Synthesis of novel poly(N,N-diethylacrylamide-co-acrylic acid) (P(DEA-co-AA)) microgels as carrier of horseradish peroxidase immobilization for pollution treatment

Synthesis of cross-linked poly(acrylic acid) nanogels in an aqueous environment using precipitation polymerization: unusually high volume change

For the first time, by using precipitation polymerization in an aqueous solution, a cross-linked poly(acrylic acid)-(pAA) nanogel was synthesized. pAA was synthesized and cross-linked with N,N'-methylenebisacrylamide (BIS) at 70°C in an acidified environment (pH 2) and containing 0.7 M NaCl using potassium persulfate as the initiator. Ionized pAA was soluble in water. The use of sodium chloride at low pH caused a decrease in the solubility of pAA and led to its precipitation and formation of cross-linked pAA nanogel. By using electron microscopies and light scattering techniques, the morphology, pH sensitivity and zeta potential of the obtained p(AA-BIS) nanogel were evaluated. The polymerization in an aqueous environment resulted in a very big swelling/shrinking coefficient (of approx. 4000) in response to pH and exhibited an unusually high negative zeta potential (of approx. -130 mV). These properties make the nanogel a very interesting sorbent and a construction material.

Self-assembly and the hemolysis effect of monodisperse N,N-diethylacrylamide/acrylic acid nanogels with high contents of acrylic acid

Monodisperse temperature/pH sensitive poly(N,N-diethylacrylamide/acrylic acid) (P(DEA/AAc)) nanogels with high contents of AAc up to 40 wt% have been prepared. In this study, it was unexpectedly found that the polydispersity of the nanogels with 40 wt% AAc strongly depended on the initiator concentration. Monodisperse P(DEA/AA) nanogels were synthesized only at a very low concentration of initiator. The phase transition behavior of the nanogels in water can be tuned by pH and temperature. Due to low polydispersity, the nanogels self-assembled into colloidal crystals at different temperatures below the volume phase transition temperature (VPTT). The sharp Bragg peaks of the crystals were significantly blue-shifted as the concentration of the nanogels was increased. In contrast, the condensed suspensions without crystals still exhibited clear colours resulting from a short-range order structure. The reflection spectra of the coloured suspensions showed that the peak wavelength became a bit longer and much broader. And the reflection intensity of the coloured suspensions was much weaker. Elastic and coloured crosslinked nanogel networks prepared by a one-pot and rapid light-initiated crosslinking method showed responses to pH and temperature. Furthermore, the interaction between the nanogels and peptide melittin was investigated. The results showed that an increasing AAc composition led to more efficient inhibition of the hemolytic activity of melittin. The nanogels with 40 wt% AAc composition completely inhibited hemolytic activity at a nanogel concentration of 400 µg ml(-1). Thus, monodisperse P(DEA/AAc) nanogels of high AAc composition may be developed as efficient substitutes for antibody-based antidotes. Owing to the combined influence of the periodic structure of the crystals of the nanogels and an efficient neutralization effect, the P(DEA/AAc) nanogels show promise to become an integral step for preparing valuable naked-eye biosensors as simple, cheap and stable substitutes for antibody-based antidotes.

Immobilization of horseradish peroxidase on electrospun microfibrous membranes for biodegradation and adsorption of bisphenol A

Horseradish peroxidase (HRP) from roots of horseradish (Amoracia rusticana) was successfully immobilized on novel enzyme carriers, poly(methyl methacrylate-co-ethyl acrylate) (PMMA CEA) microfibrous membranes, and used for removal of bisphenol A from water. PMMA CEA fibrous membranes (PFM) with fiber diameters of 300-500 nm, were fabricated by electrospinning. HRP was covalently immobilized on the surface of microfibers previously activated by polyethylenimine and glutaraldehyde. HRP loading reached 285 mg/g, and enzyme activity was 70% of free HRP after immobilization. Both stabilities and reusability of HRP were greatly improved after immobilization. After six repeated runs, immobilized HRP retained about 50% of its initial activity. Immobilized HRP exhibited significantly higher removal efficiency for bisphenol A (BPA) in 3h (93%) compared with free HRP (61%) and PFM alone (42%). The high BPA removal can be resulted by improvement of catalytic activity of immobilized HPR with adsorption on modified PMMA CEA support.

Immobilization of horseradish peroxidase by electrospun fibrous membranes for adsorption and degradation of pentachlorophenol in water

Horseradish peroxidase (HRP) is successfully in situ encapsulated into the poly(D,L-lactide-co-glycolide) (PLGA)/PEO-PPO-PEO (F108) electrospun fibrous membranes (EFMs) by emulsion electrospinning. The adsorption and degradation of pentachlorophenol (PCP) by HRP-EFMs are investigated. The experimental results show that the sorption kinetic of PCP on EFMs follows the pseudo-second-order model, and the sorption capacity is as high as 44.69 mg g(-1). The sorption mechanisms of EFMs for PCP can be explained by hydrogen bonding interactions, hydrophobic interactions and π-π bonding interactions. Profiting from the strong adsorption, the removal of PCP can be dramatically enhanced by the interaction of adsorbed PCP and HRP on the surface of EFMs. For PCP degradation, the optimal pH values for free HRP and immobilized HRP are 4 and 2-4, respectively. As pH>4.7, no adsorption and degradation are observed due to the deprotonation of PCP. The removal percentages reach 83% and 47% for immobilized HRP and free HRP, respectively, at 25 ± 1°C. The presence of humic acid can inhibit the activity of HRP and decreases the adsorption capacity of PCP because of competitive adsorption. The operational and storage stability of immobilized HRP are highly improved through emulsion electrospinning.