1
|
Tarkowski P, Siek E, Staśkiewicz G, Bielecki DK, Czekajska-Chehab E. Angle Dependence of Electrode Lead-Related Artifacts in Single- and Dual-Energy Cardiac ECG-Gated CT Scanning-A Phantom Study. J Clin Med 2024; 13:3746. [PMID: 38999312 PMCID: PMC11242805 DOI: 10.3390/jcm13133746] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 04/20/2024] [Revised: 06/19/2024] [Accepted: 06/21/2024] [Indexed: 07/14/2024] Open
Abstract
Background: The electrodes of implantable cardiac devices (ICDs) may cause significant problems in cardiac computed tomography (CT) because they are a source of artifacts that obscure surrounding structures and possible pathology. There are a few million patients currently with ICDs, and some of these patients will require cardiac imaging due to coronary artery disease or problems with ICDs. Modern CT scanners can reduce some of the metal artifacts because of MAR software, but in some vendors, it does not work with ECG gating. Introduced in 2008, dual-energy CT scanners can generate virtual monoenergetic images (VMIs), which are much less susceptible to metal artifacts than standard CT images. Objective: This study aimed to evaluate if dual-energy CT can reduce metal artifacts caused by ICD leads by using VMIs. The second objective was to determine how the angle between the electrode and the plane of imaging affects the severity of the artifacts in three planes of imaging. Methods: A 3D-printed model was constructed to obtain a 0-90-degree field at 5-degree intervals between the electrode and each of the planes: axial, coronal, and sagittal. This electrode was scanned in dual-energy and single-energy protocols. VMIs with an energy of 40-140 keV with 10 keV intervals were reconstructed. The length of the two most extended artifacts originating from the tip of the electrode and 2 cm above it-at the point where the thick metallic defibrillating portion of the electrode begins-was measured. Results: For the sagittal plane, these observations were similar for both points of the ICDs that were used as the reference location. VMIs with an energy over 80 keV produce images with fewer artifacts than similar images obtained in the single-energy scanning mode. Conclusions: Virtual monoenergetic imaging techniques may reduce streak artifacts arising from ICD electrodes and improve the quality of the image. Increasing the angle of the electrode as well as the imaging plane can reduce artifacts. The angle between the electrode and the beam of X-rays can be increased by tilting the gantry of the scanner or lifting the upper body of the patient.
Collapse
Affiliation(s)
- Piotr Tarkowski
- Department of Radiology, Medical University of Lublin, 20-090 Lublin, Poland
| | - Elżbieta Siek
- Department of Clinical and Radiological Anatomy, Medical University of Lublin, 20-090 Lublin, Poland
- Department of Radiology and Nuclear Medicine, University Hospital No 4, 20-090 Lublin, Poland
| | - Grzegorz Staśkiewicz
- Department of Clinical and Radiological Anatomy, Medical University of Lublin, 20-090 Lublin, Poland
- Department of Radiology and Nuclear Medicine, University Hospital No 4, 20-090 Lublin, Poland
| | - Dennis K Bielecki
- Department of Diagnostic Imaging, Kings College Hospital, London SE5 9RS, UK
| | | |
Collapse
|
2
|
Smolka S, Achenbach S. [Coronary computed tomography and cardiac devices : Diagnostic results or nothing but artifacts?]. Herzschrittmacherther Elektrophysiol 2022; 33:283-289. [PMID: 35788766 DOI: 10.1007/s00399-022-00876-6] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 06/05/2022] [Accepted: 06/13/2022] [Indexed: 06/15/2023]
Abstract
Coronary computed tomography (CT) angiography has become a major cornerstone in the diagnostic workup of cardiologic patients, particularly for evaluation of the coronary arteries and preprocedural planning of interventions for structural heart disease. Despite the possible problems that intensive electromagnetic radiation (including X‑rays) might cause when directly impacting on implanted cardiac devices, cardiac CT is a safe diagnostic test and should not be withheld from patients with devices if properly indicated. Sufficient image quality is paramount for the evaluation; hence, special attention should be paid to a low heart rate (< 60 bpm) and sufficient compliance with breathing instructions. Furthermore, pacemaker or implantable cardioverter-defibrillator (ICD) leads may cause metal artifacts, especially around the lead tip. Their dense material causes beam hardening and streak artifacts which may result in reduced image quality and limited diagnostic assessability. The prevalence of such artifacts depends not only on lead material but also on lead positioning relative to the gantry plane. Metal artifacts are more frequent in patients with unipolar leads and shock coils, which can impair the assessment of coronary arteries, mainly of the right coronary artery (RCA). Artifacts caused by left ventricular (LV) leads of cardiac resynchronization therapy (CRT) systems tend to affect assessment of the left circumflex artery (LCX). By using dual energy CT and postprocessing algorithms, the impact of artifacts can be reduced and diagnostic image quality can be achieved in most cases. Unfortunately, the actual occurrence of such artifacts or the degree of impairment of image quality cannot be reliably predicted.
