Towards a high peak capacity of 130 using nanoflow hydrophilic interaction liquid chromatography

Preparation of high-efficiency HILIC capillary columns utilizing slurry packing at 2100 bar

Complex mixture analysis requires high-efficiency chromatography columns. Although reversed phase liquid chromatography (RPLC) is the dominant approach for such mixtures, hydrophilic interaction liquid chromatography (HILIC) is an important complement to RPLC by enabling the separation of polar compounds. Chromatography theory predicts that small particles and long columns will yield high efficiency; however, little work has been done to prepare HILIC columns longer than 25 cm packed with sub-2 μm particles. In this work, we tested the slurry packing of 75 cm long HILIC columns with 1.7 μm bridged-ethyl-hybrid amide HILIC particles at 2,100 bar (30,000 PSI). Acetonitrile, methanol, acetone, and water were tested as slurry solvents, with acetonitrile providing the best columns. Slurry concentrations of 50-200 mg/mL were assessed, and while 50-150 mg/mL provided comparable results, the 150 mg/mL columns provided the shortest packing times (9 min). Columns prepared using 150 mg/mL slurries in acetonitrile yielded a reduced minimum plate height (hmin) of 3.3 and an efficiency of 120,000 theoretical plates for acenaphthene, an unretained solute. Para-toluenesulfonic acid produced the lowest hmin of 1.9 and the highest efficiency of 210,000 theoretical plates. These results identify conditions for producing high-efficiency HILIC columns with potential applications to complex mixture analysis.

Polarity-extended liquid chromatography-triple quadrupole mass spectrometry for simultaneous hydrophilic and hydrophobic metabolite analysis

Although various metabolomic methods have been reported in recent years, simultaneous detection of hydrophilic and hydrophobic metabolites in a single analysis remains a technical challenge. In this study, based on the combination of hydrophilic interaction liquid chromatography (HILIC) and reversed phase liquid chromatography (RPLC), an online two-dimensional liquid chromatography/triple quadrupole mass spectrometry method (2D-LC/TQMS) was developed for the simultaneous analysis of hydrophilic and hydrophobic metabolites of various biological samples. The method can measure 417 biologically important metabolites (e.g., amino acids and peptides, pyrimidines, purines, monosaccharides, fatty acids and conjugates, organic dicarboxylic acids, and others) with logP values ranging from -10.3 to 21.9. The metabolites are involved in a variety of metabolic pathways (e.g., purine metabolism, pyrimidine metabolism, tyrosine metabolism, galactose metabolism, gluconeogenesis, and TCA cycle). The developed method has good intra- and inter-day reproducibility (RSD of retention time <2%, RSD of peak area <30%), good linearity (R2 > 0.9) and wide linear range (from 0.0025 μg/mL to 5 μg/mL). The applicability of the method was tested using different biological samples (i.e., plasma, serum, urine, fecal, seminal plasma and liver) and it was found that 208 (out of 417) identical metabolites were detected in all biological samples. Furthermore, the metabolomic method was applied to a case/control study of urinary of bladder cancer. Thirty differential metabolites were identified that were involved in carbohydrate and amino acid metabolism.

Nano-liquid chromatography with monolithic stationary phase based on naphthyl monomer for proteomics analysis

Monolithic poly(2-vinylnaphthalene-co-divinylbenzene) columns were introduced, for the first time, and were evaluated as the separation media for nano-liquid chromatography (nano-LC). These columns were prepared by in-situ polymerization of 2-vinylnaphthalene (2-VNA) as the functional monomer and divinylbenzene (DVB) as the crosslinker in a fused silica capillary column of 50 µm i.d. Various porogenic solvents, including tetrahydrofuran (THF), dodecanol and toluene were used for morphology optimization. Final monolithic column (referred to as VNA column) was characterized by using scanning electron microscopy (SEM) and chromatographic analyses. Alkylbenzenes (ABs), and polyaromatic hydrocarbons (PAHs) were separated using the VNA column while the column offered excellent hydrophobic and π-π interactions under reversed-phase conditions. Theoretical plates number up to 41,200 plates/m in isocratic mode for ethylbenzene could be achieved. The potential of the final VNA column was demonstrated with a gradient elution in the  separation of six intact proteins, including ribonuclease A (RNase A), cytochrome C (Cyt C), lysozyme (Lys), β-lactoglobulin (β-lac), myoglobin (My) and α-chymotrypsinogen (α-chym) in nano LC system. The column was then applied to the peptide analysis of trypsin digested cytochrome C, allowing a high peak capacity up to 1440 and the further proteomics analysis of COS-7 cell line was attempted applying the final monolithic column in nano-LC UV system.

