Facile synthesis and properties of chromium-doped cobalt oxide (Cr-doped Co3O4) nanostructures for supercapacitor applications

Engineering of Co3O4 electrode via Ni and Cu-doping for supercapacitor application

Although cobalt oxides show great promise as supercapacitor electrode materials, their slow kinetics and low conductivity make them unsuitable for widespread application. We developed Ni and Cu-doped Co3O4 nanoparticles (NPs) via a simple chemical co-precipitation method without the aid of a surfactant. The samples were analyzed for their composition, function group, band gap, structure/morphology, thermal property, surface area and electrochemical property using X-ray diffraction (XRD), ICP-OES, Fourier transform infrared (FTIR) spectroscopy, Ultraviolet-visible (UV-Vis), Scanning electron microscopy (SEM), Thermogravimetric analysis (TGA) and/or Differential thermal analysis (DTA), Brunauer-Emmett-Teller (BET), and Impedance Spectroscopy (EIS), Cyclic voltammetry (CV), respectively. Notably, for the prepared sample, the addition of Cu to Co3O4 NPs results in a 11.5-fold increase in specific surface area (573.78 m2 g-1) and a decrease in charge transfer resistance. As a result, the Ni doped Co3O4 electrode exhibits a high specific capacitance of 749 F g-1, 1.75 times greater than the pristine Co3O4 electrode's 426 F g-1. The electrode's enhanced surface area and electronic conductivity are credited with the significant improvement in electrochemical performance. The produced Ni doped Co3O4 electrode has the potential to be employed in supercapacitor systems, as the obtained findings amply demonstrated.

Enhancing pseudocapacitive properties of cobalt oxide hierarchical nanostructures via iron doping

Through co-precipitation and post-heat processing, nanostructured Fe-doped Co₃O₄ nanoparticles (NPs) were developed. Using the SEM, XRD, BET, FTIR, TGA/DTA, UV-Vis, and techniques were examined. The XRD analysis presented that Co₃O₄ and Co₃O₄ nanoparticles that had been doped with 0.25 M Fe formed single cubic phase Co₃O₄ NPs with average crystallite sizes of 19.37 nm and 14.09 nm, respectively. The as prepared NPs have porous architectures via SEM analyses. The BET surface areas of Co₃O₄ and 0.25 M Fe-doped Co₃O₄ NPs were 53.06 m²/g and 351.56 m²/g, respectively. Co₃O₄ NPs have a band gap energy of 2.96 eV and an extra sub-band gap energy of 1.95 eV. Fe-doped Co₃O₄ NPs were also found to have band gap energies between 2.54 and 1.46 eV. FTIR spectroscopy was used to determine whether M-O bonds (M = Co, Fe) were present. The doping impact of iron results in the doped Co₃O₄ samples having better thermal characteristics. The highest specific capacitance was achieved using 0.25 M Fe-doped Co₃O₄ NPs at 5 mV/s, which corresponding to 588.5 F/g via CV analysis. Additionally, 0.25 M Fe-doped Co₃O₄ NPs had energy and power densities of 9.17 W h/kg and 472.1 W/kg, correspondingly.

Electrical conductivity and electrochemical studies of Cr-doped MoO3 nanoflakes for energy storage applications

The growing demand for electricity has increased the interest of the researchers towards exploration of energy storing devices (ESDs). With the motif for developing electrochemical energy storage devices, this research work is focussed on the study of MoO₃ nanoparticles and its doping with chromium as an efficient electrode material for energy storage applications. The nanoparticles were synthesized by hydrothermal method and were examined by powder X-ray diffraction, which determined the thermodynamically stable orthorhombic phase of MoO₃, and their morphologies were examined using scanning electron microscopy displaying flake-like structures. The typical vibrational bands of Mo-O were identified from Infra-red and Raman spectral analysis. The ultra violet diffuse reflectance spectra revealed the decrease in optical band gap after doping with chromium. The temperature dependent AC and DC conductivities were enhanced on doping. Electrochemical behaviour of the nanoparticles was probed by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) measurements and galvanostatic charge-discharge (GCD) analysis for which specific capacitance (C _sp) value of 334 Fg^-1 was achieved for Cr-doped MoO₃ nanoparticles. The electrochemical performance of the sample was found to be increased after doping with Cr.