Collapse
Affiliation(s)
- Silvia Smolka
- Medizinische Klinik 2, Universitätsklinikum Erlangen, Ulmenweg 18, 91054, Erlangen, Deutschland.
| | - Stephan Achenbach
- Medizinische Klinik 2, Universitätsklinikum Erlangen, Ulmenweg 18, 91054, Erlangen, Deutschland
| |
Collapse
|
3
|
Leadless Cardiac Pacemaker (LCP) without Diagnostic Relevant Artifacts in DualSource and DualEnergy-CT Examinations in First- to Third-Generation DSCT Scanner. Acad Radiol 2019; 26:1071-1076. [PMID: 30413293 DOI: 10.1016/j.acra.2018.10.003] [Citation(s) in RCA: 1] [Impact Index Per Article: 0.2] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Received: 08/02/2018] [Revised: 10/11/2018] [Accepted: 10/11/2018] [Indexed: 11/24/2022]
Abstract
RATIONALE AND OBJECTIVES To identify the influence and artifact burden in cardiac CT imaging of a leadless cardiac pacemaker (LCP) performed with all three generations of DualSource CT (DSCT) Scanners. MATERIALS AND METHODS The LCP was examined in DSCT scanners of the first to third generation using DualEnergy (DECT) and DSCT as well as alterations of the current-time product. For DECT examinations, virtual monoenergetic images were computed manually on a dedicated workstation. Virtual voltage was manually selected by subjective assessment of the lowest artifact burden. Systematic variations of the pacemaker angle to the gantry were assessed, too. The angle was successively increased by 10°, ranging from 0° to 90°. Artifact burden was quantified on a five-point Likert scale (1- no artifacts, 2- few artifacts, 3- moderate artifacts, 4- many artifacts, and 5- massive artifacts). Likert values of 1-3 were considered diagnostic and assessed by two board-certified radiologists in consensus. RESULTS In total, 200 examinations were analyzed, a mean Likert value of 1.93 ± 0.61 was found overall. None of the images were assessed Likert value >3. The positioning evaluation showed a clear and significant reduction of artifact burden toward lower angles, (0°: 1.4 ± 0.5 vs. 90° 2.55 ± 0.51). At scanner level, second-generation DSCT performed significantly better (1.68 ± 0.47) than both other scanners. Comparison of technique (DECT vs. DSCT) revealed a significantly improved image quality in DSCT examinations. CONCLUSION LCP can be safely examined in DSCT scanner of the first to third generation with the evaluated protocols and techniques, which are currently in use. Artifact burden can be significantly reduced by aligning or approaching the LCP's longitudinal axis toward the scanner's z-axis.
