Development of a dispersive liquid–liquid microextraction method for spectrophotometric determination of barbituric acid in pharmaceutical formulation and biological samples

Ultrasensitive enantiomeric barbiturate analysis in body fluids through capillary electrophoresis with large volume sample stacking and ultrasound assisted dispersive liquid liquid microextraction

A rapid, straightforward, and sensitive approach to quantifying enantiomeric barbiturates in serum was developed by integrating ultrasound-assisted dispersive liquid-liquid microextraction (UA-DLLME) with large-volume sample stacking (LVSS) in capillary electrophoresis (CE). UA-DLLME was employed for sample preparation, and on-column preconcentration by using LVSS with polarity switching was implemented to enhance sensitivity. We thoroughly investigated and optimized various parameters influencing extraction and stacking to achieve optimal detection performance with the highest enrichment efficiencies. Under optimal extraction conditions (injection of a mixed solution containing 40 μL of CHCl3 and 200 μL of tetrahydrofuran into 1 mL of a sample solution at pH 10.0), LVSS was performed using 600 mM Tris-boric acid (pH 9.5) containing 35 mM hydroxypropyl-β-cyclodextrin and sodium taurodeoxycholate hydrate. A voltage of 20 kV was applied and a preinjection water plug was loaded at a height of 25 cm for 10 s. Subsequently, the sample solution was injected at a height of 25 cm for 480 s, after which a voltage of -20 kV was applied and the sample stacking was initiated. The stacking process was completed when 95 % of the separation current was attained. Under optimized conditions, the contraction folds of the four barbiturate analytes (R, S-Secobarbital, R, S-pentobarbital) were improved by approximately 6400-fold, achieving detection limits of 0.1 ng/mL. The limits of quantification for all analyte enantiomers were 0.5-50 ng/mL, demonstrating good linearity (r > 0.997). Migration times exhibited a relative standard deviation of less than 1.7 %, whereas peak areas for the four analytes exhibited a deviation of 8.7 %. Finally, the established method was effectively applied to the analysis of human serum samples.

Ultrasound and surfactant-assisted dispersive liquid-liquid microextraction prior to poly(ethylene oxide)-mediated stacking in CE for highly sensitive determination of barbiturates in human fluids

This study developed a facile, highly sensitive technique for extracting and quantifying barbiturates in serum samples. This method combined ultrasound and surfactant-assisted dispersive liquid-liquid microextraction with poly(ethylene oxide)-mediated stacking in capillary electrophoresis. Factors influencing the extraction and stacking performance, such as the type and volume of extraction solvents, the type and concentration of surfactant, extraction time, salt additives, sample matrix, solution pH, and composition of the background electrolyte, were carefully studied and optimized to achieve the optimal detection sensitivity. Under the optimized extraction (injecting 140 μL C2 H4 Cl2 into 1 mL of sample with pH 4 (5 mM sodium phosphate containing 0.05 mM Tween 20 and sonication for 1 min) and separation conditions (150 mM tris(hydroxymethyl)aminomethane-borate with pH 8.5 containing 0.5% (m/v) poly(ethylene oxide)), the limits of detection (signal-to-noise ratio = 3) of five barbiturates ranged from 0.20 to 0.33 ng/mL, and the calculated sensitivity improvement ranged from 868- to 1700-fold. The experimental results revealed excellent linearity (R2  > 0.99), with relative standard deviations of 2.1%-3.4% for the migration time and 4.3%-5.7% for the peak area. The recoveries of the spiked serum samples were 97.1% -110.3%. Our proposed approach offers a rapid and practical method for quantifying barbiturates in biological fluids.

