The variability of the volume of os coxae and linear pelvic morphometry. Considerations for total hip arthroplasty

A study on the morphology of iliac crest based on the objectives of jaw bone defect reconstruction

OBJECTIVES

to understand the morphological characteristics of iliac crest and provide advice and assistance for jaw bone reconstruction with iliac bone flap by evaluating the thickness and curvature of iliac crest.

MATERIALS AND METHODS

100 patients who had taken Spiral CT of the Abdominal region before surgeries between 2020 and 2022 were included in this study. 3D reconstruction images of the iliac bones were created. 5 vertical planes perpendicular to the iliac crest were made every 2 cm along the centerline of the iliac crest (VP2 ~ VP10). On these vertical planes, 4 perpendicular lines were made every 1 cm along the long axis of the iliac crest (D1 ~ D4). The thicknesses at these sites, horizontal angle (HA) of iliac crest and the distance between inflection point and the central point of anterior superior iliac spine (DIA) were measured.

RESULTS

The thickness of iliac bone decreased significantly from D1 ~ D4 on VP6 ~ VP10 and from VP2 ~ VP10 on D3 and D4 level (P<0.05). HA of iliac crests was 149.13 ± 6.92°, and DIA was 7.36 ± 1.01 cm. Iliac bone thickness, HA and DIA had very weak or weak correlation with patient's age, height and weight.

CONCLUSIONS

The average thicknesses of iliac crest were decreased approximately from front to back, from top to bottom. The thickness and curvature of the iliac crest were difficult to predict by age, height and weight.

CLINICAL RELEVANCE

Virtual surgical planning is recommended before jaw bone reconstruction surgery with iliac bone flap, and iliac crest process towards alveolar process might be a better choice.

Acetabulum Rekonstrüksiyonunda Erişkin İnsan Kuru Os coxae’sına ait Morfometrik Ölçümlerin Önemi

Objective: The aim of this study was to obtain morphometric measurements of adult human hip bones, examine the relationship among these measurement parameters, and develop regression equations to estimate the acetabular dimensions for acetabular reconstruction Material and Method: Seventy-eight (39 right and 39 left) dry hip bones of unknown age and gender located in the laboratory of Çukurova University Faculty of Medicine, Department of Anatomy, were included in the study. Eleven hip bones with fractures, deterioration, deformities, and defects that would affect the measurements were excluded from the study. In our study, 14 morphometric measurements of hip bones were obtained. IBM SPSS program was used for statistical analysis. Results: Single and multiple regression equations were developed from the hip bone morphometric measurements for the estimation of the morphometric measurements of the acetabulum. The standard error of estimate (SEE) values ranged from ±1.818 mm to ±3.546 mm in single regression equations, and between ±1.633 mm and ±2.107 mm in multiple regression equations. A lower SEE value was obtained in multiple regression equations than in single regression equations. Conclusion: The regression equations developed in this study will allow us to obtain personalized measurements, which will aid clinicians in the correct and safe placement of the implant in hip replacement surgeries as well as in the prevention of complications with the use of appropriate prostheses.

Does cup-cage reconstruction with oversized cups provide initial stability in THA for osteoporotic acetabular fractures?

BACKGROUND

The incidence of acetabular fractures in osteoporotic patients is increasing. Immediate total hip arthroplasty (THA) has potential advantages, but achieving acetabular component stability is challenging and, at early followup, reported revision rates for loosening are high.

QUESTIONS/PURPOSES

This study measured acetabular component stability and the initial surface contact achieved between the acetabular component and unfractured region of the pelvis after THA using an oversized acetabular component and cup-cage reconstruction.

