Molecularly imprinted fluoroprobes doped with Ag nanoparticles for highly selective detection of oxytetracycline in real samples

High enrichment and sensitive measurement of oxytetracycline in tea drinks by thermosensitive magnetic molecular imprinting based magnetic solid phase extraction coupled with boron doped carbon dots

As a typical kind of new pollutants, there are still some challenges in the rapid detection of antibiotics. In this work, a sensitive fluorescent probe based on boron-doped carbon dots (B-CDs) in combination with thermo-responsive magnetic molecularly imprinted polymers (T-MMIPs) was constructed for the detection of oxytetracycline (OTC) in tea drinks. T-MMIPs were designed, fabricated and employed to enrich OTC at trace level from tea drinks, and B-CDs were utilized as the fluorescent probe to detect the concentration of OTC. The proposed method exhibited good linear relationship with OTC concentration from 0.2 to 60 μg L-1 and the limit of detection was 0.1 μg L-1. The established method has been successfully validated with tea beverages. Present work was the first attempt application of T-MMIPs in combination with CDs in detection of OTC, and demonstrated that the proposed method endowed the detection of OTC with high selectivity, sensitivity, reliability and wide application prospect, meanwhile offered a new strategy for the method establishment of rapid and sensitive detection of trace antibiotics in food and other matrices.

Molecularly imprinted polymers-isolated AuNP-enhanced CdTe QD fluorescence sensor for selective and sensitive oxytetracycline detection in real water samples

A molecularly imprinted polymers (MIPs)-isolated AuNP-enhanced fluorescence sensor, AuNP@MIPs-CdTe QDs, was developed for highly sensitive and selective detection of oxytetracycline (OTC) in aqueous medium. The developed sensor combined the advantages of strong fluorescence signal of metal-enhanced fluorescence (MEF), high selectivity of MIPs, and stability of CdTe QDs. The MIPs shell with specific recognition served as an isolation layer to adjust the distance between AuNP and CdTe QDs to optimize the MEF system. The sensor demonstrated the detection limit as low as 5.22 nM (2.40 μg/L) for a concentration range of 0.1-3.0 μM OTC and good recovery rates of 96.0-103.0% in real water samples. In addition, high specificity recognition for OTC over its analogs was achieved with an imprinting factor of 6.10. Molecular dynamics (MD) simulation was utilized to simulate the polymerization process of MIPs and revealed H-bond formation as the mainly binding sites of APTES and OTC, and finite-difference time-domain (FDTD) analysis was employed to obtain the distribution of electromagnetic field (EM) for AuNP@MIPs-CdTe QDs. The experimental results combined with theoretical analyses not only provided a novel MIP-isolated MEF sensor with excellent detection performance for OTC but also established a theoretical basis for the development of a new generation of sensors.

Excitation-depended fluorescence emission of boron-doped graphene quantum dot as an optical probe for detection of oxytetracycline in food and information encryption patterns

The boron-doped graphene quantum dot (HSE-GQD-B) was prepared by thermal pyrolysis of the mixture of citric acid, histidine, serine and ethylenediamine and boric acid. The resulting HSE-GQD-B is composed of tiny graphene sheets with an average sheet size of 4.2 ± 0.16 nm and exhibits an excitation-depended fluorescence emission behavior. The HSE-GQD-B produces the strongest blue fluorescence of 450 nm wavelength under the excitation of 365-nm ultraviolet light and the strongest yellow fluorescence of 550-nm wavelength under the excitation of 470-nm visible light. The interaction of HSE-GQD-B with oxytetracycline molecule induces a sensitive blue fluorescence quenching process. Based on this characteristic, a fluorescence method was established for optical detection of oxytetracycline. The analytical method offers a better sensitivity, selectivity, and repeatability compared with previously reported methods. The detection of oxytetracycline attains a wide linear range of 0.02-50 μM and a detection limit of 0.0067 μM. It has been successfully applied to fluorescence detection of oxytetracycline in food samples. In addition, the HSE-GQD-B was also used as a multicolor fluorescence probe for information encryption patterns.

