Alkaline phosphatase from Bacillus licheniformis. Solubility dependent on magnesium, purification and characterization

Rapid and highly sensitive electrochemical determination of alkaline phosphatase using a composite tyrosinase biosensor

The use of an amperometric graphite-Teflon composite tyrosinase biosensor for the rapid monitoring of alkaline phosphatase (ALP), with no need of an incubation step and using phenyl phosphate as the substrate, is reported. Phenol generated by the action of ALP is monitored at the tyrosinase composite electrode through the electrochemical reduction of the o-quinone produced to catechol, which produces a cycle between the tyrosinase substrate and the electroactive product, giving rise to the amplification of the biosensor response and to the sensitive detection of ALP. The current was measured at -0.10 V 5 min after the addition of ALP. As a compromise between high ALP activity and high sensitivity for the detection of phenol, a pH of 8.5 was chosen. The substrate concentration was also optimized. A linear calibration plot was obtained for ALP between 2.0 x 10(-13) and 2.5 x 10(-11), with a detection limit of 6.7 x 10(-14) M. Different types of milk were analyzed with good results, using an extremely simple and rapid procedure.

Bacillus licheniformis MC14 alkaline phosphatase I gene with an extended COOH-terminus

Bacterial alkaline phosphatases (APases), except those isolated from Bacillus licheniformis, are approximately 45-kDa proteins while eucaryotic alkaline phosphatases are 60 kDa. To answer the question of whether the apparent 60-kDa alkaline phosphatase from Bacillus licheniformis accurately reflected the size of the protein, the entire gene was analyzed. DNA sequence analysis of the alkaline phosphatase I (APaseI) gene of B. licheniformis MC14 indicated that the gene could code for a 60-kDa protein of 553 amino acids. The deduced protein sequence of APaseI showed about 32% identity to those of B. subtilis APase III and IV and had apparent sequence homologies in the core structure and active sites that are conserved among APases of various sources. The extra carboxy-terminal sequence of APaseI, which made the enzyme bigger than other procaryotic APases, was not homologous to those of eucaryotic APases. The amino acid composition of APaseI was most similar to that of salt-dependent APase among the isozymes of B. licheniformis MC14. Another open reading frame of 261 amino acids was present 142 nucleotide upstream of the APaseI gene and its predicted amino acid sequence showed 68% identity to that of glucose dehydrogenase of B. megaterium.

Production of two extracellular alkaline phosphatases by a psychrophilic arthrobacter strain

We surveyed our collection of psychrophilic bacteria to determine the types of phosphatases they produce and whether any had heat-labile activities with potential applications. Assays at different temperatures showed that the activity from one isolate was optimal at 45(deg)C and decreased dramatically above 55(deg)C. This isolate, D10, had the rod-coccus morphological cycle and cell wall amino acids associated with members of the Arthrobacter genus. Interestingly, we found that this strain made two extracellular phosphatases that could be separated by ammonium sulfate fractionation and migration during polyacrylamide gel electrophoresis. One enzyme, designated D10A, hydrolyzed both X-phos (5-bromo-4-chloro-3-indolyl phosphate) and para-nitrophenyl phosphate as substrates and had activity over a broad pH range of 7 to 11. The second enzyme, D10B, lacked activity against X-phos and had a narrow pH range of about 8 to 9. In addition, the D10B enzyme required calcium for activity. The levels of activity of both enzymes decreased for cells grown in media containing more than 100 (mu)M P(infi). These results not only demonstrate the existence of different enzymes from one Arthrobacter strain but also suggest ways in which other studies may have missed phosphatases with unknown requirements.

Evidence for two structural genes for alkaline phosphatase in Bacillus subtilis

Two secreted alkaline phosphatase proteins were purified from cultures of Bacillus subtilis JH646MS. The two proteins showed slight differences in subunit molecular weight, substrate specificity, and charge characteristics. A total of 62% of the first 22 amino-terminal amino acids were identical. Both sequences showed conservation of structural features identified in Escherichia coli and human alkaline phosphatases. One alkaline phosphatase was a monomer and the other was a dimer. Southern analysis of genomic DNA with degenerative oligomers based on the amino acid sequences suggest that there are two structural genes for alkaline phosphatase in the genome of B. subtilis.

Two alkaline phosphatase genes positioned in tandem in Bacillus licheniformis MC14 require different RNA polymerase holoenzymes for transcription

Southern transfer analysis of Bacillus licheniformis MC14 DNA, using as probe a DNA fragment from within the coding region of a previously cloned alkaline phosphatase (APase) gene, revealed a second area of hybridization adjacent to the cloned APase gene. A second APase gene (APase II) was subcloned from the same plasmid clone, pMH8, from which the first APase gene (APase I) had been subcloned. The two genes are arranged in tandem with several hundred base pairs separating them. Immunoblot analysis showed that both code for Mr 60,000 proteins that crossreact with anti-APase. Both proteins enzymatically cleave 5-bromo-4-chloro-3-indolyl phosphate. In vitro transcription showed that APase I and APase II are transcribed in the same direction but that the two genes require different forms of Bacillus RNA polymerase: sigma 55- and sigma 37-containing RNA polymerase holoenzymes, respectively.

