Sustained-release diclofenac potassium orally disintegrating tablet incorporating eudragit ERL/ERS: possibility of specific diclofenac-polymer interaction

Development and optimization of sustained release triptolide microspheres

Rheumatoid arthritis is considered a chronic systemic autoimmune disorder that may cause joint destruction. Triptolide, an active component isolated from Tripterygium wilfordii Hook.f., is considered to have promising potential for clinical use in treating rheumatoid arthritis. However, its clinical application has been limited by the narrow therapeutic window, side effects associated with plasma drug fluctuations, low oral bioavailability, and poor patient compliance with the long and frequent dosing regimen. An extended drug release preparation may address these limitations. The aim of this work was therefore to develop, formulate and optimize sustained release triptolide microspheres with poly (lactide-co-glycolide) (PLGA). Triptolide-loaded microspheres were prepared using PLGA as the matrix polymer, dichloromethane as the oil phase, and polyvinyl alcohol (PVA) as the matrix forming emulsifier. An oil-in-water (O/W) emulsion solvent evaporation technique was utilized to prepare the microspheres. Surface response methodology (RSM) coupled with central composite design (CCD) was used to optimize the formulation and a total of twenty formulations were prepared. PVA concentration (X1), PLGA concentration (X2), and theoretical drug content (X3) were selected as independent variables; and drug content (Y1), encapsulation efficiency (Y2), mean diameter (Y3) and the initial release during the first day (Y4) were taken as the response variables. The optimized formulation showed mean diameter of 42.36 μm, drug content of 7.96%, encapsulation efficiency of 80.16% and an initial release of 14.48%. The prepared microspheres exhibited a sustained release profile of triptolide in vitro over 4 weeks, which was wellfitted with a Korsmeyer-Peppas equation. However, the initial drug release (~14%) of triptolide-loaded microspheres was very high and should be specifically investigated in future studies. The results indicate that long-term sustained release microspheres of triptolide can be considered a strategy to overcome the low bioavailability and poor patient compliance with conventional triptolide tablets. The issue of initial burst release and in vivo evaluations should be specifically investigated in the future.

In Vitro and In Vivo Evaluations of PLGA Microspheres Containing Nalmefene

Poor patient compliance, untoward reactions and unstable blood drug levels after the bolus administration are impeding the pharmacotherapy for insobriety. A long-acting preparation may address these limitations. The aim of this paper was to further investigate the in vitro characteristics and in vivo performances of nalmefene microspheres. Nalmefene was blended with poly (lactide-co-glycolide) (PLGA) to prepare the target microspheres by an O/O emulsification solvent evaporation method. The prepared microspheres exhibited a controlled release profile of nalmefene in vitro over 4 weeks, which was well fitted with a first-order model. In vitro degradation study showed that the drug release in vitro was dominated by both drug diffusion and polymer degradation mechanisms. Pharmacokinetics study indicated that the prepared microspheres could provide a relatively constant of nalmefene plasma concentration for at least one month in rats. The in vivo pharmacokinetics profile was well correlated with the in vitro drug release. Pharmacodynamics studies revealed that the drug loaded microspheres could produce a long-acting antagonism efficacy on rats. These results demonstrated the promising application of injectable PLGA microspheres containing nalmefene for the long-term treatment of alcohol dependence.

Controlled release of dutasteride from biodegradable microspheres: in vitro and in vivo studies

The aim of the present work was to study the in vitro/in vivo characteristics of dutasteride loaded biodegradable microspheres designed for sustained release of dutasteride over four weeks. An O/W emulsion-solvent evaporation method was used to incorporate dutasteride, which is of interest in the treatment of benign prostatic hyperplasia (BPH), into poly(lactide-co-glycolide) (PLGA). A response surface method (RSM) with central composite design (CCD) was employed to optimize the formulation variables. A prolonged in vitro drug release profile was observed, with a complete release of the entrapped drug within 28 days. The pharmacokinetics study showed sustained plasma drug concentration-time profile of dutasteride loaded microspheres after subcutaneous injection into rats. The in vitro drug release in rats correlated well with the in vivo pharmacokinetics profile. The pharmacodynamics evaluated by determination of the BPH inhibition in the rat models also showed a prolonged pharmacological response. These results suggest the potential use of dutasteride loaded biodegradable microspheres for the management of BPH over long periods.