Physicochemical studies of microbial cell walls. I. Comparative electrophoretic behavior of intact cells and isolated cell walls

The bio-physics of condensation of divalent cations into the bacterial wall has implications for growth of Gram-positive bacteria

BACKGROUND

The anionic-polyelectrolyte nature of the wall of Gram-positive bacteria has long been suspected to be involved in homeostasis of essential cations and bacterial growth. A better understanding of the coupling between the biophysics and the biology of the wall is essential to understand some key features at play in ion-homeostasis in this living system.

METHODS

We consider the wall as a polyelectrolyte gel and balance the long-range electrostatic repulsion within this structure against the penalty entropy required to condense cations around wall polyelectrolytes. The resulting equations define how cations interact physically with the wall and the characteristic time required for a cation to leave the wall and enter into the bacterium to enable its usage for bacterial metabolism and growth.

RESULTS

The model was challenged against experimental data regarding growth of Gram-positive bacteria in the presence of varying concentration of divalent ions. The model explains qualitatively and quantitatively how divalent cations interact with the wall as well as how the biophysical properties of the wall impact on bacterial growth (in particular the initiation of bacterial growth).

CONCLUSION

The interplay between polymer biophysics and the biology of Gram positive bacteria is defined for the first time as a new set of variables that contribute to the kinetics of bacterial growth.

GENERAL SIGNIFICANCE

Providing an understanding of how bacteria capture essential metal cations in way that does not follow usual binding laws has implications when considering the control of such organisms and their ability to survive and grow in extreme environments.

Zeta potential as a diagnostic tool to evaluate the biomass electrostatic adhesion during ion-exchange expanded bed application

Expanded bed adsorption is an integrative technology in downstream processing allowing the direct capture of target proteins from biomass (cells or cell debris) containing feedstocks. Potential adhesion of biomass on the surface of adsorbent, however, may hamper the application of this technique. Since the electrostatic forces dominate the interactions between biomass and adsorbent, the concept of zeta potential was introduced to characterize the biomass/adsorbent electrostatic interactions during expanded bed application. The criterion of zeta potential evaluation proposed in the previous paper (Biotechnol Bioeng, 83(2):149-157, 2003) was verified further with the experimental validation. The zeta potential of intact cells and homogenates of four microorganisms (Escherichia coli, Bacillus subtilis, Pichia pastoris, and S. cerevisiae) were measured under varying pH and salt concentration, and two ion-exchange adsorbents (Streamline DEAE and Streamline QXL) were investigated. The biomass transmission index (BTI) from the biomass pulse response experiments was used as the indicator of biomass adhesion in expanded bed. Combining the influences from zeta potential of adsorbent (zeta(a)), zeta potential of biomass (zeta(b)) and biomass size (d), a good relationship was established between the zeta potential parameter (-zeta(a)zeta(b)d) and BTI for all experimental conditions. The threshold value of parameter (-zeta(a)zeta(b)d) can be defined as 120 mV2 microm for BTI above 0.9. This means that the systems with (-zeta(a)zeta(b)d) < 120 show neglectable electrostatic bio-adhesion, and would have a considerable probability of forming stable expanded beds in a biomass suspension under the particular experimental conditions.

Biomass/adsorbent electrostatic interactions in expanded bed adsorption: a zeta potential study