METHODS

Between November 2011 and November 2013, we treated 40 acute acetabular fractures in patients older than 70 years of age. Of these, 12 (30%) underwent immediate THA using an oversized acetabular component with screws inserted only into the ilium and a cup-cage construct. Postoperatively all patients were mobilized without weightbearing restrictions. Indications for immediate THA after acetabular fractures were displaced articular comminution deemed unreducible. Eleven of the 12 were prospectively studied to evaluate the initial stability of the reconstructions using radiostereometric analysis. One of the patients died of a pulmonary embolism after surgery, and the remaining 10 (median age, 81 years; range, 72-86 years) were studied. Of these, five were analyzed at 1 year and five were analyzed at 2 years. Acetabular component migration was defined as acceptable if less than the limits for primary THA that predict later loosening (1.76 mm of proximal migration and 2.53° of sagittal rotation). The contact surface between the acetabular component and ilium in direct continuity with the sacroiliac joint, and the ischium and pubis in direct continuity with the symphysis pubis, was measured on postoperative CT scans.

RESULTS

At 1 year the median proximal migration was 0.83 mm (range, 0.09-5.13 mm) and sagittal rotation was 1.3° (range, 0.1°-7.4°). Three of the 10 components had migration above the suggested limits for primary THA at 1 year postoperatively. The contact surface achieved at surgery between the acetabular component and pelvis ranged from 11 to 17 cm(2) (15%-27% of each component).

CONCLUSIONS

The majority of acetabular components in this cohort were stable despite the small contact surface achieved between the component and pelvic bone. Three of 10 migrated in excess of the limits that predict later loosening in primary THA but it remains to be seen whether these limits apply to this selected group of frail osteoporotic patients. We continue to use this technique routinely to treat patients with the same indications, but since the analysis of these data we have added screw fixation of the acetabular component to the ischial tuberosity and the superior pubic ramus.

LEVEL OF EVIDENCE

Level IV, therapeutic study.

Impaction bone grafting has potential as an adjunct to the surgical stabilisation of osteoporotic tibial plateau fractures: Early results of a case series

INTRODUCTION

Osteoporotic tibial plateau fractures (TPFs) are difficult to treat with either open reduction internal fixation (ORIF) or acute total knee arthroplasty (TKA). They have high complication rates, poor outcomes and often fail in the short- to mid-term. We investigated the use of impaction bone grafting (IBG) as an adjunct to stabilise the fracture in a cohort of osteoporotic TPFs.

METHODS

Nine consecutive osteoporotic TPFs were surgically stabilised with ORIF augmented with IBG or with IBG alone (one pure depression fracture) using on average allograft from 2 femoral heads/case (range 1-4 heads or 25-100 cm(3)). The median bone mineral density T-score of the patients was -2.9 (-2.5 to -4.5). All patients were mobilised weight-bearing as tolerated immediately after surgery and had regular follow-up to a minimum of 2 years where functional scores were taken and gait was assessed. Fracture reduction was assessed on plain radiographs and computed tomography (CT) scans; maintenance of fracture reduction was monitored using plain radiographs, CT and radiostereometric analysis (RSA). Bone graft remodelling was assessed by comparison of immediate post-operative CT scans with scans at a minimum of 1 year.

RESULTS

All surgeries were uneventful. All patients progressed to full weight bearing within 6 weeks of surgery and regained a normal gait by 3 months. Seven fractures healed with a cranio-caudal migration of less than 3mm (range 0-2.6mm using RSA and 0-2mm using CT). Two fractures had an isolated posterolateral fragment depression of 13.5mm and 9 mm, respectively, which did not affect the overall joint alignment or clinical outcomes at short-term follow-up. At latest CT follow-up, on average 51% of the graft area (range 36-70%) had remodelled into new host bone.

CONCLUSION

Impaction bone grafting shows promising results as an adjunct to the surgical stabilisation of osteoporotic TPFs. In this case series the technique provided enough fracture stability for patients to mobilise weight-bearing as tolerated immediately after surgery and achieve full weight-bearing by the sixth postoperative week. There was no failure of fixation and 7 of the 9 cases healed with minimal fracture displacement.