Use of the activated coagulation time and heparin dose-response curve for the determination of protamine dosage in vascular surgery

A Standardized Bolus of 5 000 IU of Heparin Does not Lead to Adequate Heparinization during Non-cardiac Arterial Procedures

BACKGROUND

In non-cardiac arterial procedures (NCAP), heparin is administered to prevent arterial thromboembolic complications (ATEC). Heparin has a nonpredictable effect in the individual patient, also known as variation in heparin sensitivity. Various dosing protocols are in use, but the optimal dose is currently still unknown. A standardized bolus of 5 000 IU heparin is most frequently used by vascular surgeons and interventional radiologists. The activated clotting time (ACT) is an established method to measure the level of anticoagulation, but has, until now, not gained widespread use in NCAP. The purpose of this study was to evaluate the anticoagulant effect during NCAP of a standardized bolus of 5 000 IU heparin by measuring the ACT.

METHODS

In this prospective study, 190 patients undergoing NCAP were enrolled between December 2016 and September 2018. The ACT was measured during open and endovascular/hybrid procedures. All patients received a standardized bolus of 5 000 IU heparin. The ACT was measured by the Hemostasis Management System Plus (HMS Plus, Medtronic®), before, 5 minutes after administration of heparin, and every 30 minutes thereafter. The primary outcome was periprocedural ACT values measured. Secondary outcomes were ATEC and hemorrhagic complications.

RESULTS

A large individual patient variability in the response to heparin was found. The mean baseline ACT in all patients was 129 ± 18 s., and the mean ACT 5 minutes after the initial bolus of heparin was 191 ± 36 s. After the initial dose of 5 000 IU heparin 60 (33%) and 10 (6%) patients reached an ACT of 200 and 250 s., respectively. Despite the use of heparin, ATEC occurred in 17 patients (9%). The lowest number of ATEC occurred in the group of patients with an ACT between 200 and 250 s.

CONCLUSIONS

A standardized bolus of 5 000 IU heparin does not lead to adequate and safe heparinization in non-cardiac arterial procedures. Patient response to heparin shows a large individual variability. Therefore, routine ACT measurements are necessary to ascertain adequate anticoagulation. Further research is needed to investigate if heparin dosing based on the ACT could result in less arterial thromboembolic complications, without increasing hemorrhagic complications.

Individual Differences in Heparin Sensitivity and Their Effect on Heparin Anticoagulation During Arterial Vascular Surgery

OBJECTIVES

To investigate whether a fixed heparin dose results in adequate heparinisation levels and consequent inhibition of haemostatic activation in all patients.

METHODS

This prospective clinical pilot study included 24 patients undergoing arterial vascular surgery. Individual heparin responsiveness was assessed using the Heparin Dose Response (HDR) test, while the activated clotting time (ACT) and heparin concentration were measured to monitor the peri-procedural degree of anticoagulation. Finally, peri-operative haemostasis was evaluated with rotational thromboelastometry (ROTEM).

RESULTS

Eight patients were identified with reduced heparin sensitivity (RS group) and 16 patients with normal heparin sensitivity (NS group). Compared with the NS group, the RS group showed less prolonged ACTs after heparinisation with heparin concentrations below the calculated target heparin concentration. ROTEM revealed shorter clot formation times in the intrinsically activated coagulation test (INTEM) 3 min (114 ± 48 s vs. 210 ± 128 s) and 30 min after the initial heparin bolus (103 ± 48 s vs. 173 ± 81 s) in the RS group compared with the NS group. In the RS group, one patient developed a major thromboembolic complication.

CONCLUSIONS

This study shows that a third of the study population had reduced heparin sensitivity, which was associated with lower levels of heparinisation, and lower inhibition levels of clot initiation and clot formation. Identifying patients with reduced heparin sensitivity by monitoring the anticoagulant effect of heparin could decrease the risk of thrombotic complications after arterial vascular surgery.

Anticoagulation monitoring during vascular surgery: accuracy of the Hemochron ® low range activated clotting time (ACT-LR)

BACKGROUND

Activated clotting time (ACT) is currently used to monitor high concentrations of heparin anticoagulation. A new instrument, the Hemochron Jr Signature device, has been specifically designed to measure ACT in low-range heparin plasma concentrations (ACT-LR). The purpose of this study was to compare ACT-LR with anti-Xa activity in patients receiving low-dose i.v. heparin during vascular surgery.

METHODS

Thirty patients, undergoing arterial vascular surgery, were included in the study and received unfractionated heparin (initial dose 50 u kg(-1)). One hundred and thirty-two pairs of blood samples were simultaneously collected during surgery to determine ACT-LR and anti-Xa activity. Pearson correlation, Kappa test, ROC curve and a specific clinical interpretation of the correlation were performed.

RESULTS

ACT-LR ranged from 68 to 380 s, anti-Xa activity from 0 to 1.45 u ml(-1). We observed a strong correlation between anti-Xa activity and ACT-LR (r(2)=0.87; P<0.0001). Accuracy of ACT-LR was good for anti-Xa activity up to 0.6 u ml(-1) (Kappa, 0.94; accuracy, 97%) and 0.8 u ml(-1) (Kappa, 0.79; accuracy, 90%), and poor for anti-Xa activity above 1 u ml(-1) (Kappa, 0.59). A clinical interpretation of the correlation graph found 98% of measured ACT-LR values to be accurate.

CONCLUSION

Hemochron Jr Signature provides measurements of ACT-LR, which are accurate for monitoring heparin anticoagulation at anti-Xa activity below 0.8 u ml(-1).

Effect of heparin-bonded pulmonary artery catheters on the activated coagulation time

OBJECTIVE

This study evaluated the effect of a heparin-bonded pulmonary artery catheter (PAC) on the activated coagulation time (ACT).

DESIGN

A prospective, controlled comparison.

SETTING

A tertiary care university hospital.

PARTICIPANTS

Adult cardiac surgery patients.

INTERVENTIONS

Celite ACTs were measured from arterial and central venous blood samples before and after the insertion of a heparin-bonded PAC. Thromboelastograms were also obtained from central venous blood samples before and 2 minutes after PAC insertion.

MEASUREMENTS AND MAIN RESULTS

There was no significant difference between the sample sites before PAC insertion. After PAC insertion, the central venous ACTs were significantly increased compared with the corresponding arterial measurements at 2, 5, 10, and 20 minutes (p < 0.005, analysis of variance [ANOVA] for repeated measures, Fisher's protected least significant difference [PLSD]). The 2-minute post-PAC reaction time from the central venous blood sample was greater than 60 minutes in all cases.

CONCLUSION

The heparin-bonded PAC was associated with a localized, time-dependent alteration in the ACT. Whenever possible, blood samples for baseline ACT measurements should be obtained from an arterial catheter to minimize the anticoagulant effects from the PAC.