Separation of Panax notoginseng saponins on modified rosin ester-bonded silica stationary phase and its mechanism

A column prepared using a unique three-membered phenanthrene skeleton of rosin has complementary selectivity to a C18 column for some separation tasks. In this study, propylene pimaric acid (16-hydroxyethyl acrylate-34-n-butyl) ester (BRB) and propylene pimaric acid (16-hydroxyethyl acrylate-34-dodecyl) ester (BRLA) were used as functional ligands to prepare two novel stationary phases, namely BRB@SiO₂ and BRLA@SiO₂, through a "thiol-ene" click chemistry reaction. The characterization results of Fourier transform infrared spectroscopy, thermogravimetric analysis, nitrogen adsorption-desorption measurements, and contact angle tests showed that the BRB@SiO₂ and BRLA@SiO₂ stationary phases were successfully prepared. In addition, the performance of the columns was evaluated using the Tanaka test and hydrophobic subtraction model, which showed that the stationary phases exhibited typical reversed-phase chromatography performance and good hydrophobicity, hydrophobic selectivity, and steric selectivity. The changes in the retention of Panax notoginseng saponins on a column under different chromatographic conditions (acetonitrile content, flow rate, and column temperature) were investigated. The separation effect of BRB@SiO₂ and BRLA@SiO₂ columns on P. notoginseng saponins was better than that of the C18 column and the BRLA@SiO₂ column could replace the C18 column for the detection of P. notoginseng saponins.

Nano-liquid chromatography with a new nano-structured monolithic nanocolumn for proteomics analysis

Herein, we report the preparation and application of a new nano-structured monolithic nanocolumn based on modified graphene oxide using narrow fused silica capillary column (e.g., 50 μm internal diameter). The nanocolumn was prepared by an in situ polymerization using butyl methacrylate, ethylene dimethacrylate, and methacryloyl graphene oxide nanoparticles. Dimethyl formamide and water were used as the porogenic solvent. After polymerization, the obtained nanocolumn was coated with dimethyloctadecylchlorosilane in order to enhance the hydrophobicity. Both isocratic and gradient nano-liquid chromatographic separations for small molecules (e.g., alkylbenzenes) and macromolecules (e.g., intact proteins) were performed. Theoretical plates number up to 3600 plates/m in isocratic mode for propylbenzene were achieved. It was demonstrated that the feasibility of graphene oxide modified monolithic nanocolumn for high-efficiency and high-throughput nanoscale proteomics analysis. The high resolving power of monolithic nanocolumn yielded sensitive protein separation with narrower peak width while a high-resolution analysis of peptides from trypsin-digested cytochrome C could be obtained. Graphene oxide based monolithic nanocolumns are promising and can allow to powerful tools for trace proteom sample analysis.

Segmented Microfluidics-Based Packing Technology for Chromatographic Columns

Nanoflow liquid chromatography-mass spectrometry (NanoLC-MS) has become the method of choice for the analysis of complex biological systems, especially when the available sample amount is limited. The preparation of high-performance capillary columns for nanoLC use is still a technical challenge. Here, we report a segmented microfluidic method for the preparation of packed capillary columns, where liquid segments were used as soft, dynamic, and well-dispersed slurry reservoirs for carrying and delivering micrometer packing particles. Based on this microfluidic packing technology, the column bed was assembled layer-by-layer at a 50 μm resolution, and ultralong capillary columns of 3, 5, and 10 m were fabricated in such a manner. The microfluidically packed columns demonstrated excellent separation efficiencies of 116 000 plates/m. The higher efficiencies obtained at higher slurry concentrations also indicate that a high-quality packed bed can be obtained without sacrificing the packing speed. Kinetic performance limit analysis shows that the microfluidic packed columns have higher peak capacity production efficiency in the high-resolution region, presenting an improved separation impedance of 2800, which is significantly better than columns packed with the conventional slurry packing method. In comparison with a commercial nanoLC column, a 5 m long microfluidic packed column was evaluated for proteomic analysis using a standard HeLa protein digest and presented 261% improvement in peptide identification capability, resulting in significantly enhanced protein identification confidence.

