Specimen movement in electron-irradiated paraffin crystals — A model for initial beam damage

Thin Layer Buckling in Perovskite CsPbBr3 Nanobelts

Flexible semiconductor materials, where structural fluctuations and transformation are tolerable and have low impact on electronic properties, focus interest for future applications. Two-dimensional thin layer lead halide perovskites are hailed for their unconventional optoelectronic features. We report structural deformations via thin layer buckling in colloidal CsPbBr₃ nanobelts adsorbed on carbon substrates. The microstructure of buckled nanobelts is determined using transmission electron microscopy and atomic force microscopy. We measured significant decrease in emission from the buckled nanobelt using cathodoluminescence, marking the influence of such mechanical deformations on electronic properties. By employing plate buckling theory, we approximate adhesion forces between the buckled nanobelt and the substrate to be F_adhesion ∼ 0.12 μN, marking a limit to sustain such deformation. This work highlights detrimental effects of mechanical buckling on electronic properties in halide perovskite nanostructures and points toward the capillary action that should be minimized in fabrication of future devices and heterostructures based on nanoperovskites.

Images of paraffin monolayer crystals with perfect contrast: minimization of beam-induced specimen motion

Quantitative analysis of electron microscope images of organic and biological two-dimensional crystals has previously shown that the absolute contrast reached only a fraction of that expected theoretically from the electron diffraction amplitudes. The accepted explanation for this is that irradiation of the specimen causes beam-induced charging or movement, which in turn causes blurring of the image due to image or specimen movement. In this paper, we used three different approaches to try to overcome this image-blurring problem in monolayer crystals of paraffin. Our first approach was to use an extreme form of spotscan imaging, in which a single image was assembled on film by the successive illumination of up to 50,000 spots, each of a diameter of around 7 nm. The second approach was to use the Medipix II detector with its zero-noise readout to assemble a time-sliced series of images of the same area in which each frame from a movie with up to 400 frames had an exposure of only 500 electrons. In the third approach, we simply used a much thicker carbon support film to increase the physical strength and conductivity of the support. Surprisingly, the first two methods involving dose fractionation in space or time produced only partial improvements in contrast whereas the third approach produced many virtually perfect images, where the absolute contrast predicted from the electron diffraction amplitudes was observed in the images. We conclude that it is possible to obtain consistently almost perfect images of beam-sensitive specimens if they are attached to an appropriately strong and conductive support; however great care is needed in practice and the problem remains of how to best image ice-embedded biological structures in the absence of a strong, conductive support film.

Stroboscopic image capture: Reducing the dose per frame by a factor of 30 does not prevent beam-induced specimen movement in paraffin

Beam-induced specimen movement may be the major factor that limits the quality of high-resolution images of organic specimens. One of the possible measures to improve the situation that was proposed by Henderson and Glaeser [Ultramicroscopy 16 (1985) 139-150], which we refer to here as "stroboscopic image capture", is to divide the normal exposure into many successive frames, thus reducing the amount of electron exposure--and possibly the amount of beam-induced movement--per frame. The frames would then be aligned and summed. We have performed preliminary experiments on stroboscopic imaging using a 200-kV electron microscope that was equipped with a high dynamic range Charge-coupled device (CCD) camera for image recording and a liquid N2-cooled cryoholder. Single-layer paraffin crystals on carbon film were used as a test specimen. The ratio F(g)/F(0) of paraffin reflections, calculated from the images, serves as our criterion for the image quality. In the series that were evaluated, no significant improvement of the F(image)(g)/F(image)(0) ratio was found, even though the electron exposure per frame was reduced by a factor of 30. A frame-to-frame analysis of image distortions showed that considerable beam-induced movement had still occurred during each frame. In addition, the paraffin crystal lattice was observed to move relative to the supporting carbon film, a fact that cannot be explained as being an electron-optical effect caused by specimen charging. We conclude that a significant further reduction of the dose per frame (than was possible with this CCD detector) will be needed in order to test whether the frame-to-frame changes ultimately become small enough for stroboscopic image capture to show its potential.

Imaging of protein molecules--towards atomic resolution

This review discusses some of the recent developments in high resolution imaging of biological molecules. Electron micrographs of unstained biological molecules never show the resolution or contrast that would be predicted. Movements in the specimen caused by radiation damage, and possibly charging of the specimen are the most significant factors in the reduction of image contrast of these radiation-sensitive specimens. Until these limitations are overcome it is unlikely that the structures of biological molecules will be determined to the resolutions to which they are preserved. The causes of contrast loss in images are discussed in a quantitative manner and the use of crystalline paraffin as a model for radiation-sensitive specimens in general is described. Procedures for improving the contrast in images of biological molecules are described, including the new method of spot-scan imaging. Possible future developments, including high resolution imaging of single particles, are discussed.

Interpretation of electron diffraction data from organic microcrystals: a theoretical perspective

The current framework for the quantitative analysis of transmission electron diffraction data from organic microcrystals is discussed. The appropriate formulation depends upon the crystal perfection: solution-grown material tends to be nearly perfect with regular elastic bends whilst the epitaxial samples are usually considerably less perfect with highly irregular bends. It is possible to obtain Bragg intensity data which are near-kinematical and thus amenable to ab initio structure analysis. Thereafter, the further refinement of the model proceeds with a consideration of dynamical and crystal bending effects. If both of these are small it is a good approximation to analyse them independently rather than use the correct description of dynamical scattering from a deformed foil. The analysis of three-dimensional data sets from tilt series is considered. Although the technique has been successfully demonstrated in several instances there are still details of the analysis that need further clarification.