Development and Validation of a Green High Performance Liquid Chromatographic Method for the Determination of Some Artificial Sweeteners and Caffeine in Soft Drinks

Simultaneous determination of sweeteners and preservatives in beverages by HPLC-DAD-ELSD

People suffering from diabetes or being overweight must severely reduce their sugar use, often seeking food with sweeteners. Often, sugar is replaced by non-nutritious sweeteners in beverages, which also contain several other substances like vitamins, caffeine, amino acids, phenolic compounds and thus increasing the shelf life of the beverages is additionally treated with the addition of preservatives. As the concentration of additives in food (including beverages) is determined by the legislation in force, it is necessary to have an appropriate analytical method for food control. Since artificial sweeteners and preservatives are very different substances, they are determined separately using different HPLC methods. In this work HPLC method combining the advantages of specific (diode array detector, DAD) and universal (evaporative light scattering detector, ELSD) detector was validated and used for simultaneous determination of benzoic acid, sorbic acid, aspartame, acesulfame K, saccharin, sucralose and steviol glycosides in sugar-free beverages. The proposed analytical method showed good linearity, precision, and accuracy. Measured limits of detection (0.6 – 11.8 mg.dm-3 depending on the analyte) were sufficient to analyze 5-times diluted beverage samples. The validated method has been successfully used for the simultaneous analysis of artificial sweeteners and preservatives in beverage samples (energy drinks, ice teas, carbonated drinks). Except for steviol glycosides, the concentration of monitored substances in beverages did not exceed the maximum permitted concentrations given in the valid legislation.

A Quantitative Method for Acesulfame K Using the Taste Sensor

We have developed a method to quantify the sweetness of negatively charged high-potency sweeteners coexisting with other taste substances. This kind of sweetness sensor uses lipid polymer membranes as the taste-sensing part. Two types of outputs have been defined in the measurement of the taste sensor: one is the relative value and the other is the CPA (the change in membrane potential caused by adsorption) value. The CPA value shows a good selectivity for high-potency sweeteners. On the other hand, the relative value is several times higher than the CPA value, but the relative value is influenced by salty substances. In order to obtain both high sensitivity and selectivity, we established a model for predicting the concentration of sweeteners with a nonlinear regression analysis method using the relative values of both the sweetness sensor and the saltiness sensor. The analysis results showed good correlations with the estimated concentration of acesulfame potassium coexisting with salty substances, as represented by R² = 0.99. This model can correspond well to the prediction of acesulfame K in a concentration of 0.2–0.7 mM, which is commonly used in food and beverages. The results obtained in this paper suggest that this method is useful for the evaluation of acesulfame K using the taste sensors.

Taste Sensor: Electronic Tongue with Lipid Membranes

Taste is of five basic types, namely, sourness, saltiness, sweetness, bitterness and umami. In this review, we focus on a potentiometric taste sensor that we developed and fabricated using lipid polymer membranes. The taste sensor can measure the taste perceived by humans and is called an electronic tongue with global selectivity, which is the property to discriminate taste qualities and quantify them without discriminating each chemical substance. This property is similar to the gustatory system; hence, the taste sensor is a type of biomimetic device. In this paper, we first explain the sensing mechanism of the taste sensor, its application to beer evaluation and the measurement mechanism. Second, results recently obtained are introduced; i.e., the application of the senor to high-potency sweeteners and the improvement of the bitterness sensor are explained. Last, quantification of the bitterness-masking effect of high-potency sweeteners is explained using a regression analysis based on both the outputs of bitterness and sweetness sensors. The taste sensor provides a biomimetic method different from conventional analytical methods.

Nafion covered lead film electrode for the voltammetric determination of caffeine in beverage samples and pharmaceutical formulations

This paper presents a sensitive, selective and low-cost voltammetric method for the determination of caffeine using a Nafion covered lead film electrode. The sensor was prepared on a glassy carbon electrode modified with lead film recovered by a Nafion layer. Caffeine was accumulated and then oxidised at the modified electrode surface to produce two anodic peaks at 0.86 and 1.40 V (vs. Ag/AgCl) in 0.1 mol L(-1) H2SO4 medium. The obtained detection limits for caffeine following 120 s of accumulation time were equal to 1.7 × 10(-8) mol L(-1) (for peak 1) and 2.2 × 10(-7) mol L(-1) (for peak 2). The method was successfully applied to determination of caffeine in tea, coffee, soft and energy drink samples as well as pharmaceutical formulation and the contents closely corresponded to those quoted by the manufacturer and those obtained by the reported spectrophotometric method.

Determination of artificial sweeteners in beverages with green mobile phases and high temperature liquid chromatography-tandem mass spectrometry

A new analytical procedure involving the use of water and a low percentage of ethanol combined to high temperature liquid chromatography-tandem mass spectrometry has been developed for the determination of nine high-intensity sweeteners in a variety of drink samples. The method permitted the analysis in 23min (including column reequilibration) and consuming only 0.85mL of a green organic solvent (ethanol). This methodology provided limits of detection (after 50-fold dilution) in the 0.05-10mg/L range, with recoveries (obtained from five different types of beverages) being in the 86-110% range and relative standard deviation values lower than 12%. Finally, the method was applied to 25 different samples purchased in Spain, where acesulfame and sucralose were the most frequently detected analytes (>50% of the samples) and cyclamate was found over the legislation limit set by the European Union in a sample and at the regulation boundary in three others.