Determination of metals in coal fly ashes using ultrasound-assisted digestion followed by inductively coupled plasma optical emission spectrometry

Simultaneous Determination of REEs in Coal Samples Using the Combination of Microwave-Assisted Ashing and Ultrasound-Assisted Extraction Methods Followed by ICP-OES Analysis

The world during the COVID-19 pandemic has led to extensive use of virtual activities by means of electronic devices, which are made up of rare earth elements (REEs). This means that quantitative knowledge of REEs in various resources is crucial for the development of effective recovery methods. Therefore, this report describes a simple microwave assisted ashing followed by ultrasound-assisted extraction (MAA-UAE) for quantitative determination of REEs in coal samples using inductively coupled plasma-optical emission spectroscopy (ICP-OES). Firstly, coal samples were ashed at 55 °C for 4.5 h to form white ashes, which were then treated with dilute HNO3 acid under ultrasonication to enhance the extraction of REEs. The quantitative recoveries (86–120%) of REEs were obtained when 1 mol L−1, 0.1 g, 40 °C, 20 min, and high frequency were applied for [HNO3], sample mass, ultrasonic bath temperature, extraction time, and ultrasonic bath frequency, respectively. The method detection limits of the proposed MAA-UAE method were between 0.0075 and 0.59 µg g−1 with satisfactory precision (<5%). The concentration levels of REEs in South African coals ranged from 1.4 to 105 µg g−1, suggesting that this coal can be a resource for REEs.

Multi-elemental analysis of particulate matter PM2.5 and PM10 by ICP OES

The complexity of aerodynamic particulate matter's (PM) matrices poses a challenge for the extraction and quantification of metals, especially for analytes with low concentration. Aiming to solve this issue, a precise and accurate protocol with the ultrasound extraction combined with microwave radiation digestion (USMW), was applied to PM samples with excellent compensations in sample throughput, digestion efficiency, and energy consumption. After the digestion and extraction procedures, the inorganic analytes, including rare earth elements, were determined by ICP OES. Two types of particulate matter sampled from two stations, Gobernacion (GOB10 and GOB2.5) and Milan (MIL10), corresponding to PM_2.5 and PM₁₀, were digested with a combination between HF, HNO₃, and H₃BO₃. The absolute limits of detection ranged from 0.42 pg m^-³ for V, to 3459 pg m^-³ for As. The accuracy of the experimental study was assessed using two certified reference materials (CRMs), Coal Fly Ash (NIST1633b) and Fly Ash (BCR176). The method presented good accuracy, with recoveries ranging from 90 to 115%, except for Al (120%) and Fe (123%). Considering the replicates for the determination of analyte elements, the repeatability was below 10% for the relative standard deviation (RSD). A cloud point extraction (CPE) procedure, with parameters optimized for the determination of Pd and Pt, was successfully applied in digested PM samples with detection limits of 1.43 and 2.05 pg m^-³ for Pd and Pt in MIL10 sample, respectively, and 76.6 pg m^-³ for Pd and 110 pg m^-³ for Pt, in samples GOB10 and GOB2.5, respectively.