An expedient metal-free cascade route to chromonyl diene scaffolds: thermodynamic vs. kinetic control

A piperidine-catalyzed reaction between 3-formylchromone, 1,3-dimethyl barbituric acid, and ylidenemalononitriles is developed that offers chromonyl diene products in good yields. This cascade reaction proceeds via the insertion of ylidenemalononitriles between the Knoevenagel adduct obtained from 3-formylchromone and 1,3-dimethylbarbituric acid, where the pyrimidine-based enaminone is integrated with the chromone through the central diene linker. Similarly, introducing pyrimidine-based enaminone into the terminal part of the chromonyl diene scaffold gave an equilibrium mixture of rotational isomers in DMSO, which could be separated and isolated by crystallization. The computational analysis confirmed the role of barbiturate in directing the type of final chromonyl diene via kinetic or thermodynamic control. Moreover, computations revealed that one of these species, observed in the NMR spectra, is produced by the bond cleavage in the spirocyclic intermediate.

A Cost-Effective Way to Produce Gram-Scale 18O-Labeled Aromatic Aldehydes

Obtaining ¹⁸O-labeled organic substances is of great research importance and also an extremely challenging work. In this work, depending on the reversed Knoevenagel reaction, ¹⁸O-labeled aromatic aldehydes (3a-3x) are successfully obtained with high total yields (52-72%) and sufficient ¹⁸O abundance (90.90-96.09%).

New developments on ultrasound-assisted processing and flavor detection of spices: A review

Spices are widely used to add unique flavors to food; such uniqueness may, however, suffer significant loss during processing, which is in many cases needed to preserve or transform spices into food ingredients. Here, the effects of ultrasound-assisted drying, extraction and microencapsulation on flavor of spices along with selected progresses made on ultrasonic detection of the flavor are reviewed. Flavors of some spices, e.g., laurel, onion and peppermint, dried with the aid of ultrasound are noted to be better than those of shade-dried, infrared, microwave and hot-air dried products. Ultrasound-assisted extraction can be effectively used to extract essential oils or oleoresins from spices. Compared with selected extraction methods, the variety of flavor substances obtained via ultrasound-assisted extraction is richer and their concentrations are also higher, making the flavors of the extracts stronger. Ultrasound-assisted microencapsulation has noted to increase the compound embedding and loading ratios, resulting in better maintenance of flavor over a longer period of time. Ultrasound has finally proved to be an efficient, green, economical and sensitive flavor detection technology for spices.

Determination of Barbiturates in Biological Specimens by Flat Membrane-Based Liquid-Phase Microextraction and Liquid Chromatography-Mass Spectrometry

The wide abuse of barbiturates has aroused extensive public concern. Therefore, the determination of such drugs is becoming essential in therapeutic drug monitoring and forensic science. Herein, a simple, efficient, and inexpensive sample preparation technique, namely, flat membrane-based liquid-phase microextraction (FM-LPME) followed by liquid chromatography-mass spectrometry (LC-MS), was used to determine barbiturates in biological specimens. Factors that may influence the efficiency including organic extraction solvent, pH, and composition of donor and acceptor phases, extraction time, and salt addition to the sample (donor phase) were investigated and optimized. Under the optimized extraction conditions, the linear ranges of the proposed FM-LPME/LC-MS method (with correlation coefficient factors ≥ 0.99) were 7.5–750 ng mL⁻¹ for whole blood, 5.0–500 ng mL⁻¹ for urine, and 25–2500 ng g⁻¹ for liver. Repeatability between 5.0 and 13.7% was obtained and the limit of detection (LOD) values ranged from 1.5 to 3.1 ng mL⁻¹, from 0.6 to 3.6 ng mL⁻¹, and from 5.2 to 10.0 ng g⁻¹ for whole blood, urine, and liver samples, respectively. This method was successfully applied for the analysis of barbiturates in blood and liver from rats treated with these drugs, and excellent sample cleanup was achieved.

