Intraoperative Assessment of Reduction of the Ankle Syndesmosis

Comparison of ultrasonographic evaluation methods for ankle syndesmosis in non-weight bearing and weight bearing conditions

BACKGROUND

This study aimed to investigate ankle syndesmosis in healthy subjects under non-weight bearing (NWB) and weight bearing (WB) conditions using two US methods.

METHODS

The anterior tibiofibular clear space (ATFCS) was measured in healthy subjects in NWB and WB conditions using two US procedures. Method 1 measured 10 mm above the ankle joint and Method 2 measured 30° from the line of 10 mm above the ankle joint.

RESULTS

A total of 60 ankles from 30 subjects (male/female, 15/15) were included. There was a significant difference in the ATFCS between the two US methods (p < 0.001), and Method 2 was better at detecting the change in diastasis from NWB to WB conditions. The ATFCS was significantly greater on WB than on NWB, irrespective of the US method.

CONCLUSIONS

Method 2 was better at detecting diastasis of the syndesmosis from NWB to WB conditions. The influence of WB needs to be considered when evaluating syndesmosis using US.

LEVEL OF EVIDENCE

Cross-sectional cohort study; Level of evidence, Ⅳ.

Image Rotation Alters Apparent Fibula Length: An Evaluation of Talocrural Angle, Shenton Line, and Dime Sign

BACKGROUND

Fibula shortening can compromise ankle stability and force transmission, thereby impacting clinical outcomes. Because radiographs depict 3-dimensional anatomy in 2 dimensions, accurate radiographic assessment of fibula length is a commonly encountered clinical challenge. The talocrural angle (TCA), Shenton line, and dime sign are useful parameters of fibula length. Yet, the impact of 3-dimensional limb positioning on these radiographic parameters is not established.

METHODS

Bone models were constructed from CT scans of 30 lower limbs. Fibula length was computationally manipulated, and digitally reconstructed radiographs were generated reflecting 1-degree increments of sagittal and axial plane rotation of each limb for each fibula length condition. The TCA was computationally measured on each image. The presence of an aligned mortise view, intact Shenton line, and intact dime sign was assessed by 2 observers.

RESULTS

The mean TCA, which was 78.0 (95% CI ± 1.6) degrees for a true mortise projection with anatomic fibula length, changed by approximately 1 degree per millimeter of fibula length change. On average, 14.7 degrees of caudal rotation obscured 2 mm of fibular shortening by virtue of producing the same TCA as a true mortise view with anatomic fibula length, designated a false positive view. Axial rotation had a comparatively small effect. Observers 1 and 2 were, respectively, 91% and 88% less likely to accurately judge the image alignment of the false positive images compared to true mortise images. Moreover, intraobserver agreement was poor to moderate (mean 0.47, range 0.13-0.59) and interobserver agreement was uniformly poor (mean 0.08, range 0.01-0.20).

CONCLUSION

In our study using digitally reconstructed radiographs from CT scans of 30 limbs, we found that sagittal plane rotation impacts the radiographic appearance of fibula length as measured by the TCA. Limb axial rotation had a comparatively small effect. Further study of human perception of Shenton line and dime sign is needed before the effect of rotation on these parameters can be fully understood.

LEVEL OF EVIDENCE

Level IV, case series.

The Center-Center Image Closely Approximates Other Methods for Syndesmosis Reduction Clamp Placement

BACKGROUND

The optimal placement for a syndesmosis reduction clamp remains an open question. This study compared the center-center axis, which localizes clamp placement using only an internally rotated lateral ankle X-ray, with other common approaches, whose accuracy can only be confirmed using computed tomography (CT).

METHODS

Bone models of anatomically aligned (n = 6) and malreduced (n = 48) limbs were generated from CT scans of cadaveric specimens. Four axes for guiding clamp placement (center-center, centroid, B2, and trans-syndesmotic) were then analyzed, using digitally reconstructed radiographs derived from the bone models. Each axis' location was defined using angle-height pairs that describe axis orientation along the full anatomical region where syndesmosis fixation occurs.

RESULTS

In anatomically aligned limbs, the center-center axis was located on average (±95% CI [confidence interval]), 0.64° (±0.50°) internal rotation, 1.03° (±0.73°) internal rotation, and 2.09° (±7.29°) external rotation from the centroid, B2, and trans-syndesmotic axes, respectively. Fibular displacement altered the magnitude of limb rotation needed to identify the center-center axis.

CONCLUSION

The center-center technique is a valid method that closely approximates previously described methods for syndesmosis clamp placement without using CT, and the magnitude of C-arm rotation needed to transition from a talar dome lateral to a center-center view may be a potential method for assessing syndesmosis reduction.

LEVELS OF EVIDENCE

Level III: Retrospective comparative study.

High-Ankle Sprain and Syndesmotic Instability: How Far Have We Come with Diagnosis and Treatment?

Probably one of the most controversial subjects in the orthopedic field is the distal tibiofibular articulation. Even though its most primary knowledge can be a matter of enormous debate, it is in the diagnosis and treatment most of the disagreements reign. Distinguishing between injury and instability remains challenging as well as an optimal clinical decision regarding surgical intervention. The last years presented technology and that was able to bring body to an already well-developed scientifical rationale. In this review article, we aim to demonstrate the current data behind syndesmotic instability in the ligament scenario, whereas using few fracture concepts.