Collapse
|
4
|
Reinartz SD, Imhoff M, Tolba R, Fischer F, Fischer EG, Teschner E, Koch S, Gärber Y, Isfort P, Gremse F. EIT monitors valid and robust regional ventilation distribution in pathologic ventilation states in porcine study using differential DualEnergy-CT (ΔDECT). Sci Rep 2019; 9:9796. [PMID: 31278297 PMCID: PMC6611907 DOI: 10.1038/s41598-019-45251-7] [Citation(s) in RCA: 7] [Impact Index Per Article: 1.4] [Reference Citation Analysis] [Abstract] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 07/25/2018] [Accepted: 04/12/2019] [Indexed: 11/19/2022] Open
Abstract
It is crucial to precisely monitor ventilation and correctly diagnose ventilation-related pathological states for averting lung collapse and lung failure in Intensive Care Unit (ICU) patients. Although Electrical Impedance Tomography (EIT) may deliver this information continuously and non-invasively at bedside, to date there are no studies that systematically compare EIT and Dual Energy CT (DECT) during inspiration and expiration (ΔDECT) regarding varying physiological and ICU-typical pathological conditions such as atelectasis. This study aims to prove the accuracy of EIT through quantitative identification and monitoring of pathological ventilation conditions on a four-quadrant basis using ΔDECT. In a cohort of 13 pigs, this study investigated systematic changes in tidal volume (TV) and positive end-expiratory pressure (PEEP) under physiological ventilation conditions. Pathological ventilation conditions were established experimentally by single-lung ventilation and pulmonary saline lavage. Spirometric data were compared to voxel-based entire lung ΔDECT, and EIT intensities were compared to ΔDECT of a 12-cm slab of the lung around the EIT belt, the so called ΔDECTBelt. To validate ΔDECT data with spirometry, a Pearson’s correlation coefficient of 0.92 was found for 234 ventilation conditions. Comparing EIT intensity with ΔDECT(Belt), the correlation r = 0.84 was found. Normalized cross-correlation function (NCCF) between scaled global impedance (EIT) waveforms and global volume ventilator curves was r = 0.99 ± 0.003. The EIT technique correctly identified the ventilated lung in all cases of single-lung ventilation. In the four-quadrant based evaluation, which assesses the difference between end-expiratory lung volume (ΔEELV) and the corresponding parameter in EIT, i.e. the end-expiratory lung impedance (ΔEELI), the Pearson’s correlation coefficient of 0.94 was found. The respective Pearson’s correlation coefficients implies good to excellent concurrence between global and regional EIT ventilation data validated by ventilator spirometry and DECT imaging. By providing real-time images of the lung, EIT is a promising, EIT is a promising, clinically robust tool for bedside assessment of regional ventilation distribution and changes of end-expiratory lung volume.
Collapse
Affiliation(s)
- Sebastian D Reinartz
- Department of Diagnostic and Interventional Radiology, University Hospital, RWTH Aachen University, 52074, Aachen, Germany.
| | - Michael Imhoff
- Department for Medical Informatics, Biometry and Epidemiology, Ruhr University of Bochum, 44780, Bochum, Germany
| | - René Tolba
- Institute of Laboratory Animal Science, University Hospital, RWTH Aachen University, 52074, Aachen, Germany
| | - Felix Fischer
- Drägerwerk AG & Co. KGaA, Moislinger Allee 53-55, 23558, Lübeck, Germany
| | - Eike G Fischer
- Aix Scientifics CRO, Theaterstr. 7, 52062, Aachen, Germany
| | - Eckhard Teschner
- Drägerwerk AG & Co. KGaA, Moislinger Allee 53-55, 23558, Lübeck, Germany
| | - Sabine Koch
- Institute of Laboratory Animal Science, University Hospital, RWTH Aachen University, 52074, Aachen, Germany
| | - Yvo Gärber
- Drägerwerk AG & Co. KGaA, Moislinger Allee 53-55, 23558, Lübeck, Germany
| | - Peter Isfort
- Department of Diagnostic and Interventional Radiology, University Hospital, RWTH Aachen University, 52074, Aachen, Germany
| | - Felix Gremse
- Institute for Experimental Molecular Imaging, University Hospital, RWTH Aachen University, 52074, Aachen, Germany
| |
Collapse
|