Catalysis by water-soluble phosphine complexes of transition metal ions in aqueous and two-phase media

Synthesis, characterization, kinetic investigation and biological evaluation of Re(i) di- and tricarbonyl complexes with tertiary phosphine ligands

Kinetics of Re(i) complexes illustrated the ability to ‘tune’ the metal centre; phosphine-based complexes were more stable and more cytotoxic.

The effect of pH on the reactions of catalytically important RhI complexes in aqueous solution: reaction of [RhCl(tppms)3] and trans-[RhCl(CO)(tppms)2] with hydrogen (TPPMS = mono-sulfonated triphenylphosphine)

Hydrolysis and hydrogenation of [RhCl(tppms)3] (1) and trans-[RhCl(CO)(tppms)2] (2) was studied in aqueous solutions in a wide pH range (2 < pH < 11) in the presence of excess TPPMS (3-diphenylphosphinyl-benzenesulfonic acid sodium salt). In acidic solutions hydrogenation of 1 yields a mixture of cis-mer- and cis-fac-[RhClH2(tppms)3] (3a,b) while in strongly basic solutions [RhH(H2O)(tppms)3] (4) is obtained, the midpoint of the equilibrium between these hydride species being at pH 8.2. The paper gives the first successful 1H and 31P NMR spectroscopic characterization of a water soluble rhodium(I)-monohydride (4) bearing only monodentate phosphine ligands. Hydrolysis of 2 is negligible below pH 9 and its hydrogenation results in formation of [Rh(CO)H(tppms)3] (5), which is an analogue to the well known and industrially used hydroformylation catalyst [Rh(CO)H(tppts)3] (6) (TPPTS = 3,3',3''-phosphinetriyltris(benzenesulfonic acid) trisodium salt). It was shown by pH-potentiometric measurements that formation of 5 is strongly pH dependent in the pH 5-9 range, this gives an explanation for the observed but previously unexplained pH dependence of several hydroformylation reactions. Conversely, the effect of pH on the rate of hydrogenation of maleic and fumaric acid catalyzed by 1 in the 2 < pH < 7 range can be adequately described by considering solely the changes in the ionization state of these substrates. All these results warrant the use of buffered (pH-controlled) solutions for aqueous organometallic catalysis.

Facile Catalyst Separation Without Water: Fluorous Biphase Hydroformylation of Olefins

A novel concept for performing stoichiometric and catalytic chemical transformations has been developed that is based on the limited miscibility of partially or fully fluorinated compounds with nonfluorinated compounds. A fluorous biphase system (FBS) consists of a fluorous phase containing a dissolved reagent or catalyst and another phase, which could be any common organic or nonorganic solvent with limited or no solubility in the fluorous phase. The fluorous phase is defined as the fluorocarbon (mostly perfluorinated alkanes, ethers, and tertiary amines)-rich phase of a biphase system. An FBS compatible reagent or catalyst contains enough fluorous moieties that it will be soluble only or preferentially in the fluorous phase. The most effective fluorous moieties are linear or branched perfluoroalkyl chains with high carbon number; they may also contain heteroatoms. The chemical transformation may occur either in the fluorous phase or at the interface of the two phases. The application of FBS has been demonstrated for the extraction of rhodium from toluene and for the hydroformylation of olefins. The ability to separate a catalyst or a reagent from the products completely at mild conditions could lead to industrial application of homogeneous catalysts or reagents and to the development of more environmentally benign processes.