Piezoelectric Nanogenerator Based on Electrospun Cellulose Acetate/Nanocellulose Crystal Composite Membranes for Energy Harvesting Application

Nanocellulose-based nanogenerators for sensor applications: A review

With the rapid development of the Internet of Things, nanogenerator as a green energy collection technology has attracted great attention in various fields. Specifically, the natural renewable nanocellulose as a raw material can significantly improve the environmental friendliness of the nanocellulose-based nanogenerators, which also makes the nanocellulose based nanogenerators expected to further develop in areas such as wearable devices and sensor networks. This paper mainly reports the application of nanocellulose in nanogenerator, focusing on the sensor. The types, sources and preparation methods of nanocellulose are briefly introduced. At the same time, the special structure of nanocellulose highlights the advantages of nanocellulose in nanogenerators. Then, the application of nanocellulose-based nanogenerators in sensors is introduced. Finally, the future development prospects and shortcomings of this nanogenerator are discussed.

Piezoelectric Nanogenerator Based on Electrospinning PVDF/Cellulose Acetate Composite Membranes for Energy Harvesting

The organic piezoelectric polymer polyvinylidene fluoride (PVDF) has attracted extensive research because of its excellent flexibility and mechanical energy-harvesting properties. Here, the electrospinning technique was taken to fabricate synthesized fiber membranes of a PVDF/cellulose acetate (CA) composite. The obtained PVDF/CA electrospun fiber membranes (EFMs) were employed to prepare a flexible nanogenerator. XRD and FTIR spectroscopy revealed the enhancement of piezoelectric behavior due to an increase in β-phase in PVDF/CA EFMs compared with cast films. The PVDF/CA fibers (mass ratio of PVDF to CA = 9:1) showed an output voltage of 7.5 V and a short-circuit current of 2.1 μA under mechanical stress of 2 N and frequency of 1 Hz, which were 2.5 and two times greater than those of the pure PVDF fibers, respectively. By charging a 4.7 µF capacitor for 15 min with the voltage generated by the PVDF/CA EFMs, nine LED lamps could be lit. The work provides an effective approach to enhancing the piezoelectric effects of PVDF for low-power electronic loading of macromolecule polymers.