Expanded bed adsorption is an integrated technology that allows the introduction of particle-containing feedstock without the risk of blocking the bed. The biomass particles contained in the feedstock have to be treated as an integral part of the process and potential interactions between suspended biomass and the adsorbent must be excluded during process design. Because the electrostatic forces dominate the interactions between the biomass and adsorbent, the zeta potential has been studied as a tool to characterize biomass/adsorbent electrostatic interactions. The zeta potentials of four types of biomass (yeast intact cells, yeast homogenate, Escherichia coli intact cells, and E. coli homogenate) and two types of ion exchanger were measured systematically at varying process conditions. Using the cell transmission index from biomass pulse-response experiments as a parameter, the relations between zeta potential and the biomass/adsorbent interaction were evaluated. Combining the influences from zeta potential of adsorbent (zeta(a)), zeta potential of biomass (zeta(b)), and biomass size (d), parameter (-zeta(a)zeta(b)d) was found to be an appropriate indicator of the biomass/adsorbent interactions in expanded beds under various liquid-phase conditions for different types of biomass. The threshold value of parameter (-zeta(a)zeta(b)d) can be defined as 120 mV(2) microm for cell transmission of >90%, which means that systems with (-zeta(a)zeta(b)d) < 120 may have a considerable probability of forming stable expanded beds in a biomass suspension under the particular experimental conditions.

Physical methods for characterization of microbial surfaces

There are different concepts for explaining the adsorption of microorganisms to solid surfaces: the DLVO theory and the surface free energy. Basic aspects of both theories are discussed. Established methods for determining the surface properties of microbial cells are reviewed: Electrophoretic mobility, colloid titration, electrostatic interaction chromatography, bacterial adherence to hydrocarbons, partitioning in an aqueous two-phase system, hydrophobic interaction chromatography, contact angle measurement and X-ray photoelectron spectroscopy. They are discussed and classified according to their potential for the correlation of cell surface characteristics and adsorption behavior.

The effect of mercuric salts on the electro-rotation of yeast cells and comparison with a theoretical model

The rotational spectrum of yeast cells changed after pre-treatment of the cells with HgCl2 or Hg(NO3)2 and became indistinguishable from that of ultrasonically produced cell walls. The spectrum of the affected cells contained a peak which could only be explained by attributing a conductivity to the cell walls that was higher than that of the medium. Theoretical models of the rotational response are fully in accord with the experimental spectra. It is shown that the rotation method is capable of measuring even the low cell wall conductivity of yeast cells (which was found to be 33 microS/cm at 10 microS/cm medium conductivity). Knowledge of the spectra allowed a field frequency to be selected at which untreated cells showed no rotation, but at which cells affected by treatment with Hg(II) identified themselves by rotating in the same direction as the field. Calculation of the percentage of cells showing this co-field rotation gave an index (termed the co-field rotation value) of the proportion of the cells that were affected. Using this technique, effects of 25 nmol/l Hg(II) could be demonstrated. In media of low conductivity (10 microS/cm) the change in the rotational spectrum was usually 'all-or-none', whereas at 200 microS/cm a graded Hg(II)-mediated change became apparent. The co-field rotation method showed that the action of small quantities of Hg(II) was still increasing after 3 h of incubation and paralleled the Hg(II)-induced K+ release. A rapid reduction of the effects of Hg(II) was seen when 3-30 mM K+ (or Na+) or when 1 mM Ca2+ were present in the incubation medium, or as the pH was increased. At high incubation cell concentrations the toxic effect of Hg(II) was reduced, apparently due to binding by the cells.

Electrokinetic properties of (Na+, K+)-ATPase vesicles as studied by laser Doppler spectroscopy

The technique of laser Doppler electrophoresis was applied for the study of the surface charge properties of (NA+, K+)-ATPase containing microsomal vesicles derived from guinea-pig kidney. The influence of pH, the screening and binding of uni- and divalent cations and the binding of ATP show: (1) one net negative charge per protein unit with a pK = 3.9; (2) deviation from the Debye relation between surface potential and ionic strength for univalent cations, with no difference in the effect of Na+ and K+; (3) Mg2+ binds with an association constant of Ka = 1.1. 10(2) M-1 while ATP binds with an apparent Ka = 1.1.10(4) M-1 for 1 mM NaCl, 0.2 mM KCI, 0.1 mM MgCl2, 0.1 mM Tris-HCl2, 0.1 mM Tris-HCl (pH 7.3). The binding is weaker at higher Mg2+ concentrations. There is no ATP binding in the absence of Mg2+. In addition, the average vesicle size derived from the linewidth of the quasielastic light scattering spectrum is 203.7 +/- 15.2 nm. In the presence of ATP a reduction in size is observed.

