Determination of sulphanilamide in milk by first-derivative and second-derivative spectrofluorimetry

Validation of a Stability-Indicating Spectrometric Method for the Determination of Sulfacetamide Sodium in Pure Form and Ophthalmic Preparations

Introduction:

Sulfacetamide sodium is a widely used sulfonamide for ophthalmic infections.

Objective:

A number of analytical methods have been reported for the analysis of sulfacetamide but they lack the ability to determine both the active drug and its major degradation product, sulfanilamide, simultaneously in a sample.

Materials and Methods:

In the present study a simple, rapid and economical stability-indicating UV spectrometric method has been validated for the simultaneous assay of sulfacetamide sodium and sulfanilamide in pure form and in ophthalmic preparations.

Results:

The method has been found to be accurate (recovery 100.03 ±0.589%) and precise (RSD 0.587%) with detectable and quantifiable limits of 1.67×10^–6 M (0.04 mg%) and 5.07×10^–6 M (0.13 mg%), respectively for the assay of pure sulfacetamide sodium. The method is also found to be accurate and precise to small changes in wavelength, pH and buffer concentration as well as to forced degradation. The study further includes the validation of the method for the assay of pure sulfanilamide in solution, which has been found to be accurate, precise and robust.

Conclusion:

The results indicate that the proposed two-component spectrometric method is stability-indicating and can be used for the simultaneous assay of both sulfacetamide sodium and sulfanilamide in synthetic mixtures and degraded solutions.

Rapid and selective determination of pitavastatin calcium in presence of its degradation products and co-formulated drug by first-derivative micelle-enhanced and synchronous fluorimetric methods

New, selective and rapid methods are presented for determination of PIT in the presence of its hydrolytic degradation products and co-formulated drug, EZE. These methods are derivative micelle enhanced native fluorescence and synchronous fluorimetry.

Determination of sulphathiazole and sulphanilamide by photochemically induced fluorescence and first-derivative fluorescence

This manuscript reports the usefulness of the determination of sulphathiazole (ST) using photochemically induced fluorescence (RTPF) and RTPF coupling with first derivative (D1-RTPF), and the determination of sulphanilamide (SAN) by meaning first derivative of the emission spectrum. By irradiating 5 min, with intense UV radiation, sulphathiazole, in ethanol:water 20:80 (v/v) solutions at pH 4.5-5.0, show fluorescence emission at 342 nm (lambdaex=251 nm). Under these conditions, a linear relation, fluorescence intensity-ST concentration, was found between 0.23 and 3.00 microg mL(-1) of ST. The method was applied for determining ST in a pharmaceutical drug. ST was also determined in honey by using the D1-RTPF signal, applying the standard addition method, and measuring at 324.8 nm. Under the same experimental conditions of pH and solvent, a fluorimetric method for determining SAN in presence of ST is proposed. Calibration graphs for SAN determination were established using the amplitude of the first derivative of the emission spectrum measured at 324.4 nm, as the analytical signal. This method has been applied to determining SAN in a pharmaceutical formulation.