Influence of inelastic collision on the dynamic behavior of particle sedimentation in high-viscosity fluids

Effects of bubbles on particle dynamic behavior and concentration distribution in High-viscosity liquid under negative pressure

The vacuum method is a widely adopted technique for eliminating bubbles from polymers containing particles. To investigate the influence of bubbles on the behavior of particles and the concentration distribution in high-viscosity liquids under negative pressure, experimental and numerical methods have been employed. The experimental findings demonstrated a positive correlation between the diameter and rising velocity of bubbles and the negative pressure. As the negative pressure increased from - 10 kPa to - 50 kPa, the position of the region where the particles were concentrated in the vertical direction was elevated. Furthermore, when the negative pressure exceeded - 50 kPa, the particle distribution became sparse and layered locally. The Lattice Boltzmann method (LBM) integrated with the discrete phase model (DPM) was utilized to investigate the phenomenon, and the outcomes revealed that rising bubbles have an inhibitory effect on particle sedimentation, and the extent of inhibition was determined by the negative pressure. In addition, vortexes generated by differences in the rising velocity between bubbles resulted in a particle distribution that was sparse and layered locally. This research provides a reference for achieving desired particle distributions using a vacuum defoaming approach and should be further studied to extend its applicability to suspensions containing particles with different viscosities.

Fabrication of Highly Compacted Green Body Using Multi-Sized Al Powder under a Centrifugal Force

This study investigates the application of centrifugal force for the compaction of metal powder. Previous studies using the centrifugal force for manufacturing the green bodies were focused on fine powders with narrow particle size distribution or binary mixtures. This study explores the particle packing of multi-sized powder. Aluminum alloy powder with a particle size less than 100 µm and polymer binder were admixed and compacted in the centrifugal casting with ranging magnitudes of centripetal acceleration. Three different centrifugal forces were tested: 700, 1800, and 3700 G. The microstructure of the green bodies was then observed on the SEM micrographs. The obtained green bodies had high packing densities ranging from 62 to 69%. The packing density and median particle size increase at the positions further away from the center of rotation of the centrifuge with an increase of centrifugal force. The effect of centrifugal force on the segregation of particles was investigated through the quasi-binary segregation index. The segregation phenomena was not observed at 700 G, but clear particle segregation was found at higher centrifugal forces. The increase of the centrifugal force resulted in higher segregation with finer particles moving to the inner part of the spinning mold, with a significant change in the size of particles located closer to the center of rotation. Overall, the centrifugal process was found to produce highly compacted green bodies while yielding a segregation effect due to wide particle size distribution.