Accurate and robust systolic myocardial T1 mapping using saturation recovery with individualized delay time: comparison with diastolic T1 mapping

High resolution single-shot myocardial imaging using bSSFP with wave encoding

BACKGROUND

Single-shot balanced steady-state free precession (bSSFP) sequence is widely used in cardiac imaging. However, the limited scan time in one heartbeat greatly hinders its spatial resolution compared to the segmented acquisition mode. Therefore, a highly accelerated single-shot bSSFP imaging technology is needed for clinical use.

PURPOSE

To develop and evaluate a wave-encoded bSSFP sequence with high acceleration rates for single-shot myocardial imaging.

METHODS

The proposed Wave-bSSFP method is implemented by adding a sinusoidal wave gradient in the phase encoding direction during the readout of bSSFP sequence. Uniform undersampling is used for acceleration. Its performance was first validated via phantom studies by comparison with conventional bSSFP. Then it was evaluated in volunteer studies via anatomical imaging, T2 -prepared bSSFP, and T1 mapping in in-vivo cardiac imaging. All methods were compared with accelerated conventional bSSFP reconstructed using iterative SENSE and compressed sensing (CS), to demonstrate the advantage of wave encoding in suppressing the noise amplification and artifacts induced by acceleration.

RESULTS

The proposed Wave-bSSFP method achieved a high acceleration factor of 4 for single-shot acquisitions. The proposed method showed lower average g-factors than bSSFP, and fewer blurring artifacts than CS reconstruction. The Wave-bSSFP with R = 4 achieved higher spatial and temporal resolutions compared with the conventional bSSFP with R = 2 in several applications such as T2 -prepared bSSFP and T1 mapping, and could be applied in systolic imaging.

CONCLUSION

Wave encoding can be used to highly accelerate 2D bSSFP imaging with single-shot acquisitions. Compared with the conventional bSSFP sequence, the proposed Wave-bSSFP method can effectively reduce the g-factor and aliasing artifacts in cardiac imaging.

Systolic modified Look-Locker inversion recovery myocardial T1 mapping improves the accuracy of T1 and extracellular volume fraction measurements of patients with high heart rate or atrial fibrillation

Image data for T1 mapping are generally acquired during mid-diastole period. However, T1 mapping tends to fail for patients with high heart rate or atrial fibrillation because of short or irregular R-R interval. Focusing on the evidence that the timing of systole is more stable than that of diastole from the R wave, we compared systolic T1 mapping with conventional diastolic T1 mapping for all participants (n = 58) by visual scoring of T1 calculation error. The systolic scores were significantly better than the diastolic scores (p < 0.05). This advantage of the systolic scores was confirmed selectively for patients with atrial fibrillation (p < 0.05, n = 19). The successful number of nonrigid image registration alignment for extracellular volume fraction (ECV) analysis also increased significantly for systolic images compared with diastolic images (p < 0.05). Thus, systolic T1 mapping improves the accuracy of T1 values and ECV analysis.