Development of Dispersive Liquid-Liquid Microextraction method combined with UV spectrophotometry for the Determination of Malathion Pesticide

A simple and novel method was developed by combination of dispersive liquid-liquid microex-traction with UV spectrophotometry for the preconcentartion and determination of trace amount of malathion. The presented method is based on using a small volume of ethylenechloride as the extraction solvent was dissolved in ethanol as the dispersive solvent, then the binary solution was rapidly injected by a syringe into the water sample containing malathion. The important parame-ters, such the type and volume of extraction solvent and disperser solvent, the effect of extraction time and rate, the effect of salt addition and reaction conditions were studied. At the optimum conditions, the calibration graph was linear in the range of 2-100 ng mL-1 of malathion with a limit of detection of 0.8 ng L-1. In addition, the enrichment factor was 30. The developed method was successfully applied for the determination of malathion pesticide in water samples

Dispersive liquid-liquid microextraction: trends in the analysis of biological samples

Dispersive liquid-liquid microextraction (DLLME) is a recent microextraction technique that was first developed by Rezaee and co-workers in 2006. It allows the simultaneous extraction and preconcentration of analytes into a micro-volume of extracting solvent based on a ternary solvent system involving an aqueous phase, a nonpolar water immiscible high-density solvent that acts as extraction phase, and a disperser solvent, which is often polar and water miscible. This article presents an overview of DLLME applications in the analysis of biological samples (e.g., plasma and urine). Aside from the classical DLLME applications using high density extraction solvents, recent advances in the use of low density solvents and ionic liquids are also discussed. Although most of the applications deal with the analysis of organic target compounds, a few applications on the bioanalysis of inorganic substances are also included.

Recent advances in unique sample preparation techniques for bioanalysis

The extraction and/or purification of drugs and medicines from biological matrices are important objectives in investigating their toxicological and pharmaceutical properties. Many widely used methods such as liquid–liquid extraction or SPE, used for extracting, purifying and enriching drugs and medicines found in biological materials, involve laborious, intensive and expensive preparatory procedures, and they require organic solvents that are toxic to both humans and the environment. Recent trends are focused on miniaturization, high-throughput and automation techniques. All the advantages and disadvantages of these techniques and devices in biological analysis are presented, and their applications in the extraction and/or purification of drugs and medicines from biological matrices are discussed in this review.

Role of microextraction sampling procedures in forensic toxicology

The last two decades have provided analysts with more sensitive technology, enabling scientists from all analytical fields to see what they were not able to see just a few years ago. This increased sensitivity has allowed drug detection at very low concentrations and testing in unconventional samples (e.g., hair, oral fluid and sweat), where despite having low analyte concentrations has also led to a reduction in sample size. Along with this reduction, and as a result of the use of excessive amounts of potentially toxic organic solvents (with the subsequent environmental pollution and costs associated with their proper disposal), there has been a growing tendency to use miniaturized sampling techniques. Those sampling procedures allow reducing organic solvent consumption to a minimum and at the same time provide a rapid, simple and cost-effective approach. In addition, it is possible to get at least some degree of automation when using these techniques, which will enhance sample throughput. Those miniaturized sample preparation techniques may be roughly categorized in solid-phase and liquid-phase microextraction, depending on the nature of the analyte. This paper reviews recently published literature on the use of microextraction sampling procedures, with a special focus on the field of forensic toxicology.

An overview of liquid phase microextraction approaches combined with UV-Vis spectrophotometry

Ultraviolet and visible spectrophotometer has become a popular analytical instrument in the modern day laboratories. However, the low concentrations of many analytes in samples make it difficult to directly measure them by UV-Vis spectrophotometry. This overview focuses on the combinations of microvolume UV-Vis spectrophotometry with miniaturized approaches to sample preparation, namely, single drop microextraction (SDME), dispersive liquid-liquid microextraction (DLLME), cold induced aggregation microextraction (CIAME), in situ solvent formation microextraction (ISSFME), ultrasound assisted emulsification microextraction (USAEME), solidified floating organic drop microextraction (SFODME), and hollow fiber based liquid phase microextraction (HF-LPME) to improve both the selectivity and sensitivity. Integration of these techniques provides unique advantages which include availability, simplicity of operation, low cost, speed, precision and accuracy; hence making them a powerful tool in chemical analysis.