Factors influencing toxicity of cadmium to Tetrahymena pyriformis: Particulate or soluble form and degree of complexation

Toxicological comparisons of Tetrahymena species, end points and growth media: supplementary investigations to the pilot ring test

Parallel to an international Pilot Ring Test to standardize a mutigeneration test protocol with the protozoon Tetrahymena pyriformis supplementary investigations were made. Effects on growth rate and 46 h population density were measured using an extended set of 12 chemicals, a further Tetrahymena-species (T. thermophila) and 4 different media (axenic and bacteria based). Results are compared for sensitivity with effects on additional end points (chemosensory response, respiration and vitality). Both species exhibit similar sensitivity towards the chemicals. In some cases the media composition influenced the toxic potential of chemicals. Both growth parameters proved to be a sensitive integral end point for toxicological studies, confirming the one point, photometric measurement of population density after 46 hours in axenic (preferably proteose peptone-) medium an obvious choice for a standard test procedure.

Interaction between components of electroplating industry wastes. Influence of the receiving water on the toxicity of the effluent

A copper-cadmium-nickel-zinc mixture was assessed in seven different river waters to study metal toxicity to the ciliate protozoan Colpidium campylum, the interactions occurring between metals, and the influence of the receiving water on toxicity. In the range of concentrations tested, which are representative of electroplating industry wastes, the main part of the toxicity can be attributed to copper and to cadmium-copper synergy. A classification of waters, based on a principal component analysis (PCA), was used to examine the main parameters of the water, which can affect the toxicity of metal mixtures. It appears that the mineralization of the water, more than the total organic carbon (TOC), is an important parameter for the expression of toxicity. A strategy for the estimation of ecotoxicological hazard assessment, based on a simplified factorial experiment is proposed. It enables one to study, in a two-step bioassay, the toxicity of an effluent, the influence of river water on its toxicity, and the effects of contact time and dilution. By applying PCA to data from very different waters, it may be possible to estimate the ecotoxicological risk associated with the discharge of an effluent, on the basis of the chemistry of the receiving water.

The influence of growth phase and culture conditions of Tetrahymena on effects of cadmium

The batch culture system is used in the majority of toxicity studies employing protozoa and other cell cultures, although it is known that metal toxicity may vary depending on the age and therefore on the physiological state of the culture. The ciliate Tetrahymena was exposed to cadmium during short-term incubations at different stages of the growth cycle. In cultures with cells proliferating at a high rate (log phase cells) the toxicity of cadmium was found to increase with increasing initial cell density. However, in the subsequent stationary growth phase with decreased rate of cell proliferation, the sensitivity against cadmium again decreases. Thus the effect of a given concentration of cadmium depends on the initial cell density of the culture. This effect of cadmium may be explained either by changes in the chemical composition of the culture medium during the growth cycle or by a changed cellular metabolism. Furthermore, it is shown that the cadmium concentration of the medium decreases during prolonged exposure when the cells are grown in batch cultures. Some of the problems associated with the toxicity bioassay performed in a static system may be overcome by using a continuous flow system. In such a system, Tetrahymena can be kept under optimal growth conditions with a generation time of less than 3 h, and any cell density may be maintained for extended periods of time. Furthermore, the cadmium concentration of the medium remained constant during prolonged exposure when maintaining a cell density of about 50 x 10(3) cells/ml. This illustrates the great advantage of using a continuous flow system in such investigations, where for example, long-term adaptations of the organism to a metal may be studied under constant conditions.