Sensitive Photochemically Induced Fluorescence Sensor for the Determination of Nitenpyram and Pyraclostrobin in Grapes and Wines

An upconverted nanoparticle-porphyrin metal-organic framework platform for near-infrared detection of nitenpyram

A ratiometric nitenpyram (NIT) upconversion luminescence sensor UCNPs-PMOF was fabricated from a metal-porphyrin organic framework (PMOF) and pretreated UCNPs. The reaction between NIT and the PMOF releases the H₂TCPP (5,10,15,20-tetracarboxyl phenyl) porphyrin ligand, which enhances the absorption of the system at 650 nm, and reduces the upconversion emission intensity of the sensor at 654 nm through a luminescence resonance energy transfer (LRET) mechanism, thus achieving the quantitative detection of NIT. The detection limit was 0.21 μM. Meanwhile, the emission peak of UCNPs-PMOF at 801 nm does not change with the concentration of NIT, and the emission intensity ratio (I_{654 nm}/I_{801 nm}) is used to achieve the ratiometric luminescence detection of NIT, and the detection limit is 0.22 μM. UCNPs-PMOF has good selectivity and anti-interference to NIT. In addition, it has a good recovery rate in actual sample detection, which indicates that it has high practicability and reliability in NIT detection.

Development of 2D and 3D front face fluorescence spectroscopy for monitoring ultrasound treatment in the removal of pesticides residues from fresh lettuces at the laboratory and pilot scales

Pesticide residues in vegetables are potentially toxic components to humans and can cause serious health problems. To remove pesticide residues from fresh agricultural products and improve consumer food safety, various pesticide removal methods have been investigated over the past decades. In this study, the effectiveness of laboratory and pilot scale ultrasonic cleaning on the removal of boscalid and pyraclostrobin residues from lettuce was examined. 2D fluorescence spectroscopy, 3D fluorescence spectroscopy represented by excitation-emission matrix (EEM), and parallel factor analysis (PARAFAC) were used to characterize and discriminate the fluorescence signatures of these pesticides in the cleaning water to determine the effectiveness of the ultrasonic cleaning method as a function of the level of pesticide removal. The 2D fluorescence results showed that the rate of removal of boscalid by ultrasonics at the laboratory scale increased with the cleaning time. The ultrasonic treatment showed a higher cleaning efficiency compared to only soaking in distilled water for 10 min. The same trends were observed at the pilot scale. The EEM also showed differences in the concentration of pesticides removed by ultrasonication between the different parts of the lettuce, the concentration was higher in the upper part than the lower part. This study showed that ultrasonication is an effective technique for the removal of pesticide residues on lettuce, and it also showed the significant potential of fluorescence spectroscopy coupled with PARAFAC for the discrimination and characterization of pesticides.

Chemical Derivatization in Flow Analysis

Chemical derivatization for improving selectivity and/or sensitivity is a common practice in analytical chemistry. It is particularly attractive in flow analysis in view of its highly reproducible reagent addition(s) and controlled timing. Then, measurements without attaining the steady state, kinetic discrimination, exploitation of unstable reagents and/or products, as well as strategies compliant with Green Analytical Chemistry, have been efficiently exploited. Flow-based chemical derivatization has been accomplished by different approaches, most involving flow and manifold programming. Solid-phase reagents, novel strategies for sample insertion and reagent addition, as well as to increase sample residence time have been also exploited. However, the required alterations in flow rates and/or manifold geometry may lead to spurious signals (e.g., Schlieren effect) resulting in distorted peaks and a noisy/drifty baseline. These anomalies can be circumvented by a proper flow system design. In this review, these aspects are critically discussed mostly in relation to spectrophotometric and luminometric detection.

Effective nitenpyram detection in a dual-walled nitrogen-rich In(iii)/Tb(iii)–organic framework

A heterometallic MOF probe with the advantages of strong fluorescence, simple synthesis, high density of Lewis acidic and basic sites, and repeatable use, has been designed and synthesized, which exhibits a rapid and sensitive reaction to nitenpyram.

Analytical methods to analyze pesticides and herbicides

This paper reviews studies published in 2019, in the area of analytical techniques for determination of pesticides and herbicides. It should be noted that some of the reports summarized in this review are not directly related to but could potentially be used for water environment studies. Based on different methods, the literatures are organized into six sections, namely extraction methods, electrochemical techniques, spectrophotometric techniques, chemiluminescence and fluorescence methods, chromatographic and mass spectrometric techniques, and biochemical assays. PRACTITIONER POINTS: Totally 141 research articles have been summarized. The review is divided into six parts. Chromatographic and mass spectrometric techniques are the most widely used methods.

Two luminescent dye@MOFs systems as dual-emitting platforms for efficient pesticides detection

Pesticides, which can accumulate in soil, water, animals and plants, are essential to world agriculture. Developing a method that can efficiently and quickly detect toxic pesticides is of importance but still a challenge. Here, two luminescent dye@MOFs systems, Rho B@1 and Rho 6G@1, were successfully fabricated based on [Cd₂(tib)(btb)(H₂O)₂]∙NO₃∙2DMF (1). This work is the first use of two fluorescent sensors as dual-emitting platforms for detecting pesticides. As a result, the fluorescence intensity ratios between the two main emissions can be tuned using the concentrations of the dye solutions, and the emissions are at 370 nm/606 nm and 370 nm/590 nm for Rho B@1 and Rho 6G@1, respectively. The intensities of the two main emissions of Rho B@1 and Rho 6G@1 are also influenced by the chemical structures of pesticides with electron-withdrawing groups. It is important that high sensitivity and selectivity for sensing pesticides must have good recyclability. Rho B@1 and Rho 6G@1 can still remain stable regarding the detection of nitenpyram even after 5 cycles, with LODs of 0.48 nM for Rho B@1 and 3 nM for Rho 6G@1, which indicate that these two luminescent dye@MOFs systems are excellent fluorescence probe candidates for the selective detection of pesticides.

Effects of mineral oil spray additives on the distribution and dissipation kinetics of pyraclostrobin and azoxystrobin in banana leaves, fruits, and soil

Using LC-MS/MS, a rapid and sensitive method for the simultaneous determination of pyraclostrobin and azoxystrobin residues in banana matrices (leaf and whole banana) and soil was established. The samples were extracted using acetonitrile and purified through C₁₈ dispersive solid-phase extraction. The average recovery of the analytes in various matrices was in the range of 77.3%-103.9% with an RSD range of 0.9%-9.5%. The initial deposition amounts of pyraclostrobin and azoxystrobin at 2 h in the banana leaves of the mineral oil group were 1.43 and 1.31 times in Guangxi, and 2.10 and 1.81 times in Hainan for the water group, whereas those in the soil of the water group were 3.45 and 3.03 times in Guangxi, and 2.14 and 3.48 times in Hainan for the mineral oil group. The half-lives in the leaves and soil of the mineral oil group were not remarkably different from those of the water group. The terminal residue of the analytes on the whole banana was <0.02 mg/kg at 14 days after application from the two sites. The results of this work may indicate and promote the safety of using pyraclostrobin and azoxystrobin in banana production, especially with mineral oil spray adjuvants.