologous series of seven ketones from acetone to 2-dodecanone. Dispersion plots at 30 °C with separation fields from 35 to 123 Td exhibited increased alpha functions for the hydrated proton, protonated monomers, and proton bound dimers with increased moisture levels. Increases in the level of moisture were accompanied by decreased quantitative response with progressive suppression in the formation of the proton bound dimer first and then protonated monomer. Product ions for 2-octanone at 7 ppb were not observed above a moisture level of 4.0 × 103 ppm, establishing a limit for observation of analyte ion formation. The observation limit increased from 1.1 × 103 ppm for acetone to 5.7 × 103 ppm for 2-dodecanone. These findings demonstrate that ketones can be determined with a differential mobility spectrometry (DMS) analyzer near room temperature in the presence of elevated levels of moisture expected with the use of membrane inlets or headspace sampling of surface or ground waters. Moisture levels entering this DMS analyzer employed as an environmental monitor should be kept at 1.0 × 103 ppm or below and quantitative studies for individual ketones should be made at a fixed moisture level.

Portable combination of Fourier transform infrared spectroscopy and differential mobility spectrometry for advanced vapor phase analysis

Designing mobile devices for the analysis of complex sample mixtures containing a variety of analytes at different concentrations across a large dynamic range remains a challenging task in many analytical scenarios. To meet this challenge, a compact hybrid analytical platform has been developed combining Fourier transform infrared spectroscopy based on substrate-integrated hollow waveguides (iHWG-FTIR) with gas chromatography coupled differential mobility spectrometry (GC-DMS). Due to the complementarity of these techniques regarding analyte type and concentration, their combination provides a promising tool for the detection of complex samples containing a broad range of molecules at different concentrations. To date, the combination of infrared spectroscopy and ion mobility techniques remains expensive and bound to a laboratory utilizing e.g. IMS as prefilter or IR as ionization source. In the present study, a cost-efficient and portable solution has been developed and characterized representing the first truly hyphenated IR-DMS system. As a model analyte mixture, 5 ppm isopropylmercaptan (IPM) in methane (CH4) were diluted, and the concentration-dependent DMS signal of IPM along with the concentration-dependent IR signal of CH4 were recorded for all three hybrid IR-DMS systems. While guiding the sample through the iHWG-FTIR or the GC-DMS first did not affect the obtained signals, optimizing the IR data acquisition parameters did benefit the analytical results.