Detection of bacterial contamination, including Bacillus spores, in dry growth media and in milk by identification of their 16S rDNA by polymerase chain reaction

Method of MeasuringBacillusanthracisSpores in the Presence of Copious Amounts ofBacillusthuringiensisandBacilluscereus

A sensitive and reliable method for the detection of Bacillus anthracis (BA; Sterne strain 7702) spores in presence of large amounts of Bacillus thuringiensis (BT) and Bacillus cereus (BC) is presented based on a novel PZT-anchored piezoelectric excited millimeter-sized cantilever (PAPEMC) sensor with a sensing area of 1.5 mm2. Antibody (anti-BA) specific to BA spores was immobilized on the sensing area and exposed to various samples of BA, BT, and BC containing the same concentration of BA at 333 spores/mL, and the concentration of BT + BC was varied in concentration ratios of (BA:BT + BC) 0:1, 1:0, 1:1, 1:10, 1:100, and 1:1000. In each case, the sensor responded with an exponential decrease in resonant frequency and the steady-state frequency changes reached were 14 +/- 31 (n = 11), 2742 +/- 38 (n = 3), 3053 +/- 19 (n = 2), 2777 +/- 26 (n = 2), 2953 +/- 24 (n = 2), and 3105 +/- 27 (n = 2) Hz, respectively, in 0, 27, 45, 63, 154, and 219 min. The bound BA spores were released in each experiment, and the sensor response was nearly identical to the frequency change during attachment. These results suggest that the transport of BA spores to the antibody immobilized surface was hindered by the presence of other Bacillus species. The observed binding rate constant, based on the Langmuir kinetic model, was determined to be 0.15 min-1. A hindrance factor (alpha) is defined to describe the reduced attachment rate in the presence of BT + BC and found to increase exponentially with BT and BC concentration. The hindrance factor increased from 3.52 at 333 BT + BC spores/mL to 11.04 at 3.33 x 105 BT + BC spores/mL, suggesting that alpha is a strong function of BT and BC concentration. The significance of these results is that anti-BA functionalized PEMC sensors are highly selective to Bacillus anthracis spores and the presence of other Bacillus species, in large amounts, does not prevent binding but impedes BA transport to the sensor.

Estimating amplification efficiency improves multiplex real-time PCR quantification of Bacillus licheniformis and Bacillus subtilis spores in animal feed

A multiplex real-time PCR assay was developed for absolute quantification in animal feed of Bacillus subtilis CH201 and Bacillus licheniformis CH200 spores, which constitute the viable component of the microbial growth promoter, BioPlus 2B. Spores were lysed using a bead-beating protocol. DNA was extracted and purified from the lysates with the Qiagen DNeasy Plant Kit. Two standard curves for absolute quantification were made and tested. Standard curve-1 was made from feed samples spiked with BioPlus 2B, while standard curve-2 was made from serially diluted DNA extracted from BioPlus 2B powder. Feed samples supplemented with BioPlus 2B were quantified using both standard curves. The detection limit of the assay was 10(4) CFU g(-1) of feed. The amplification efficiency (Eff) of each PCR was determined using the LinRegPCR software and Eff differences between individual samples and standards were corrected for. When compared to plate counts, standard curve-1 slightly under-estimated the number of spores (mean=-2.47% of plate counts). A spore density-dependent Eff was found, and Eff for standard curve-1 could not be determined. Standard curve-2 over-estimated spore numbers when not corrected for individual Eff (mean=+5.46% of plate counts). Standard curve-2 Eff was independent (Eff(mean)=1.96) of spore density. The assay quantified the numbers of spores in feed samples very similar to plate counts (mean=+0.47% of plate counts), when standard curve-2 was used and individual Eff was accounted for.

Micromechanical cantilever array sensors for selective fungal immobilization and fast growth detection

We demonstrate the use of micromechanical cantilever arrays for selective immobilization and fast quantitative detection of vital fungal spores. Micro-fabricated uncoated as well as gold-coated silicon cantilevers were functionalized with concanavalin A, fibronectin or immunoglobulin G. In our experiments two major morphological fungal forms were used--the mycelial form Aspergillus niger and the unicellular yeast form Saccharomyces cerevisiae, as models to explore a new method for growth detection of eukaryotic organisms using cantilever arrays. We exploited the specific biomolecular interactions of surface grafted proteins with the molecular structures on the fungal cell surface. It was found that these proteins have different affinities and efficiencies to bind the spores. Maximum spore immobilization, germination and mycelium growth was observed on the immunoglobulin G functionalized cantilever surfaces. We show that spore immobilization and germination of the mycelial fungus A. niger and yeast S. cerevisiae led to shifts in resonance frequency within a few hours as measured by dynamically operated cantilever arrays, whereas conventional techniques would require several days. The biosensor could detect the target fungi in a range of 10(3) - 10(6) CFUml(-1). The measured shift is proportional to the mass of single fungal spores and can be used to evaluate spore contamination levels. Applications lie in the field of medical and agricultural diagnostics, food- and water-quality monitoring.