Desorption atmospheric pressure photoionization with polydimethylsiloxane as extraction phase and sample plate material

The ionization mechanisms in direct and dopant-assisted atmospheric pressure photoionization and atmospheric pressure laser ionization

A novel, gas-tight API interface for gas chromatography-mass spectrometry was used to study the ionization mechanism in direct and dopant-assisted atmospheric pressure photoionization (APPI) and atmospheric pressure laser ionization (APLI). Eight analytes (ethylbenzene, bromobenzene, naphthalene, anthracene, benzaldehyde, pyridine, quinolone, and acridine) with varying ionization energies (IEs) and proton affinities (PAs), and four common APPI dopants (toluene, acetone, anisole, and chlorobenzene) were chosen. All the studied compounds were ionized by direct APPI, forming mainly molecular ions. Addition of dopants suppressed the signal of the analytes with IEs above the IE of the dopant. For compounds with suitable IEs or Pas, the dopants increased the ionization efficiency as the analytes could be ionized through dopant-mediated gas-phase reactions, such as charge exchange, proton transfer, and other rather unexpected reactions, such as formation of [M + 77](+) in the presence of chlorobenzene. Experiments with deuterated toluene as the dopant verified that in case of proton transfer, the proton originated from the dopant instead of proton-bound solvent clusters, as in conventional open or non-tight APPI sources. In direct APLI using a 266 nm laser, a narrower range of compounds was ionized than in direct APPI, because of exceedingly high IEs or unfavorable two-photon absorption cross-sections. Introduction of dopants in the APLI system changed the ionization mechanism to similar dopant-mediated gas-phase reactions with the dopant as in APPI, which produced mainly ions of the same form as in APPI, and ionized a wider range of analytes than direct APLI.

Carbon disulfide as a dopant in photon-induced chemical ionization mass spectrometry

RATIONALE

The addition of a dopant to an Atmospheric Pressure PhotoIonization (APPI) source of a mass spectrometer has been shown to enhance the degree of analyte ionization. A series of different dopants has been successfully utilized; however, there has been very little published on the characteristics of a good dopant. We have proposed carbon disulfide (CS2) as a novel new dopant based on its absorption cross-section for the VUV photon's energy used and its unique gas-phase ion chemistry, notably the fact that it does not contain a proton.

METHODS

The ability of CS2 to enhance the ionization effectiveness of APPI was tested by using a group of compounds that have different proton affinities (PAs) and electron affinities (EAs). These results were compared to results obtained using the commonly used dopants, toluene and anisole. Particular attention was paid to the formation of [M](+) ions relative to [M+H](+) ions. Mass spectra were collected using a Waters Quattro Premier liquid chromatography/tandem mass spectrometry (LC/MS/MS) system equipped with a commercial Photomate™ photoionization source.

RESULTS

The results show that CS2 increases the ionization efficiency of most of the analytes studied in this work comparably to toluene and anisole. CS2 promotes both ionization routes of [M](+) and [M+H](+). In addition, due to the higher ionization energy (IE) of CS2 (10.01) compared to the IEs of toluene (8.83) and anisole (8.20), CS2 can enhance the ionization efficiency of analytes that cannot be enhanced with toluene and anisole.

CONCLUSIONS

We have determined that CS2 is a viable dopant for use in APPI sources. For some analytes, significant [M+H](+) ion signals are observed; therefore, the donated proton must come from either water clusters or solvents. In addition, CS2 promotes the ionization of analytes with low PAs and higher IEs than that of toluene and anisole.

Analysis of lipids with desorption atmospheric pressure photoionization-mass spectrometry (DAPPI-MS) and desorption electrospray ionization-mass spectrometry (DESI-MS)

In this article, the effect of spray solvent on the analysis of selected lipids including fatty acids, fat-soluble vitamins, triacylglycerols, steroids, phospholipids, and sphingolipids has been studied by two different ambient mass spectrometry (MS) methods, desorption electrospray ionization-MS (DESI-MS) and desorption atmospheric pressure photoionization-MS (DAPPI-MS). The ionization of the lipids with DESI and DAPPI was strongly dependent on the spray solvent. In most cases, the lipids were detected as protonated or deprotonated molecules; however, other ions were also formed, such as adduct ions (in DESI), [M-H](+) ions (in DESI and DAPPI), radical ions (in DAPPI), and abundant oxidation products (in DESI and DAPPI). DAPPI provided efficient desorption and ionization for neutral and less polar as well as for ionic lipids but caused extensive fragmentation for larger and more labile compounds because of a thermal desorption process. DESI was more suitable for the analysis of the large and labile lipids, but the ionization efficiency for less polar lipids was poor. Both methods were successfully applied to the direct analysis of lipids from pharmaceutical and food products. Although DESI and DAPPI provide efficient analysis of lipids, the multiple and largely unpredictable ionization reactions may set challenges for routine lipid analysis with these methods.