Catalytic ozonation process using CuO/clinoptilolite zeolite for the removal of formaldehyde from the air stream

Construction of BiOCl/Clinoptilolite Composite Photocatalyst for Boosting Formaldehyde Removal

Binary composite was synthesized via coupling BiOCl with alkali leached natural clinoptilolite (40B0/CN), which showed retarded recombination of photo-generated carriers. The clinoptilolite was pretreated with alkali leaching, resulting in a larger pore size and high cation exchange capacity. The modified clinoptilolite was more feasible for the growth of BiOCl and to promote the adsorption ability for formaldehyde (HCHO). In addition, the cation exchange capacity was conducive to anchor Bi³⁺, further leading to the reduction of the particle size of BiOCl. The carrier effect of alkali leached natural clinoptilolite promoted the amorphous transformation of BiOCl at low temperature, which simultaneously produced more distortions and defects in the BiOCl lattice. The 40B0/CN composite exhibited the superior light absorption ability with a narrower band gap. The photocatalytic degradation rate for HCHO of 40B0/CN under solar light reached 87.7%, and the reaction rate constant was 0.0166 min⁻¹, which was 1.6 times higher than that of BiOCl. This paper gave a deep insight into photocatalytic technology to efficiently degrade formaldehyde.

Synthesis and characterization of Fe2O3 doped ZnO supported on clinoptilolite for photocatalytic degradation of metronidazole

ZnO/Fe₂O₃/Clinoptilolite photocatalyst was synthesized through sol-gel method. The photocatalyst was characterized by XRD, XRF, EDX, FE-SEM, FT-IR, BET and UV-VIS DRS analyses. According to the XRD, FT-IR, and EDX results, the presence of ZnO and Fe₂O₃ was confirmed on the clinoptilolite surface. Based on the XRF results, the molar ratio of Fe³⁺/ZnO in the photocatalyst was obtained as 0.06. The FE-SEM results confirmed stabilization of ZnO/Fe₂O₃ on the clinoptilolite surface. Based on the BET results, the surface area and pore volume for the photocatalyst were obtained as 291.35 m²/g and 0.23 cm³/g, respectively. According to the UV-VIS DRS results, the band gap energy of the photocatalyst was measured as 3.38 eV. The performance of the synthesized photocatalyst in degrading metronidazole from contaminated water, as one of the most widely used antibiotics in pharmaceutical industries, was evaluated by response surface methodology. Operational factors including pH (4-10), metronidazole concentration (1-100 mg/l), irradiation time (45-180 min), photocatalyst concentration (0.5-2 g/l), and H₂O₂ concentration (25-100 mg/l) were investigated. The optimal values of the factors in degrading 99% of the contaminant were as follows: irradiation time = 90 min, photocatalyst concentration = 1 g/l, pH = 10, H₂O₂ concentration = 40 mg/l, and MNZ concentration = 60 mg/l.

Indoor formaldehyde removal by three species of Chlorophytum comosum under dynamic fumigation system: part 2-plant recovery

Spider plants (Chlorophytum comosum) are known to be among the most common easy mountable indoor plants capable of purifying indoor air by absorbing carbon monoxide, formaldehyde, xylene, and many other hazardous gases. In addition, these plants are non-toxic and safe for pets and children. This project is focused on the investigation of the spider plants' capability of the formaldehyde purification under laboratory-controlled parameters of the indoor air environment. Two scenarios including employment of fresh plants as well as recovered ones damaged by 7-day exposure of formaldehyde were considered. A special attention was made to the investigation of physiological indexes of the plant leaves after damage, and whether the spider plant could be reused after its recovery. The physiological characteristics of the recovery period of potted Chlorophytum comosum immediately after 7 days of fumigation with formaldehyde were studied. Eight physiological indexes of leaves including chlorophyll, free protein, relative conductivity, MDA (malondialdehyde, lipid peroxidation), SOD (superoxide dismutase), POD (peroxidase), T-AOC (total antioxidant capacity), and stomata were selected to monitor plants' recovery processes. The results of 30-day experimental runs showed that three species of spider plants were mostly recovered within 15 days. Repeated 7-day fumigation of plants, conducted to study their ability to effectively clean the air after regeneration, confirmed such ability; the efficiency at the first day was similar to the performance of the fresh plant. However, from the second day, the efficiency was dropped by 35-50% and remained at these levels for the rest of the exercise.

Hazardous wastes treatment technologies

A review of the literature published in 2019 on topics related to hazardous waste management in water, soils, sediments, and air. The review covered treatment technologies applying physical, chemical, and biological principles for the remediation of contaminated water, soils, sediments, and air. PRACTICAL POINTS: This report provides a review of technologies for the management of waters, wastewaters, air, sediments, and soils contaminated by various hazardous chemicals including inorganic (e.g., oxyanions, salts, and heavy metals), organic (e.g., halogenated, pharmaceuticals and personal care products, pesticides, and persistent organic chemicals) in three scientific areas of physical, chemical, and biological methods. Physical methods for the management of hazardous wastes including general adsorption, sand filtration, coagulation/flocculation, electrodialysis, electrokinetics, electro-sorption ( capacitive deionization, CDI), membrane (RO, NF, MF), photocatalysis, photoelectrochemical oxidation, sonochemical, non-thermal plasma, supercritical fluid, electrochemical oxidation, and electrochemical reduction processes were reviewed. Chemical methods including ozone-based, hydrogen peroxide-based, potassium permanganate processes, and Fenton and Fenton-like process were reviewed. Biological methods such as aerobic, anoxic, anaerobic, bioreactors, constructed wetlands, soil bioremediation and biofilter processes for the management of hazardous wastes, in mode of consortium and pure culture were reviewed. Case histories were reviewed in four areas including contaminated sediments, contaminated soils, mixed industrial solid wastes and radioactive wastes.