Microporous silica with nanolayer structure coated with renewable organic solvent film as a novel extracting phase: A combination of solid- and liquid-phase microextraction

Sponge-like porous manganese(II, III) oxide as a coating for solvent-assisted solid-phase microextraction of polycyclic aromatic hydrocarbons followed by gas chromatography-mass spectrometry

A nanostructure sponge-like porous manganese(II, III) oxide was synthesized and applied as a new fiber coating for solvent-assisted solid-phase microextraction. The synthesized material was characterized via Fourier-transform infrared spectroscopy, scanning electron microscopy, thermogravimetric analysis, X-ray diffraction, and N₂ adsorption/desorption techniques. To investigate the extraction performance of the prepared material, direct immersion solid-phase microextraction followed by gas chromatography-mass spectrometry was used for the determination of the selected polycyclic aromatic hydrocarbons in wastewater samples. Three polycyclic aromatic hydrocarbons including 1-methylnaphthalene, anthracene, and pyrene were selected as model analytes. To maximize the sensitivity of the method, key experimental factors affecting the extraction efficiency of the analytes such as ionic strength, extraction solvent, stirring rate, extraction temperature and time, and desorption temperature and time were optimized. The applicability of the new coating material for the extraction of the selected analytes from wastewater samples was evaluated. Under the optimum conditions, detection limits between 0.7 and 1.5 ng L^-1 were obtained for the model analytes. The linear dynamic range was 5.0-3.0 × 10³ ng L^-1 for all the analytes. Relative standard deviations were between 2 and 11%. In the case of real sample analysis, the extraction recoveries of the analytes were obtained in the range of 77-111%.

Implementing a superhydrophobic substrate in immersed solvent-supported microextraction as a novel strategy for determination of organic pollutants in water samples

In this research, a new approach for extraction and determination of polycyclic aromatic hydrocarbons from sea and rain water samples was developed by implementing a superhydrophobic substrate and consuming the least amount of solvent. This version of solvent-supported microextraction enabled us to perform the procedure in the immersion mode with the slightest troubles arising from water leakage into the gas chromatography. The superhydrophobic property leads to the fixation of extracting solvent on the substrate surface during water sampling. To prepare a superhydrophobic substrate, a piece of melamine foam was coated by tannic acid and silica nanoparticles using methyltrimethoxysilane and tetramethyl orthosilicate. The morphology of the prepared foams was studied by scanning electron microscopy. The developed solvent-supported microextraction method in combination with gas chromatography-mass spectrometry was applied to the isolation and determination of some typical polycyclic aromatic hydrocarbons from aquatic media. Influential parameters such as substrate nature, extractive solvent, eluting solvent and its quantity and extraction time were investigated. The limits of detection and quantification of the method under the optimized conditions were 0.01-0.11 µg L^-1 and 0.03-1.01 µg L^-1, respectively. The relative standard deviations at the concentration level of 20 µg L^-1 were between 3% and 14% (n = 3). The linearity of calibration curves ranged from 0.03 to 60 µg L^-1. The implementation of the solvent-supported method to the analysis of real water samples was quite successful and the relative recoveries were between 88% and 107%.