Structural study of AOT reverse micelles containing native or modified proteins: influence of surfactant-enzyme interaction

Nanoencapsulated Lecitase Ultra and Thermomyces lanuginosus Lipase, a Comparative Structural Study

Two commercially available and widely used enzymes, the parent Thermomyces lanuginosus lipase (TLL) and the shuffled phospholipase A1 Lecitase (Lecitase Ultra), were encapsulated in AOT/isooctane reverse micelles and evaluated regarding their structure and activity. Preparations were also tested as effective biocatalysts. Small-angle X-ray scattering (SAXS), electronic paramagnetic resonance (EPR), and fluorescence spectroscopy were the techniques applied to assess the effects of enzyme incorporation to a reverse micellar nanostructure. SAXS analysis showed that the radius of gyration (Rg) changed from 16 to 38 Å, as the water content (w0) increased. Elongated shapes were more commonly observed than spherical shapes after enzyme encapsulation. EPR studies indicated that enzymes do not participate in the interface, being located in the aqueous center. Fluorescence energy transfer showed that TLL is located in the water core, whereas Lecitase Ultra is closer to the interface. Enzymatic activity toward a standard esterification reaction endured after the enzyme was incorporated into the micelles. The activity of TLL for systems with w0 15 showed the highest conversion yield, 38% in 2 h, while the system with w0 10 showed the highest initial velocity, 0.43 μM/min. This last system had a Rg of 19.3 Å, similar to that of the TLL monomer. Lecitase Ultra showed the highest conversion yields in systems with w0 10, 55% in 2 h. However, the initial rate was much lower than that of TLL, suggesting less affinity for the substrates, which is expected since Lecitase Ultra is a phospholipase. In summary, we here used several spectroscopic and scattering techniques to reveal the shape and stability of TTL and Lecitase Ultra encapsulated systems, which allowed the selection of w0 values to provide optimized enzymatic activity.

Electrochemical extraction of proteins by reverse micelle formation

The transfer of proteins by the anionic surfactant bis(2-ethylhexyl) sulfosuccinate (AOT) at a polarized 1,2-dichloroethane/water (DCE/W) interface was investigated by means of ion-transfer voltammetry. When the tetrapentylammonium salt of AOT was added to the DCE phase, the facilitated transfer of certain proteins, including cytochrome c (Cyt c), ribonuclease A, and protamine, could be controlled electrochemically, and a well-defined anodic wave for the transfer was obtained. At low pH values (e.g., pH 3.4), the anodic wave was usually well-separated from the wave for the formation of protein-free (i.e., unfilled) reverse micelles. The anodic wave for the protein transfer was analyzed by applying the theory for facilitated transfer of ions by charged ligands and then supplying information regarding the number of AOT anions reacting with one protein molecule and the total charge carried by the protein transfer. However, controlled-potential electrolyses performed for the transfer of Cyt c, which is red, revealed that the protein-AOT complexes were unstable in DCE and liable to aggregate at the interface when the pH of the W phase was 3.4. At pH 7.0, when formation of unfilled reverse micelles occurred simultaneously, the protein-AOT complexes appeared to be stabilized, probably via fusion with unfilled reverse micelles.

Structure modifications of AOT reverse micelles due to protein incorporation

Structural modifications of AOT/water/isooctane reverse micelles due to incorporation of proteins were studied at various water contents and protein concentrations, using small-angle X-ray scattering (SAXS) experiments under static conditions, rheometry analysis, and SR-SAXS experiments under induced shear flow. Two proteins, lysozyme (pI 11.1, Mw 14,300 Da) and BSA (pI 4.3, Mw 66,700 Da), were chosen as models. SAXS analysis of protein-containing reverse micelles at low water content detected minima in the average micelle size versus protein concentration curve, for both proteins, below and above their isoelectric point. This minimum was attributed to changes in the size distribution of the reverse micelles. SAXS measurements of reverse micelles at high water content have shown them to have a cylindrical form. Incorporation of lysozyme at pH 7 into the cylindrical micelles induced a shape transition to spherical micelles, which was associated with a decreased viscosity. SR-SAXS measurements under induced shear flow and dynamic conditions revealed alignment of the cylindrical micelles in the flow direction. The anisotropy parameter, a measure of the degree of the spatial order, was found to increase with increasing shear rate and to decrease with increasing lysozyme concentration.

Enhanced stabilization of aerosol-OT surfactant monolayer upon interaction with small amounts of bovine serum albumin at the air–water interface

An investigation is made of the influence from small amounts of the protein bovine serum albumin (BSA) on the lateral organization of low molecular weight surfactant sodium bis-2-ethylhexyl sulfosuccinate (AOT) at the air-water interface. Surface pressure (pi - A), surface potential (deltaV - A) and Brewster angle microscopy (BAM) experiments were carried out, with particular emphasis on the monolayer stability under successive compression-expansion cycles. AOT monolayer is not stable at the air-water interface, which means that the majority of AOT molecules go into the aqueous subphase as monomers and/or normal micelles. When a waiting time elapses between spreading and compression, the surfactant monolayer tends to reorganize partially at the air-water interface, with a monolayer expansion being observed for waiting times as large as 12 h. The incorporation of very small amount of BSA (10(-9)M) at the interface, also inferred from BAM, increases the monolayer stability as revealed by pi - A and deltaV - A results. For a waiting time of circa 3 h, the mixed monolayer reaches its maximum stability. This must be related to protein (and/or protein-surfactant complexes) adsorbed onto the AOT monolayer, thus altering the BSA conformation to accommodate its hydrophobic/hydrophilic residues. Furthermore, the effects from such small amounts of BSA in the monolayer formation and stabilization mean that the AOT monolayer responds cooperatively to BSA.