A Turn-Off Fluorescent Biomimetic Sensor Based on a Molecularly Imprinted Polymer-Coated Amino-Functionalized Zirconium (IV) Metal-Organic Framework for the Ultrasensitive and Selective Detection of Trace Oxytetracycline in Milk

Developing sensitive and effective methods to monitor oxytetracycline residues in food is of great significance for maintaining public health. Herein, a fluorescent sensor (NH₂-UIO-66 (Zr)@MIP) based on a molecularly imprinted polymer-coated amino-functionalized zirconium (IV) metal-organic framework was successfully constructed and first used for the ultrasensitive determination of oxytetracycline. NH₂-UIO-66 (Zr), with a maximum emission wavelength of 455 nm under 350 nm excitation, was prepared using a microwave-assisted heating method. The NH₂-UIO-66 (Zr)@MIP sensor with specific recognition sites for oxytetracycline was then acquired by modifying a molecularly imprinted polymer on the surface of NH₂-UIO-66 (Zr). The introduction of NH₂-UIO-66 (Zr) as both a signal tag and supporter can strengthen the sensitivity of the fluorescence sensor. Thanks to the combination of the unique characteristics of the molecularly imprinted polymer and NH₂-UIO-66 (Zr), the prepared sensor not only exhibited a sensitive fluorescence response, specific identification capabilities and a high selectivity for oxytetracycline, but also showed good fluorescence stability, satisfactory precision and reproducibility. The fabricated sensor displayed a fluorescent linear quenching in the OTC concentration range of 0.05-40 μg mL^-1, with a detection limit of 0.012 μg mL^-1. More importantly, the fluorescence sensor was finally applied for the detection of oxytetracycline in milk, and the results were comparable to those obtained using the HPLC approach. Hence, the NH₂-UIO-66 (Zr)@MIP sensor possesses great application potential for the accurate evaluation of trace oxytetracycline in dairy products.

Molecularly imprinted ratiometric fluorescence detection of tetracycline based on its fluorescence enhancement effect caused by tungsten trioxide quantum dots

This paper reports a novel probe developed based on the tungsten trioxide quantum dots (WO_3-x QDs) and molecularly imprinted polymers for the detection of trace tetracycline (TC) in the complex food matrix. Tungsten ion (W⁶⁺) in WO_3-x QDs has a fluorescence enhancement effect on TC, and TC has a fluorescence quenching effect on WO_3-x QDs. The blue emission of the WO_3-x QDs (λ_em = 470 nm) as a reference and the yellow emission of the TC (λ_em = 550 nm) as a response were utilized for the ratiometric fluorescence detection. In order to improve its selectivity, the molecular imprinting technology was combined to construct molecularly imprinted ratiometric fluorescent probes (MIRFPs). Therefore, the MIRFPs can not only selectively detect TC, but also realize the visual detection from blue to yellow. Under the optimal conditions, the linear ranges of 0.01 ∼ 10.0 μmol/L and 20.0 ∼ 80.0 μmol/L were obtained with the limits of detection of 3.23 nmol/L and 6.37 μmol/L, respectively. Furthermore, the MIRFPs had been successfully applied to the detection of TC in milk and eggs. The satisfactory recoveries were in the range of 92.7 ∼ 102.9 % with relative standard deviations (RSD, n = 3) below 1.59 %. This work offers a good strategy for the detection of food hazards.

A self-powered photoelectrochemical oxytetracycline aptasensor: An integrated heterojunction photoanode of metal-organic framework derived ZnO nanopolyhedra/graphitic carbon nitride with high carrier density

The development of effective strategies for the detection of oxytetracycline (OTC) in soil is of great importance for preserving agri-environmental safety and human health. Herein, a novel photoactive material of metal-organic framework (MOF) derived ZnO nanopolyhedra/graphitic carbon nitride (ZnO/g-C3N4) heterojunction was designed by mixing calcination of zeolite imidazole framework-8 (ZIF-8) and melamine. A self-powered photoelectrochemical aptasensor for the sensitive and selective detection of OTC in soil was proposed using ZnO/g-C3N4 as the photoanode. The photoactivity of the MOF derived ZnO nanopolyhedra was regulated effectively by the introduction of g-C3N4, which resulted in a 7-fold increase in the photocurrent of the ZnO nanopolyhedra at a bias potential of 0 V. It was assigned to the higher carrier density of ZnO/g-C3N4. By virtue of the amplified photocurrent of ZnO/g-C3N4, the specificity of the OTC aptamer and the anti-interference ability of the self-powered sensing method, the designed aptasensor demonstrated the advantages of a wide linear range (0.005-200 nM), low limit of detection (1.49 × 10-3 nM), good selectivity and good reproducibility. For real soil sample analysis, satisfactory recoveries were obtained and further verified by ultra-performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS).

Tailoring Functional Micromotors for Sensing

Micromotors are identified as a promising candidate in the field of sensing benefiting from their capacity of autonomous movement. Here, a review on the development of tailoring micromotors for sensing is presented, covering from their propulsion mechanisms and sensing strategies to applications. First, we concisely summarize the propulsion mechanism of micromotors involving fuel-based propulsion and fuel-free propulsion introducing their principles. Then, emphasis is laid to the sensing stratagems of the micromotors including speed-based sensing strategy, fluorescence-based sensing strategy, and other strategies. We listed typical examples of different sensing stratagems. After that, we introduce the applications of micromotors in sensing fields including environmental science, food safety, and biomedical fields. Finally, we discuss the challenges and prospects of the micromotors tailored for sensing. We believe that this comprehensive review can help readers to catch the research frontiers in the field of sensing and thus to burst out new ideas.

