Modeling the effect of temperature on solid-phase microextraction of volatile organic compounds from air by polydimethylsiloxane coating using finite element analysis

Monitoring the liberation of volatile organic compounds during fused deposition modeling three dimensional printing using solid-phase microextraction coupled to gas chromatography/mass spectrometry

Three-dimensional (3D) printers have gained tremendous popularity and are being widely used in offices, laboratories, and private homes. Fused deposition modeling (FDM) is among the most commonly used mechanisms by desktop 3D printers in indoor settings and relies on the extrusion and deposition of heated thermoplastic filaments, resulting in the liberation of volatile organic compounds (VOCs). With the growing use of 3D printers, concerns regarding human health have risen as the exposure to VOCs may cause adverse health effects. Therefore, it is important to monitor VOC liberation during printing and to correlate it to filament composition. In this study, VOCs liberated with a desktop printer were measured by solid-phase microextraction (SPME) combined with gas chromatography/mass spectrometry (GC/MS). SPME fibers featuring sorbent coatings of varied polarity were chosen for the extraction of VOCs liberated from acrylonitrile butadiene styrene (ABS), tough polylactic acid, and copolyester+ (CPE+) filaments. It was found that for all three filaments tested, longer print times resulted in a greater number of extracted VOCs. The ABS filament liberated the most VOCs while the CPE+ filaments liberated the fewest VOCs. Through the use of hierarchical cluster analysis and principal component analysis, filaments as well as fibers could be differentiated based on the liberated VOCs. This study demonstrates that SPME is a promising tool to sample and extract VOCs liberated during 3D printing under non-equilibrium conditions and can be used to aid in tentative identification of the VOCs when coupled to gas chromatography-mass spectrometry.

Optimization of headspace solid-phase microextraction of volatile organic compounds from dry soil samples by porous coatings using COMSOL Multiphysics

Headspace solid-phase microextraction (HSSPME) is one of the simplest and cost-efficient sample preparation approaches for determination of volatile organic compounds (VOCs) in soil. This study was aimed at the development of the model for numerical optimization of HSSPME of volatile organic compounds from dry soil samples by porous coatings using COMSOL Multiphysics (CMP). ‘Transport of Diluted Species in Porous Medium’ physics was used for modeling. Effect of sample mass, pressure, fiber-headspace and soil-headspace distribution constants on extraction profiles and time of 95% equilibrium has been studied using the developed model. Equilibrium extraction under atmospheric pressure (1 atm) can take up to 97 min, while under vacuum (0.0313 atm) – 2.3 min. Equilibration time under vacuum was 42-43 times lower than under 1 atm at all studied distribution constants and sample masses. The developed model was modified for optimization of pre-incubation time using ‘Transport of Diluted Species’ physics. According to the obtained plots, 95% equilibration time can reach 13.3 min and depends on both sample mass and soil-headspace distribution constant of the analyte. The developed model can be recommended for optimization of pressure, preincubation and extraction time when fiber-headspace and soil-headspace distribution constants, soil porosity and density are known.