Cloning and characterization of the Bacillus licheniformis gene coding for alkaline phosphatase

The structural gene for alkaline phosphatase (orthophosphoric monoester phosphohydrolase; EC 3.1.3.1) of Bacillus licheniformis MC14 was cloned into the Pst1 site of pMK2004 from chromosomal DNA. The gene was cloned on an 8.5-kilobase DNA fragment. A restriction map was developed, and the gene was subcloned on a 4.2-kilobase DNA fragment. The minimum coding region of the gene was localized to a 1.3-kilobase region. Western blot analysis was used to show that the gene coded for a 60,000-molecular-weight protein which cross-reacts with anti-alkaline phosphatase prepared against the salt-extractable membrane alkaline phosphatase of B. licheniformis MC14 .

Alkaline phosphatase. A dominant enzyme of microvillus structure of cephalopod photoreceptors

The rhabdomeres of cephalopod photoreceptors, which are built up mainly of rhodopsin and phospholipid molecules, show a very high alkaline phosphatase activity. The enzyme has been partially characterized in purified rhodopsin vesicle fractions of the rhabdomeres by the following kinetic data: pH optimum 8.7; activation energy 9100 cal . m-1; Vmax = 2.5 mumol . min-1 . mg-1; Km = 1.5 x 10(-4) M; its activity depends on Mg2+. There is good evidence that the alkaline phosphatase is a membrane-bound enzyme with receptor sites presumably located on the inside of the membrane. This enzyme has not been purified but its high activity compared to that of other known alkaline phosphatases (see Table I) indicates that each mirovillus, the structural unit of the rhabdomere, contains 1-20 enzyme molecules. This finding supports the hypothesis that the alkaline phosphatase is involved in the biochemical amplification process of excitation, or adaptation.

Membrane-associated alkaline phosphatase from Bacillus licheniformis that requires detergent for solubilization: lactoperoxidase 125I localization and molecular weight determination

When membranes of Bacillus licheniformis MC14 were extracted exhaustively with 1 M magnesium, approximately 80% of the membrane-associated alkaline phosphatase (orthophosphoric-monoester phosphohydrolase [alkaline optimum], E.C. 3.1.3.1) was solubilized. The remaining activity could be extracted with a cationic detergent, hexadecylpyridinium chloride, without loss of enzymatic activity. The detergent-extractable alkaline phosphatase was immunoprecipitable with antibody to the salt-extractable alkaline phosphatase or the secreted alkaline phosphatase, had an approximate molecular weight of 60,000, and was localized 100% on the outer surface of the cytoplasmic membrane.

A soluble alkaline phosphatase from Bacillus licheniformis MC14. Histochemical localization, purification, characterization and comparison with the membrane-associated alkaline phosphatase

Growth conditions affect the quantity and distribution of alkaline phosphatase (orthophosphoric-monoester phosphohydrolase (alkaline optimum), EC 3.1.3.1) in Bacillus licheniformis MC14. The soluble alkaline phosphatase, which has been found in biochemical localization studies between the cell wall and cell membrane (Glynn, J.A., Schaffel, S.D., McNicholas, J.M. and Hulett, F.M. (1977) J. Bacteriol. 129, 1010-1019), was localized via electron microscope histochemistry in cells cultured under conditions which result in increased quantities of this activity. This soluble alkaline phosphatase was stabilized with 20% glycerol and purified to homogeneity as determined by sodium dodecyl sulfate(SDS)-polyacrylamide gel electrophoresis. The purified enzyme is soluble in dilute buffer. This soluble alkaline phosphatase has been characterized and compared to the membrane-associated alkaline phosphatase from this organism.

Lactoperoxidase-125I localization of salt-extractable alkaline phosphatase on the cytoplasmic membrane of Bacillus licheniformis

Previous histochemical and biochemical localizations of alkaline phosphatase in Bacillus licheniformis MC14 have shown that the membrane-associated form of the enzyme is located on the inner surface of the cytoplasmic membrane, and soluble forms are located in the periplasmic space and in the growth medium. The distribution of salt-extractable alkaline phosphatase on the surfaces of the cytoplasmic membrane of B. licheniformis MC14 was determined by using lactoperoxidase-125I labeling techniques. Cells harvested during rapid alkaline phosphatase production were converted to protoplasts or lysed protoplasts and labeled. Analysis of the data obtained indicated that 30% of the salt-extractable, membrane-associated alkaline phosphatase was located on the outer surface of the cytoplasmic membrane, whereas 70% of the membrane-associated enzyme was localized on the inner surface. Controls for protoplast integrity (release of tritiated thymidine or examination of cytoplasmic proteins for label content) indicated excellent protoplast stability. Controls indicated that chemical labeling was not a factor in the apparent distribution of alkaline phosphatase on the membrane. These results support the previously reported histochemical localization of alkaline phosphatase on the membrane inner surface. The presence of alkaline phosphatase on the membrane outer surface is reasonable, considering the soluble forms of the enzyme found in the periplasmic region and in the culture medium.