Kill two birds with one stone: Selective and fast removal and sensitive determination of oxytetracycline using surface molecularly imprinted polymer based on ionic liquid and ATRP polymerization

Oxytetracycline (OTC) residue in food and environment has potential threats to ecosystem and human health, thus its sensitive monitoring and effective elimination are very important. In this work, a new molecularly imprinted polymer (MIP) composite was prepared through atom transfer radical polymerization by using OTC as template, gold nanoparticles modified carbon nanospheres (Au-CNS) as supporter, ionic liquids (IL) as functional monomer and cross-linking agent. The obtained MIP-IL@Au-CNS composite was characterized by Fourier transform infrared absorption spectroscopy, X-ray photoelectron spectroscopy, scanning electron microscopy and transmission electron microscopy. It displayed high imprinting factor (5.50) and adsorption capacity (56.7 mg g^-1), and could achieved the adsorption equilibrium in short time (about 15 min). Results also illustrated that the adsorption process basically conformed to the quasi-second-order kinetic model and Freundlich model, and MIP-IL@Au-CNS could be recycled at least 5 times. Furthermore, a sensitive OTC electrochemical sensor was developed by combining MIP-IL@Au-CNS with IL-modified carbon nanocomposites (IL@N-rGO-MWCNT). The resulting sensor demonstrated a linear response to OTC in the wide range of 0.02-20 μM, and the detection limit was down to 5 nM. It also had the advantages of high selectivity, fast elution/regeneration and simple construction procedure. The sensor had been applied to the detection of real samples, and acceptable recovery (96.4%-106%) and RSD (3.2%-6.2%) were obtained. This work expands the application of IL-based MIP in pollutant monitoring and enriching.

A molecularly imprinted antibiotic receptor on magnetic nanotubes for the detection and removal of environmental oxytetracycline

The detection and elimination of antibiotic contaminants, such as oxytetracycline (OTC), a broad-spectrum tetracycline antibiotic, would be of help in efficient environmental monitoring, agriculture and food safety tests. Nevertheless, currently available methodologies, which mostly rely on the chromatographic separation of OTC, suffer from low sensitivity and complicated processes. Thus, we report here on the design and synthesis of a fluorescent sensor based on molecularly imprinted magnetic halloysite nanotubes (referred to as MHNTs@FMIPs) for the effective detection and purification of OTC in actual environmental samples. The fluorescence of the MHNTs@FMIPs was quenched obviously upon loading with OTC, covering a linear concentration range of 10-300 nM with a limit of detection (LOD) as low as 8.1 nM. The imprinting factor is 4.47, indicating an excellent specificity. Furthermore, the MHNTs@FMIPs can be applied to the quantitative detection of OTC (5 cycles of 300 nM) in aquaculture wastewater and Yangtze River water, demonstrating their immense application potential.

Boosting the peroxidase-like activity of gold nanoclusters for the colorimetric detection of oxytetracycline in rat serum

Gold nanoclusters (AuNCs)-based nanozymes have been studied widely as they provide unrivaled advantages in terms of preferable enzyme-like activities, high stability, and good biocompatibility. Although the enzyme-like catalytic activity of AuNCs has been the object of extensive investigation, understanding how charges or reactive oxygen species on the surfaces of AuNCs can enhance their catalytic performance in the colorimetric sensing of drugs by regulating the catalytic activity of AuNCs is still a big challenge. Herein, l-tryptophanonitrile (LTN)-protected AuNCs (LTN@AuNCs) were prepared, and their nanozyme activity was investigated in the catalytic oxidation process of the peroxidase substrate, namely 3,3',5,5'-tetramethylbenzidine, in the prescence of hydrogen peroxide. Oxytetracycline induced the aggregation of LTN@AuNCs due to the electrostatic interaction between the positively charged LTN@AuNCs and the negatively charged drug. Importantly, the aggregated LTN@AuNCs produced more reactive oxygen species and significantly boosted their peroxidase-like activity. Subsequently, a colorimetric method for highly specific and sensitive detection of oxytetracycline was establised. The ultraviolet-visible absorbance at a wavelength of 650 nm of the aggregated-LTN@AuNCs exhibited a good linear relationship with oxytetracycline in a range of 0.5-15.0 μM (R2 = 0.994). The limit of detection was 0.3 μM. After oxytetracycline was abdominally injected in rats, the metabolic process of the drug in serums was further investigated by using the proposed sensing protocol. The improvable catalytic activity capability of the AuNCs-based nanozymes discloses its great potential in real bio-applications.