Photocatalytic Performance of Organically Templated Cr-Doped Co3O4 in Remediation of Industrial Wastewater: Effect of Order–Disorder in the Lattice

In photocatalysis, the optical properties and surface parameters significantly affect the catalytic performance. To engineer the optical properties and textural structure, Cr and p-phenylene diamine (PDA) were utilized as dopant and textural structure regulator, respectively. A series of Cr-doped Co3O4 with dopant percentages of 0, 1, 3, and 5, templated PDA at a fixed ratio of 5%, and another un-templated sample with a dopant ratio of 5% were prepared. The co-precipitation method was applied in swift and innovative procedures, where a calculated amount of NaOH was used as a precipitant. The optical properties, dopant concentration quenching, and surface parameters are strongly affected by the order–disorder in the lattice and dopant concentration. The lattice regularity affects the optical properties and the surface parameters along with the dopant concentration. The photocatalysts were evaluated in the disposal of organic pollutants in a representative sample of wastewater collected from different industrial activities. The function of another function was applied to monitor the pollutants' disposal, taking the total organic carbon (TOC) as a function of the pollutants' concentration and the photometric absorbance as a function of the TOC. The kinetic investigation exhibited the significant role of the pore system on the reaction rate.

Efficient Recovery Annealing of the Pseudocapacitive Electrode with a High Loading of Cobalt Oxide Nanoparticles for Hybrid Supercapacitor Applications

Electrochemical pseudocapacitors, along with batteries, are the essential components of today's highly efficient energy storage systems. Cobalt oxide is widely developing for hybrid supercapacitor pseudocapacitance electrode applications due to its wide range of redox reactions, high theoretical capacitance, low cost, and presence of electrical conductivity. In this work, a recovery annealing approach is proposed to modify the electrochemical properties of Co₃O₄ pseudocapacitive electrodes. Cyclic voltammetry measurements indicate a predominance of surface-controlled redox reactions as a result of recovery annealing. X-ray diffraction, Raman spectra, and XPES results showed that due to the small size of cobalt oxide particles, low-temperature recovery causes the transformation of the Co₃O₄ nanocrystalline phase into the CoO phase. For the same reason, a rapid reverse transformation of CoO into Co₃O₄ occurs during in situ oxidation. This recrystallization enhances the electrochemical activity of the surface of nanoparticles, where a high concentration of oxygen vacancies is observed in the resulting Co₃O₄ phase. Thus, a simple method of modifying nanocrystalline Co₃O₄ electrodes provides much-improved pseudocapacitance characteristics.

Synthesis of novel Co3O4 nanocubes-NiO octahedral hybrids for electrochemical energy storage supercapacitors

Fabrication of novel metal oxide nanostructured composites is a proficient approach to develop efficient energy storage devices and development of cost-free and eco-friendly metal oxide nanostructures for supercapacitor applications received considerable attention in recent years. The Co₃O₄ nanocubes-NiO octahedral structured composite was constructed using facile and one-step calcination process. Cyclic voltammetry, charge-discharge, and electrochemical impedance spectral techniques have been employed to analyze the specific capacitance of the synthesized nanostructures and the composites. Specific capacitance and cycling stability of the composites were evaluated with the pristine Co₃O₄ and NiO nanostructures. The composite showed a specific capacitance of 832 F g^-1 at a current density of 0.25 A g^-1, which was ~1.5 and ~1.9-times higher than pristine Co₃O₄ nanocubes and NiO octahedral structure, respectively. On the other hand, electrode showed approximately 50 % capacity retention at a higher current density (5 Ag^-1) because of the uniform morphology of Co₃O₄ and NiO. The charge-discharge stability measurements of the composite showed an admirable specific capacitance retention capability, which was 94.5 % after 2000 continuous charge-discharge cycles at a current density of 5 A g^-1. The superior electrochemical performance of the nano-composite was ascribed to synergistic effects and uniform morphology. Efficient nanostructure development using facile and one-step calcination process and electrochemical performance make the synthesized composite a promising device for supercapacitor applications.