Preparation and characterization of water-soluble microcapsule for sustained drug release using Eudragit RS 100

Preparation of an oil suspension containing ondansetron hydrochloride as a sustained release parenteral formulation

Ondansetron hydrochloride (ODS) is a selective 5-hydroxytryptamine type 3 antagonist for nausea and emesis prevention in neoplastic patients. To reduce dosing frequency and side effects and improve patient compliance, a sustained release parenteral formulation of ODS was developed. Microparticles of methylcellulose (MC) and ODS were prepared using the spray-drying method and suspended in oils to form oil suspensions. The formulations were evaluated for residual moisture, drug content, size distribution, DSC, XRD, FTIR, SEM, drug release, and pharmacokinetic studies. The effects of polymers and oils on the drug release were evaluated. MC showed the most prominent sustained release effect among various polymers examined with the optimum MC/ODS ratio of 2:1 (w/w). The particle size of the produced microparticles was in the mean diameter of approximately 3 μm. Physicochemical characterization suggested that ODS existed in an amorphous matrix within the microparticles and interacted with MC via hydrogen bonds. Corn oil was selected as the appropriate oil for suspension due to the sustained release of ODS and the appropriate viscosity. The optimized sustained release formulation of ODS was the corn oil suspension of spray-dried microparticles containing MC and ODS (2:1, w/w). It showed an in vitro drug sustained release up to 120 h, while the oil suspension of ODS without any polymer released the drug within 2 h. Following subcutaneous administration in rats, the optimized formulation could prolong the drug release until 72 h with the enhanced bioavailability in comparison with the ODS solution. The oil suspension of spray-dried microparticles might be an efficient approach for prolongation of the drug effect in the management of nausea and emesis. Graphical abstract.

Development of Eudragit RS 100 Microparticles Loaded with Ropinirole: Optimization and In Vitro Evaluation Studies

The current study aimed to develop novel pH independent microparticles loaded with ropinirole (ROP) for sustained drug release. Eudragit RS 100 was used as release retardant and microparticles were fabricated by oil-in-oil emulsion solvent evaporation method. A three-factor three-level Box-Behnken design using Design-Expert software was employed to optimize formulation variables. Ropinirole loaded microparticles were evaluated with respect to morphology, particle size, encapsulation efficiency, and in vitro release profile. Optical microscopy and SEM micrographs indicated spherical shape with smooth surface and well-defined boundary. The particle size was in the range of 98.86 to 236.29 μm, being significantly increased with increasing polymer concentration. Higher polymer load also increased the thickness of internal polymer network, which led to reduced drug loss and higher entrapment efficiency (89%). The cumulative in vitro release was found to be in the range of 54.96 to 99.36% during the release studies (12 h) following zero order release kinetics and non-Fickian diffusion pattern. The developed microparticles have the potential to sustain the release of ropinirole, which may lead to a reduction in its adverse effects and improved management of Parkinson's disease.