Kinetics of the beta-thromboglobulin release from alpha-granules of blood platelets activated by ADP

Thrombogenicity assessment of Pipeline, Pipeline Shield, Derivo and P64 flow diverters in an in vitro pulsatile flow human blood loop model

Flow diversion is a disruptive technology for the treatment of intracranial aneurysms. However, these intraluminal devices pose a risk for thromboembolic complications despite dual antiplatelet therapy. We report the thrombogenic potential of the following flow diversion devices measured experimentally in a novel human blood in-vitro pulsatile flow loop model: Pipeline™ Flex Embolization Device (Pipeline), Pipeline™ Flex Embolization Device with Shield Technology™ (Pipeline Shield), Derivo Embolization Device (Derivo), and P64 Flow Modulation Device (P64). Thrombin generation (Mean ± SD; μg/mL) was measured as: Derivo (28 ± 11), P64 (21 ± 4.5), Pipeline (21 ± 6.2), Pipeline Shield (0.6 ± 0.1) and Negative Control (1.5 ± 1.1). Platelet activation (IU/μL) was measured as: Derivo (4.9 ± 0.7), P64 (5.2 ± 0.7), Pipeline (5.5 ± 0.4), Pipeline Shield (0.3 ± 0.1), and Negative Control (0.9 ± 0.7). We found that Pipeline Shield had significantly lower platelet activation and thrombin generation than the other devices tested (p < .05) and this was comparable to the Negative Control (no device, p > .05). High resolution scanning electron microscopy performed on the intraluminal and cross-sectional surfaces of each device showed the lowest accumulation of platelets and fibrin on Pipeline Shield relative to Derivo, P64, and Pipeline. Derivo and P64 also had higher thrombus accumulation at the flared ends. Pipeline device with Phosphorylcholine surface treatment (Pipeline Shield) could mitigate device material related thromboembolic complications.

Thrombogenicity assessment of Pipeline Flex, Pipeline Shield, and FRED flow diverters in an in vitro human blood physiological flow loop model

Endovascular treatment of intracranial aneurysms with endoluminal flow diverters (single or multiple) has proven to be clinically safe and effective, but is associated with a risk of thromboembolic complications. Recently, a novel biomimetic surface modification with covalently bound phosphorylcholine (Shield Technology™) has shown to reduce the material thrombogenicity of the Pipeline flow diverter. Thrombogenicity of Pipeline Flex, Pipeline Shield, and Flow Redirection Endoluminal Device (FRED) in the presence of human blood under physiological flow conditions—in addition to relative increase in thrombogenicity with multiple devices—remains unknown and was investigated here. Thrombin generation (mean ± SD; μg/mL; thrombin–antithrombin complex or TAT) was measured as FRED (30.3 ± 2.9), Pipeline (13.9 ± 4.4), Pipeline Shield (0.4 ± 0.3), and negative control (no device; 0.1 ± 0.0). Platelet activation (mean ± SD; IU/μL; beta‐thromboglobulin or βTG) was measured as FRED (148 ± 45), Pipeline (92.8 ± 41), Pipeline Shield (16.2 ± 3.5), and negative control (2.70 ± 0.16). FRED was significantly more thrombogenic than Pipeline and Pipeline Shield (p < 0.05) for TAT. Additionally, Pipeline Shield had significantly lower TAT and βTG than the other devices tested (p < 0.05) and these were comparable to the negative control (p > 0.05). TAT and βTG scaled proportionately with multiple Pipeline devices (N = 6) but was unaffected by multiple Pipeline Shield (N = 6) devices—the latter being statistically similar to negative control (p > 0.05). © 2018 The Authors. Journal Of Biomedical Materials Research Part A Published By Wiley Periodicals, Inc. J Biomed Mater Res Part A: 106A: 3195–3202, 2018.

PDMS content affects in vitro hemocompatibility of synthetic vascular grafts

An unsolved problem when employing small-diameter vascular grafts for aorto-coronary by-pass and peripheral reconstruction is the early thrombotic occlusion. The PEtU-PDMS is a new elastomeric material, composed of poly(ether)urethane and polydimethylsiloxane, synthesized to realize grafts with improved hemocompatibility characteristics. In order to investigate the effect of PDMS content on hemocompatibility, three different percentages of PDMS containing grafts (10, 25 and 40) were evaluated. Grafts realized with Estane 5714-F1 and silicone medical grade tubes were used as references. The hemocompatibility was investigated by an in vitro circuit in which human anticoagulated blood was circulated into grafts by a peristaltic pump modified to obtain a passive flow. For each experiment, 40 cm length graft was closed into a circular loop and put in rotation for 2 h at 37 degrees C. At the end of the experiments different parameters regarding platelet adhesion and activation were evaluated: circulating platelets count, beta-thromboglobulin release, platelet CD62P expression and amount of monocyte-platelet conjugates. PEtU-PDMS grafts with 25 and 40% of PDMS induced the lowest platelet adhesion, plasma level of beta-TG and amount of monocyte-platelet conjugates. No significative variations were observed in CD62P expression. In conclusion, PDMS content significatively affects blood-graft surface interaction, in fact higher PDMS percentage containing grafts showed the best in vitro hemocompatibility.

Luminal surface microgeometry affects platelet adhesion in small-diameter synthetic grafts

One of the major problems when using small-diameter vascular grafts in arterial reconstruction is the development of platelet-rich thrombi as a consequence of blood contact with artificial surfaces. The degree of occlusion is certainly affected by the thrombogenicity of the internal surface that seems to play a key role in patency and long-term wound healing of grafts. In this study, the blood compatibility of Cardiothane (CA) vascular grafts was investigated. The CA material, a blend of polyurethane and polydimethylsiloxane that has shown relatively good physical and biocompatibility properties, was manufactured into vascular grafts by the instrument named "spray-machine". Grafts with different luminal surface porosity were produced using increasing CA concentrations by the "spray-machine" and the blood compatibility was evaluated in vitro by a circulation system in which the human blood was allowed to interact with the material in a well-controlled setting. The samples of circulating blood were collected at different times of circulation and platelet adhesion and activation were studied. Grafts with a highly porous luminal surface induced a lower adhesion and activation of platelets in vitro than the low-porosity ones. These results underlined the importance of the microgeometry of the graft luminal surface in the interaction with blood.