Performance of nanoflow liquid chromatography using core-shell particles: A comparison study

Due to its unique structure, core-shell material has presented significantly improved chromatographic performance in comparison with conventional totally porous material. This has been well demonstrated in the analytical column format, e.g. 4.6 mm i.d. columns. In the proteomics field, there is always a demand for high resolution microseparation tools. In order to explore core-shell material's potential in proteomics-oriented microseparations, we investigated chromatographic performance of core-shell material in a nanoLC format, as well as its resolving power for protein digests. The results show core-shell nanoLC columns have similar van Deemter curves to the totally porous particle-packed nanoLC columns. For 100 µm i.d. capillary columns, the core-shell material does not have significantly better dynamics. However, both core-shell and totally porous particle-packed nanoLC columns have shown high efficiencies: plate heights of ~11 µm, equivalent to 90000 plates per meter, have been achieved with 5 µm particles. Using a 60 cm long core-shell nanoLC column, 72000 plates were realized in an isocratic separation of neutral compounds. For a 15 cm long nanoLC column, a maximum peak capacity of 220 has been achieved in a 5 hour gradient separation of protein digests, indicating the high resolving power of core-shell nanoLC columns. With a standard HeLa cell lysate as the sample, 2546 proteins were identified by using the core-shell nanoLC column, while 2916 proteins were identified by using the totally porous particle-packed nanoLC column. Comparing the two sets of proteomics data, it was found that 1830 proteins were identified by both columns, while 1086 and 716 proteins were uniquely identified by using totally porous and core-shell particle-packed nanoLC columns, respectively, suggesting their complementarity in nanoLC-MS based proteomics.

Strong hydrophilic monolithic column functionalized with amphiphilic benzyl quinine for capillary electrochromatography and application in pharmaceutical analysis

An innovative strong hydrophilic organic polymer monolithic column of poly(N-benzylquininium chloride-co-1, 3, 5-triacryloylhexahydro-1, 3, 5-triazine) (poly(NBQ-co-TAT)) has been successfully synthesized through in situ copolymerization for capillary electrochromatography. The amphiphilic monomer NBQ and the strong polar cross-linker TAT are firstly used in hydrophilic electrochromatography by taking advantage of the exhibition of hydrophilicity at lower levels of organic solvent and ease formation of porous structure. The monolithic column poly(NBQ-co-TAT) shows powerful hydrophilic selectivity with mobile phase containing more than 60% organic solvent. The introduction of NBQ and TAT enlarges the sources of functional monomers and cross-linkers for HILIC. Due to the presence of the positively charged group in NBQ, an anodic electroosmotic flow is generated with the change of pH values from 2.0 to 12.0. The monolithic column was used for the separations of thioureas, phenols, xanthines, nucleobases, acidic substances and pharmaceuticals. The highest column efficiency for N, N'-dimethylthiourea is 1.15 × 10⁵ N m^-1. The application of the monolithic column for a real sample, cytochrome C digestion indicates its great potential in practical application.

Liquid chromatography above 20,000 PSI

Continued improvements in HPLC have led to faster and more efficient separations than previously possible. One important aspect of these improvements has been the increase in instrument operating pressure and the advent of ultrahigh pressure LC (UHPLC). Commercial instrumentation is now capable of up to ~20 kpsi, allowing fast and efficient separations with 5-15 cm columns packed with sub-2 μm particles. Home-built instruments have demonstrated the benefits of even further increases in instrument pressure. The focus of this review is on recent advancements and applications in liquid chromatography above 20 kpsi. We outline the theory and advantages of higher pressure and discuss instrument hardware and design capable of withstanding 20 kpsi or greater. We also overview column packing procedures and stationary phase considerations for HPLC above 20 kpsi, and lastly highlight a few recent applicatioob pressure instruments for the analysis of complex mixtures.