Temperature and composition dependence of young's modulus for ordered B2 polycrystalline CoAl and FeAl

Unexpected High Ductility of Fe40Al Alloys at Room Temperature

Iron aluminium alloys, especially those sintered from elemental powders, suffer from low ductility. In this paper, an iron aluminium alloy (Fe40Al) produced by pressure-assisted induction sintering from elemental powders is shown and described. Samples produced by this method show an unexpectedly high ductility in the compression test that is an order of magnitude higher than the literature values. Microstructural observations show plastic behaviour with significant deformation of the grains and a lack of decohesion. At the same time, the tensile properties of these samples remain at much lower levels. An attempt to explain this phenomenon is made and described in this paper.

Microstructural and Mechanical Properties of Binary Ti-Rich Fe⁻Ti, Al-Rich Fe⁻Al, and Ti⁻Al Alloys

Three series of binary, FeTi (Ti-rich), FeAl and TiAl (Al-rich) alloy samples were produced in an argon arc furnace. An annealing treatment of 72 h at 1000 °C was applied to the samples, giving rise to different equilibrium microstructures depending on chemical composition. Their mechanical properties were studied through the determination of elastic constants that measure the stiffness of the elaborated materials. Young's modulus of the binary alloys was determined using Resonance Ultrasonic Vibration (RUV). The accuracy of this technique was demonstrated. A scanning electron microscope (SEM) with an energy dispersive spectrometer (EDS) and X-ray diffraction (XRD) made it possible to identify intermetallic compounds FeTi and Fe 2 Ti, FeAl and Fe Al 2 , and TiAl and Ti Al 2 in respective systems Fe⁻Ti, Fe⁻Al, and Ti⁻Al. The link between their composition, microstructure, and elastic properties was established.