[Cell electrophoretical characterization of the surface of Candida guilliermondii]

The electrical properties of the outer layer of the cell wall of a hydrocarbon-grown yeast C. guilliermondii were studied in detail by cell electrophoresis. Some experiments were also made with the yeast S. cerevisiae. The mobilities of the yeasts were measured as a function of pH at pH 2-11.5 and constant ionic strength I = 0.02 mol/l. For identification of surface groups the pH-mobility curves are used to calculate pK-values. The results indicate the presence of amino and carboxyl groups on the surface of C. guilliermondii. These groups are probably a part of a glyco-protein with an isoelectric point at pH 3.3 located on the surface. Electrophoresis of droplets of mineral oil coated with adsorbed protein layer confirms these conclusions. The importance of this glycoprotein in hydrocarbon uptake is discussed.

Ultrastructural study of Salmonella typhimurium treated with membrane-active agents: specific reaction dansylchloride with cell envelope components

Amino groups of cell envelope proteins, lipids, and lipopolysaccharides cannot be labeled in intact cells of Salmonella typhimurium G 30 by using 5-dimethylaminonaphthalene-1-sulfonylchloride incorporated in lecithin-cholesterol vesicles. However, application of membrane-interacting agents like tris(hydroxymethyl)aminomethane (Tris)-hydrochloride, ethylenediaminetetraacetate (Na salt) (EDTA), divalent cations, and sublethal doses of the cationic antibacterial agents polymyxin B and chlorhexidine induced specific fluorescent labeling of envelope proteins and lipids but not of cytoplasmic compounds, with the exception of a soluble protein with a molecular weight of 46,000 in sodium dodecyl sulfate-polyacrylamide gel electrophoresis. Treatment with Tris-hydrochloride buffer produced labeling of the heat-modifiable protein B/B(+) and of proteins with molecular weights of 26,000, 22,000, and below 17,000. A combination of Tris-hydrochloride and EDTA induced additional dansylation of the major protein A and of proteins of molecular weights 80,000, 60,000, and 44,000. Polymyxin B and chlorhexidine caused similar labeling patterns. In every case, except with divalent cation treatment, protein B/B(+) was the most prominently labeled species. Phosphatidylethanolamine was dansylated up to 30%. Lipopolysaccharide was not reactive under any condition or treatment. In addition, the peptidoglycan-bound lipoprotein did not react with dansylchloride in either intact or Tris-hydrochloride-treated cells. The results are discussed with regard to a possible localization of labeled and unlabeled compounds of the cell envelope on the basis of a model placing cell envelope amino groups into ion-ion interactions with anionic components of other envelope compounds like phosphate and carboxyl groups.

Differential fluorescence labelling with 5-dimethyl-aminonaphthalene-1-sulfonyl chloride of intact cells and isolated membranes in Salmonella typhimurium and Acholeplasma laidlawii

For fluorescence labelling intact cells and isolated cell envelopes (membranes) from Salmonella typhimurium and Acholeplasma laidlawii were treated with mixed dansylchloride-lecithin-cholesterol vesicles. This kind of dansylation, which has been supposed to be specific for cell surface proteins, produced fluorescent protein pattern after SDS-polyacrylamide gel electrophoresis only when isolated envelopes were dansylated. Acid hydrolysis of fluorescent cell envelopes of Salmonella typhimurium yielded O-dansyltryosine and epsilon-N-dansyl-lysine besides the free sulfonic acid and unidentified compounds. However, no fluorescent proteins were detectable in cell envelopes isolated from dansylated intact bacteria from Salmonella typhimurium. In accord Acholeplasma laidlawii showed only fluorescence from proteins with a molecular weight higher than 100000.