Physical and mechanical properties of polypropylene fractions

Waste Electrical and Electronic Equipment: A Review on the Identification Methods for Polymeric Materials

Considering that the large quantity of waste electrical and electronic equipment plastics generated annually causes increasing environmental concerns for their recycling and also for preserving of raw material resources, decreasing of energy consumption, or saving the virgin materials used, the present challenge is considered to be the recovery of individual polymers from waste electrical and electronic equipment. This study aims to provide an update of the main identification methods of waste electrical and electronic equipment such as spectroscopic fingerprinting, thermal study, and sample techniques (like identification code and burning test), and the characteristic values in the case of the different analyses of the polymers commonly used in electrical and electronic equipment. Additionally, the quality of the identification is very important, as, depending on this, new materials with suitable properties can be obtained to be used in different industrial applications. The latest research in the field demonstrated that a complete characterization of individual WEEE (Waste Electric and Electronic Equipment) components is important to obtain information on the chemical and physical properties compared to the original polymers and their compounds. The future directions are heading towards reducing the costs by recycling single polymer plastic waste fractions that can replace virgin plastic at a ratio of almost 1:1.

Influence of thermooxidative degradation on the in situ fate of polyethylene in temperate coastal waters

Polyethylene is a commonly used polymer in plastic products and is often found as marine litter. Nevertheless there is limited knowledge about what happens to the material when it ends up in the sea. Polyethylene films were therefore thermally oxidised to four different levels of degradation. The films were then placed in stainless-steel cages in the sea off the Swedish west coast for 12 summer weeks. Subsamples were analysed with respect to biofouling, degradation and buoyancy. All levels showed a continued oxidation in the field. The pre-degraded films started fragmenting and the non-degraded films showed a decrease in tensile strain. All levels showed increased biofouling with higher presence of filamentous algae and bryozoans on pre-degraded materials. The density (kg·m^-3) of the films was seen to increase slightly, and the apparent density for the pre-degraded films (density of the films with biofilm) showed a strong increase, which resulted in sinking.