The impact of particulate and soluble organic matter on physicochemical properties of extracellular polymeric substances in a microalga Neocystis mucosa SX

Impact of organic matter molecular weight on hexavalent chromium enrichment in green microalgae

In lightly polluted water containing heavy metals, organic matter, and green microalgae, the molecular weight of organic matter may influence both the growth of green microalgae and the concentration of heavy metals. This study elucidates the effects and mechanisms by which different molecular weight fractions of fulvic acid (FA), a model dissolved organic matter component, facilitate the bioaccumulation of hexavalent chromium (Cr(VI)) in a typical green alga, Chlorella vulgaris. Findings show that the addition of FA fractions with molecular weights greater than 10 kDa significantly enhances the enrichment of total chromium and Cr(VI) in algal cells, reaching 21.58%-31.09 % and 16.17 %-22.63 %, respectively. Conversely, the efficiency of chromium enrichment in algal cells was found to decrease with decreasing molecular weight of FA. FA molecular weight within the range of 0.22 µm-30 kDa facilitated chromium enrichment primarily through the algal organic matter (AOM) pathway, with minor contributions from the algal cell proliferation and extracellular polymeric substances (EPS) pathways. However, with decreasing FA molecular weight, the AOM and EPS pathways become less prominent, whereas the algal cell proliferation pathway becomes dominant. These findings provide new insights into the mechanism of chromium enrichment in green algae enhanced by medium molecular weight FA.

Cold plasma-assisted regeneration of biochar for dye adsorption

Environmental remedies, including adsorption-based water purification, are now being asked to meet the requirement for a low-carbon circular economy requiring low energy and low material consumption. In this regard, we tested the possibility of regenerating adsorbents via cold plasma (CP) treatment for less use of adsorbents and no washing solution. In the adsorption of methylene blue (MB) using carbonized rice husk (CRH) and five successive regeneration cycles by CP treatment, the removal efficiencies were maintained at a moderate level (∼70% of the initial performance), unlike five consecutive adsorption without CP treatment (∼9-13% of the initial performance). The regeneration of CRH by CP treatment was also double-checked by the FESEM, EDS, BET, FTIR, XPS, and surface zeta potential measurements. The successfully recovered adsorption capability is related to the remediation of adsorption sites. It is also worth noting that the required power consumption for recycling by CP treatment was about 6.4 times lower than carbonizing new rice husks. This work provides insights into recovering adsorbents using CP without rigorous, costly, and energy-intensive processes.

Zero Discharge of Dyes and Regeneration of a Washing Solution in Membrane-Based Dye Removal by Cold Plasma Treatment

Although dye removal from wastewater streams has been investigated via several approaches using adsorbents, resins, or membranes, it is still hard to avoid the fact that dyes are persistently left in the adsorption materials or washing solutions used to regenerate the used adsorbents. In particular, given that cleaning agents are composed of acid/base, organic solvents, or electrolytes, dye adsorption and adsorbent regeneration processes leave behind more hard-to-manage wastewater containing dyes. In this study, we demonstrated that cold plasma (CP) treatment, which is one of the advanced oxidation processes (AOPs), can be used for zero discharge of dyes and regeneration of a washing solution in a membrane-based dye removal process. Specifically, CP treatment was found to successfully remove dyes released from a washing process to regenerate a used membrane, thereby effectively recycling a cleaning solution. As a result, the regenerated washing solution was more favorable for the adsorbed dyes’ elution, leading to the successful regeneration of a used membrane without a significant loss of dye removal efficiency. This fact was evidenced by a comparative study on the effect of CP treatment on the reusability of membranes and washing solutions and the kinetic analysis of the AOP of the desorbed dyes. We hope that this study contributes to opening a new door for environmentally friendly and sustainable dye removal.

Effects of Suspended Particles on Exopolysaccharide Secretion of Two Microalgae in Jinjiang Estuary (Fujian, China)

The effects of suspended particles (SP) of different concentrations and sizes on the secretion of exopolysaccharide (EPS) by Chlorella pyrenoidosa (C. pyrenoidosa) and Microcystis flos-aquae (M. flos-aquae) in Jinjiang Estuary, Fujian Province, China were studied in co-cultures of microalgae and SP. The results show that the SP concentration has an “inhibit–promote–inhibit” effect on the secretion of EPS by C. pyrenoidosa, whereby there is an optimal concentration of SP corresponding to the largest amount of EPS secreted by C. pyrenoidosa. Low concentrations had no significant effect on the secretion of EPS from M. flos-aquae (p > 0.05), whereas higher concentrations had an inhibitory effect. The C. pyrenoidosa EPS content was found to be significantly decreased in response to SP of small particle sizes (0–75 and 75–120 μm) and significantly increased for SP of large particle sizes (120–150 and 150–500 μm). Small particle sizes (0–75 and 75–120 μm) were found to be beneficial to the secretion of EPS from M. flos-aquae, and the promotion of EPS secretion gradually decreased with the increase in SP particle size. However, when the particle size was too large (120–150 and 150–500 μm), SP had no significant effect on EPS secretion. This study is helpful for understanding the microalgae EPS secretion response to SP and provides a scientific basis for studying the mechanism of EPS secretion by algae and the effect of SP on eutrophication of the estuary.

A comprehensive review on carbon source effect of microalgae lipid accumulation for biofuel production

Energy is a major driving force for the economic development. Due to the scarcity of fossil fuels and negative impact on the environment, it is important to develop renewable and sustainable energy sources for humankind. Microalgae as the primary feedstock for biodiesel has shown great application potential. However, lipid yield from microalgae is limited by the upstream cost, which restrain the realization of large-scale biofuel production. The modification of lipid-rich microalgae cell has become the focus over the last few decades to improve the lipid content and productivity of microalgae. Carbon is a vital nutrient that regulates the growth and metabolism of microalgae. Different carbon sources are assimilated by microalgae cells via different pathways. Inorganic carbon sources are mainly used through the CO₂-concentrating mechanisms (CCMs), while organic carbon sources are absorbed by microalgae mainly through the Pentose Phosphate (PPP) Pathway and the Embden-Meyerhof-Pranas (EMP) pathway. Therefore, the addition of carbon source has a significant impact on the production of microalgae biomass and lipid accumulation. In this paper, mechanisms of lipid synthesis and carbon uptake of microalgae were introduced, and the effects of different carbon conditions (types, concentrations, and addition methods) on lipid accumulation in microalgal biomass production and biodiesel production were comprehensively discussed. This review also highlights the recent advances in microalgae lipid cultivation with large-scale commercialization and the development prospects of biodiesel production. Current challenges and constructive suggestions are proposed on cost-benefit concerns in large-scale production of microalgae biodiesel.