A thin-layer multistrip agarose gel electrophoresis apparatus for Ferguson plot analysis at the sub-microgram load level

Agarose electrophoresis of DNA in discontinuous buffers, using a horizontal slab apparatus and a buffer system with improved properties

Using a horizontal slab apparatus with a buffer in the reservoirs at the level of the gel ("sea-level electrophoresis"), the retrograde discontinuous buffer system reported by Wiltfang et al. for sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) of proteins was applied to DNA electrophoresis. This application yielded the advantages of an increased displacement rate of the moving boundary front and a decrease in the concentration of the counterion base in the resolving phase, which yielded reduced relative mobility values at equivalent gel concentrations and practicable low buffer concentrations. The change of relative mobilities (Rf) with a variation of field strength is decreased compared to that of the migration rate in the continuous Tris-boric-acid-EDTA (TBE) buffer and thus the robustness of the system is improved, as well as the efficiency of separation. The system of Wiltfang et al. has in common with previously described discontinuous DNA system, that it is able to stack DNA from dilute samples and is insensitive to sample components with lower net mobilities than DNA, such as acetate. However, the variance of Rf at constant current density in the discontinuous buffer system is not improved over that of the migration rate at constant field strength in the continuous TBE buffer.

Information on DNA conformation derived from the Ferguson plot of DNA fragments of up to 9 kb in size, using polyacrylamide gel electrophoresis in a discontinuous buffer system

The Ferguson plot in polyacrylamide gel electrophoresis (PAGE)(15%CDATD, moving boundary electrophoresis buffer system operative at pH 8.9, 4 degrees C, 8 mA/cm2 of gel) of DNA fragments up to 9.4 kb in size was found to exhibit a linear segment at polyacrylamide concentrations starting at 3% T and undergoing a gradual transition into a concave segment at higher gel concentrations, confirming previous findings by Stellwagen. The larger the DNA, and the higher the gel concentration, the less extended the linear and the more extended the concave segment of the plot. The lowest % T of the linear range for DNA in polyacrylamide remains unknown since mobilities at nongelling concentrations below 3% T have not as yet been measured. As previously suggested, the transition from the linear to the concave segment corresponds to that from the randomly oriented DNA to the anisotropically stretched, "reptating" DNA. For a DNA of 9.4 kb in size, the end of the linear range of the Ferguson plot can be extended from 3.5 to 5% T when 15% DATD rather than 2.5% Bis is used to crosslink the polyacrylamide. Increasing the temperature of PAGE from 4 degrees C to 25 and 50 degrees C widens the linear segment progressively, indicating an increasingly random orientation with rising temperature. When current density is increased from 8 to 40 mA/cm2, the concave curvature of the Ferguson plot of DNA 1 to 9.4 kb in size decreases, suggesting a transition from a "reptating" to a randomly distributed molecule, due to increased Joule heat.(ABSTRACT TRUNCATED AT 250 WORDS)

Discontinuous buffer system for polyacrylamide and agarose gel electrophoresis of DNA fragments

DNA fragments up to 9 kb in size were stacked and separated by polyacrylamide gel electrophoresis, and those up to 50 kb in size by agarose gel electrophoresis, using a discontinuous buffer system. Polyacrylamide gels at pH 8.9, 2 degrees C, 0.01 M ionic strength, yielded sharp bands with DNA loads of 8 micrograms/cm2 of gel of a mixture of 19 DNA fragments in the size range of 72-23130 bp, while agarose gels at pH 8.5, 25 degrees C, provided well-resolved, unperturbed bands at 0.04 M ionic strength with DNA loads of 1 microgram/cm2 of the same mixture. Note that the ionic strength of the agarose gels is comparable to the conventionally used 0.5 x TBE (Tris-borate-EDTA) buffer, while that successfully applied to polyacrylamide is seven-fold less than the ionic strength of conventionally used 1 x TBE buffer, with a substantially shorter duration of electrophoresis as a result. The application of a discontinuous buffer system to the gel electrophoresis of DNA results in (i) Band identification by Rf, the migration distance relative to a sharply defined "buffer front" (moving boundary). This is sufficiently labor saving, compared to determining absolute mobilities, so as to render practical the expression of bands as numbers, with benefits for data storage, statistical manipulations and physico-chemical exploitation of mobility data. The use of Rf's also circumvents loss of precision in mobility measurement resulting from progressive band spreading of dye bands used as a front. (ii) A uniformly and highly concentrated starting zone, beneficial to resolution, is obtained, without the losses by which separate concentration steps are usually burdened.(ABSTRACT TRUNCATED AT 250 WORDS)